Valcom VIP-854 Manual

Valcom Telefon VIP-854

Læs gratis den danske manual til Valcom VIP-854 (3 sider) i kategorien Telefon. Denne vejledning er vurderet som hjælpsom af 8 personer og har en gennemsnitlig bedømmelse på 4.1 stjerner ud af 4.5 anmeldelser. Har du et spørgsmål om Valcom VIP-854, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/3
1 947644
CAUTION: To reduce the risk of electric shock,
Do not remove cover.
No user serviceable parts inside.
Refer servicing to qualified service personnel.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This sym bol indicates that dangerous
voltage constituting a risk of electric
shock is present within this unit.
This symbol indicates that there are
important operating and maintenance
instructions in the literature accompanying
this unit.
ISSUE 2
VIP-854
NETWORK TIE LINE MODULE
INTRODUCTION
The VIP-854 Network Tie Line Module allows two
end-points to be connected via an Ethernet
connection, bridging multiple trunk & station lines.
SPECIFICATIONS
Access Methods
2 PBX, FXO (Trunk) Ports
2 PBX, FXS (Station) Ports
Features
RJ-45 for network connection
2 RJ-11 FXO (Trunk) Ports
2 RJ-11 FXS (Station) Ports
2 Failover Phone Ports
2 Relays with Form C contacts
Front Panel Status & Network LEDs
2.5mm Barrel Power Connector
Power over Ethernet (802.3af) compliant
Dimensions/Weight
1.38" H x 6.13" W x 5.25" D
(3.50cm H x 15.6cm W x 13.33cm D)
Weight: 1.25 lbs. (0.57 kg)
Nominal Specifications
Input Impedance: 600 Ohms
Input Level: -10dBm
Output Impedance: 600 Ohms
Output Level: - 10dBm nominal
Relay Current: 1 AMP @ 24VDC
Nominal Power Requirements
Via rear panel barrel connector:
Voltage: 24VDC
Current: 325mA
Via Power over Ethernet (802.3af) Switch:
802.3af: Class 3
Environment
Temperature: 0 to +40° C
Humidity: 0 to 85% non-precipitating
Packing List
Qty Item
1 VIP-854
1 VSP Document
2 Mounting Brackets w/ Hardware
4 Rubber Pads
INSTALLATION
NOTE: The telephone system referred to in
this manual is the customer premise
equipment such as an electronic key system,
a PBX or a dedicated single line telephone
sets. The VIP-854 is not intended for direct or
indirect connection to the public telephone
network. When used with a customer premise
telephone system such as a key system or
PBX system, these units are interfaced to the
FXS or single line station port, which is a fully
protected interface device. Also, the host
system must be configured to disallow central
office trunk conferencing in order to prevent
indirect connection to the public network.
Precautionary Designations
2 947644
FCC Information
This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference when the equipment is operated
in a commercial environment. This
equipment generates, uses and can radiate
radio frequency energy and if not installed
and used in accordance with the instruction
manual, may cause harmful interference to
radio communications. Operation of this
equipment in a residential area may cause
harmful interference in which case the user
will be required to correct the interference at
his own expense.
Mounting
The VIP-854 is designed for wall or table
mounting.
Wall: Using the mounting brackets and hardware
provided, secure the VIP-854 to the wall.
Table: Provided with the VIP-854 are four rubber
stick on pads. Peel these pads off their carrier
backing and place at the four corners of the
bottom of the unit.
Power Connections
The preferred method of powering a VIP-854 is
via a Power over Ethernet (PoE) switch, meeting
the 802.3af specification.
If the rear panel barrel connector is used for
power, the preferred power supply is a Valcom
VIP-324D.
Make all signal connections prior to powering the
VIP-854, either via Power over Ethernet (802.3af)
or the Barrel Connector on the back of the
VIP-854.
Network Connection
The VIP-854 has one RJ-45 network connector
on the front panel.
Use a standard Ethernet patch cable to connect
the VIP-854 to an Ethernet switch. If using a
Power over Ethernet 802.3af compliant switch,
this front panel RJ-45 Ethernet connector will
supply power as well as network connectivity to
the VIP-854 unit.
Signal Connections
On the rear panel, the VIP-854 has 2 RJ-11 jacks
for connection to FXS circuits, 2 RJ-11 jacks for
FXO circuits, 2 RJ-11 jacks for failover telephone
connections and 1 terminal block for relay
connections.
Phone1, Phone2: Connect standard analog
Trunk lines to the VIP-854 via the rear panel RJ-
11 jacks labeled Phone1 or Phone2 (including
standard analog telephones). Tip and Ring
appears on pins 3 and 4 of these jacks.
Line1, Line2: Connect standard analog Station
circuits to the VIP-854 via the rear panel RJ-11
jacks labeled Line1 or Line 2 (including C.O. or
Centrex phone lines). Tip and Ring appear on
pins 3 and 4 of these jacks.
FP1, FP2: Connect a standard analog telephone
to the VIP-854 via the rear panel RJ-11 jack
labeled FP1 or FP2. Tip and Ring appear on pins
3 and 4 of these jacks.
In the event of power failure, the telephone in
FP1 will be able to access Line1 and FP2 will be
able to access Line2.
Relay Connections: Access to the 2 form C
relays is provided via a six pin screw terminal
block. The relays are labeled K1 and K2. Each
relay is brought out on three terminals. The
common contact is the middle terminal with the
normally closed contact on the left and the
normally open contact on the right. Relay
contacts are rated for 1A @ 24VDC.
Status Indicator Lights
The VIP-854 has 3 status indication lights on the
front panel.
STATUS: Flashes then illuminates to indicate
power.
LINK: Indicates 100 Mbit Ethernet connection
when illuminated. No activity indicates 10 Mbit
connection.
ACT: Indicator flashes to indicate network
activity.
Front View
Rear View

Produkt Specifikationer

Mærke: Valcom
Kategori: Telefon
Model: VIP-854

Har du brug for hjælp?

Hvis du har brug for hjælp til Valcom VIP-854 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Telefon Valcom Manualer

Valcom

Valcom VIP-430 Manual

6 September 2024
Valcom

Valcom VIP-431 Manual

6 September 2024
Valcom

Valcom V-5330210 Manual

6 September 2024
Valcom

Valcom V-5330110 Manual

6 September 2024
Valcom

Valcom VIP-854 Manual

6 September 2024
Valcom

Valcom VIP-848 Manual

6 September 2024
Valcom

Valcom V-9970 Manual

6 September 2024

Telefon Manualer

Nyeste Telefon Manualer

Yealink

Yealink SIP-T31W Manual

30 Juli 2025
Nokia

Nokia 105 Classic Manual

30 Juli 2025
HMD

HMD 105 Pure Manual

30 Juli 2025
HMD

HMD 101 4G Manual

30 Juli 2025
Thomson

Thomson 512263 Manual

27 Juli 2025
Panasonic

Panasonic KX-TGDA63 Manual

26 Juli 2025
Panasonic

Panasonic KX-TGDA99 Manual

26 Juli 2025
Panasonic

Panasonic KX-TGE610 Manual

26 Juli 2025
Panasonic

Panasonic KX-TGDA83 Manual

26 Juli 2025
Panasonic

Panasonic KX-TGDA66 Manual

26 Juli 2025