Tripp Lite PDU3VS6H50 Manual

Tripp Lite stikdase PDU3VS6H50

Læs gratis den danske manual til Tripp Lite PDU3VS6H50 (68 sider) i kategorien stikdase. Denne vejledning er vurderet som hjælpsom af 56 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 28.5 anmeldelser. Har du et spørgsmål om Tripp Lite PDU3VS6H50, eller vil du spørge andre brugere om produktet?

Side 1/68
1
Owner’s Manual
3-Phase Switched 0U
Power Distribution Units
(Phase and Bank Measurements)
208V MODELS
PDU3VS6L2120 PDU3VS6L2130 PDU3VS6H50
(Series Number: AG-00BC) (Series Number: AG-00BA) (Series Number: AG-00BA)
400V MODELS
PDU3XVS6G20
(Series Number: AG-00BD)
Important Safety Instructions 2
Installation 3
Digital Display 6
Using the Digital Display 8
Features 14
Configuration and Operation 16
Service 16
Warranty and Warranty 17
Registration
Español 18
Français 35
Русский 52
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
Copyright © 2014 Tripp Lite. All rights reserved.
14-01-022-9332D2.indb 1 5/12/2014 4:19:29 PM
2
Important Safety Instructions
SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be followed during
the installation, operation, and storage of this product. Failure to heed these
instructions and warnings may affect the product warranty.
The PDU provides convenient multiple outlets, but it DOES NOT provide surge or line noise
protection for connected equipment.
The PDU is designed for indoor use only in a controlled environment away from excess
moisture, temperature extremes, conductive contaminants, dust or direct sunlight.
Do not connect the PDU to an ungrounded outlet or to extension cords or adapters that
eliminate the connection to ground.
The power requirement for each piece of equipment connected to the PDU must not exceed
the individual outlet’s load rating.
The total power requirement for equipment connected to the PDU must not exceed the
maximum load rating for the PDU.
Do not drill into or attempt to open any part of the PDU housing. There are no user-serviceable
parts inside.
Do not attempt to modify the PDU, including the input plugs and power cables.
Do not attempt to use the PDU if any part of it becomes damaged.
Do not attempt to mount the PDU to an insecure or unstable surface.
Use of this equipment in life support applications where failure of this equipment can
reasonably be expected to cause the failure of the life support equipment or to signicantly
affect its safety or effectiveness is not recommended. Do not use this equipment in the
presence of a ammable anesthetic mixture with air, oxygen or nitrous oxide.
Never attempt to install electrical equipment during a thunderstorm.
Keep indoor ambient temperature between 32°F and 122°F (0°C and 50°C).
Connect the PDU to an outlet that is in accordance with your local building codes and that is
adequately protected against excess currents, short circuits and earth faults.
The PDU must be installed by a qualied technician only.
Install in accordance with your local electrical codes. Be sure to use the proper over current
protection for the installation, in accordance with the plug rating/equipment rating.
The electrical sockets supplying power to the equipment shall be installed near the equipment
and be easily accessible.
Be sure to provide a local disconnect device on any models that are permanently installed
without a plug that is easily accessible.
14-01-022-9332D2.indb 2 5/12/2014 4:19:29 PM


Produkt Specifikationer

Mærke: Tripp Lite
Kategori: stikdase
Model: PDU3VS6H50

Har du brug for hjælp?

Hvis du har brug for hjælp til Tripp Lite PDU3VS6H50 stil et spørgsmål nedenfor, og andre brugere vil svare dig