With each wash cycle.
Compartment
For pro gramm es with pre-wash only.
(Follow the user instructions !)
Electric indicator on control panel (if provided).
Check the rinse aid level
(On models w ith water softener system only.)
Electric indicator on control panel (if prov ided).
If there is no sa lt warning light in the control panel
(for some models), you can estimate when to f ill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regene ration
salt le vel
Load the baskets
Select a p rogramme
Close the door, t urn on the water ta p and press the St art/reset button. The mac hine will start working
after about 10 seconds.
Running the dishwasher
Swi tch off the applia nce
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 min utes) before unloading the dishwa sher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
The y will a lso dry better.Unload the appli ance , starting from the lower b asket.
Changing the programme
Add forgotten dishes in the
dishwasher.
Scrape off any large am ount of leftover food. Soften remnan ts of burnt food in pa ns,
then l oad the baskets. Refer to the dishwashe r loadin g instruct ions.
Press the Programme butto n until the selected progra m me li ghts up .
( See th e section entitled Ope rationg instruction )“ ”
When the working cy cle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the ON/OFF button.
If the appliance is switched
off during a wash cycle.
Op en t he d o o r careful l y.
Hot st eam may escape
when the door is opened!
If the appliance is swi tched off during a wash cycle, when switched
on agai n, plea se re-select th e washing cyc le and operate the dishwasher
acco rding to the original Power-on state ).
Switch on the appliance Press the On/Off button to switch on the applian c e, Open the door.
1.Open the door a little to sto p the dishwasher.
2.After the spra y arms stop working, you can ope n the door completely.
3.Add the forgotten dishes.
4.Close the door, the dishwa sher will star t running again after 10 sec onds.
For detailed operating method read the correspond ing content on the instructio n manual.
1. A runn ing cycl e can only be modified if it has been running for a short time. O therwise the deterg ent
m ay have alre ady be en released and the water already drained. If this is the case, the de tergent
dispenser must be refilled.
2. Press the Start/Reset button for more than 3 second s to cancel the running programme.
3. Select a new programme.
4. R estart the dishwash er.
