Walrus Audio R1 Manual


Læs gratis den danske manual til Walrus Audio R1 (10 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 27 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 14 anmeldelser. Har du et spørgsmål om Walrus Audio R1, eller vil du spørge andre brugere om produktet?

Side 1/10
DECAY - The Decay knob sets the length of the reverb decay. Set this
control lower for short natural sounding decays or higher for longer more
ethereal-sounding reverbs.
PRE DELAY - Adjust the amount of pre-delay applied to your guitar
signal before it enters the reverb. Pre-delay is useful for shaping how
the reverb responds to your playing. At low (short) pre-delay settings,
the reverb is heard almost immediately after you play a note. As you
increase the pre-delay, the reverb is delayed a small amount to provide
some separation between the notes you are playing and the reverb
signal.
MIX - The Mix knob sets the ratio of dry to wet signal. At minimum, no
reverb is heard. At maximum, no dry signal is heard. Equal parts dry
and reverb can be found around the 3 o’clock position.
LEFT ENCODER - The Left encoder offers creative control over various ways to fine-tune each reverb program
allowing you to creatively shape things like modulation, diffusion, ducking, and more. Cycle through each
option by pressing down on the encoder until you reach the desired control, then turn the encoder knob to
adjust. Alternatively, press and hold down the encoder and then turn to scroll through options then release
to select. Note that not every option listed below will apply to every program.
RATE: Adjust the speed of the modulation applied within the reverb.
DEPTH: Adjust the amount of the modulation applied within the reverb.
D/S (DUCK/SWELL): Rotate the Left encoder counterclockwise to apply a ducking effect to the reverb
trails. The reverb signal will temporarily “duck” down to allow for just your dry signal to pass through. As
you stop playing new notes and the ducking releases, your reverb will gently mix back in with your dry
signal.
Rotate the Left encoder clockwise to apply a volume envelope applied to your wet signal as it passes
through the R1 creating a gentle volume swell. This helps create unique moments of cinematic ambiance.
The higher the swell number determines how long it takes to fade in the guitar and reverb signal after
you play. To turn this swell effect off, return the D/S number to 0.
DIFFUSE: Controls the amount of diffusion applied to the reverb, at minimum less diffusion is applied,
at maximum, more diffusion is applied for softer reverb trails.
OCTTYP: (Octave Type): This applies to the Air Program only. Use this function to choose if the shimmer
effect happens pre or post the reverb tank.
CONTROLS
ADJUSTING PARAMETERS
When adjusting any knob parameter, you will
see a bar appear on the screen. The higher
you turn up a parameter, the fuller the bar
will appear. The top left number is your stored
preset value. The top right number shows the
value of where the knob is currently set. The dot
below the bar shows you the last value used
before turning the knob. LAST VALUE USED
CURRENT VALUE
WHERE KNOB IS SET
PRESET
VALUE
NAME OF PARAMETER
BEING ADJUSTED
DECAY


Produkt Specifikationer

Mærke: Walrus Audio
Kategori: Ikke kategoriseret
Model: R1

Har du brug for hjælp?

Hvis du har brug for hjælp til Walrus Audio R1 stil et spørgsmål nedenfor, og andre brugere vil svare dig