Uniden UPP 136 Manual


Læs gratis den danske manual til Uniden UPP 136 (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 27 personer og har en gennemsnitlig bedømmelse på 4.1 stjerner ud af 14 anmeldelser. Har du et spørgsmål om Uniden UPP 136, eller vil du spørge andre brugere om produktet?

Side 1/4
- 1 -
Portable Power Bank &
Jump Start Kit
UPP136
USB Output 2
(Charge mobile devices)
DC Output
(12V/16V/19V devices)
POWER Switch
(ON/OFF)
Power Button
(Flashlight & Power Modes)
DC INPUT
(Charge the UPP136)
Flashlight
LED Display
12V Connector
(Jump start)
USB Output 1
(Charge mobile devices)
13600mAh Capacity
Universal 12V clamps
Supports Engines
< 5.0L Petrol
< 3.0L Diesel
USB Port 5V/2.1A Port
LED Flashlight
Laptop Connector
AC/DC Chargers
Resting Discharge
– 20% Loss/Year
Carrying Case
FEATURES
WHAT’S INCLUDED
UPP136 portable power unit
8 pcs laptop charging connector with charger leads
2–1 USB connector (Micro, Mini)
Smart Jumper Cable adaptor
12-15V DC cigarette lighter adaptor (vehicle adaptor)
15V/1.0A AC Adaptor
SLIDE ON THE POWER SWITCH BEFORE YOU DO THE
FOLLOWING:
Charge the unit
- Charge the USB device
- Charge DC12V/16V/19V device
- Use the Flashlight
- Use the Air Pump (Not Included)
USING THE UPP136 POWER BANK
CHARGING THE UNIT
1. Use the 240V AC Adaptor to connect the unit to an AC home outlet
or the cigarette lighter adaptor to connect the unit to the vehicle’s
cigarette lighter socket.
2. Slide ON the POWER switch to monitor charging progress on the
screen. The display shows 100% with when charging is complete.
3. Disconnect the UPP136 from the AC adaptor.
To preserve battery life, fully charge the Power Bank every three
months.
CHECK BATTERY CAPACITY
1. Slide ON the POWER switch.
2. Press POWER button without any devices connected to the char-
ger.
3. The number of bars in the battery icon indicate the power in the
battery.
JUMP START A VEHICLE
1. Slide ON the POWER switch and make sure the Power Bank is
fully charged.
2. Turn off all accessories on the vehicle (radio, air conditioner, etc)
3. Connect the jumper cable’s RED clamp to the POSITIVE post of
the vehicle battery.
4. Connect the jumper cable’s BLACK clamp to the NEGATIVE post
of the vehicle battery.
5. Insert the jumper cable connector into the Power Bank’s 12V
connector (under ap). Be sure the connection is solid.
6. Turn the vehicle ignition key for 3 seconds only. If the vehicle
starts:
Disconnect the jumper cables from the power pack rst, then
disconnect the clamps from the battery.
Leave the ignition on for a few minutes, then turn off the
vehicle.
Start the car.
7. If the car does NOT start on the rst try, wait for a minute and try
again.
CHARGING A 5V USB DEVICE (TABLET, CELL PHONE, ETC.)
1. Slide ON the POWER switch. Connect 2-1 USB connector to the
UPP136.
2. Connect your device to either the miniUSB or microUSB cable.
3. The UPP136 begins to charge your device.
TURN ON FLASHLIGHT
1. Slide ON the POWER switch. Press and hold POWER button to
turn on the LED ashlight in steady mode.
2. Press POWER button again to cycle through the 4 modes: Steady,
- 2 - - 3 -


Produkt Specifikationer

Mærke: Uniden
Kategori: Ikke kategoriseret
Model: UPP 136

Har du brug for hjælp?

Hvis du har brug for hjælp til Uniden UPP 136 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Uniden Manualer

Uniden

Uniden R7 Manual

4 Januar 2025
Uniden

Uniden DFR7 Manual

22 November 2024
Uniden

Uniden BCD325P2 Manual

1 Oktober 2024
Uniden

Uniden PRO5050 Manual

27 September 2024
Uniden

Uniden WLI2-USB2-G54 Manual

20 September 2024
Uniden

Uniden WPP 15W + D800 Manual

16 September 2024
Uniden

Uniden BCD260DN Manual

1 September 2024
Uniden

Uniden BCD160DN Manual

1 September 2024
Uniden

Uniden UM355VHF Manual

30 August 2024
Uniden

Uniden UH825-2TP Manual

27 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer