With each wash cycle.
Compartment
For pro gramm es with pre-wash only.
(Follow the user instructions !)
Electric indicator on control panel (if provided).
Check the rinse aid level
(On models w ith water softener system only.)
Electric indicator on control panel (if provided) .
If there is no salt warning light in the control panel
(for some models), you can estimate when to f ill the salt into
the softene r by the number of cycles the dishwasher has run.
Check the regene ration
salt le vel
Load the baskets
Select a p rog r amme
Close the door, t urn on the water tap and press the St art/reset button. The machine will start working
after about 10 seconds.
Running the dishwasher
Swi tch off the applia nce
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 min utes) before unloading the dishwa sher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
The y will a lso dry better.Unload the appliance, starting from the lower b asket.
Changing the programme
Add forgot ten dishes in the
dishwasher.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pa ns,
then l oad the baskets. Refer to the di shwashe r loading in struct ions.
Press the Programme butto n until the selected progra m me li ghts up .
( See the section entitled Ope rationg instru ction )“ ”
When the working cy cle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the ON/OFF button.
If the appliance is switched
off during a wash cycle.
Op en t he do or carefu ll y.
Hot st eam may escape
when the door is opened!
If the appliance is switched off during a wash cycle, when sw itched
on agai n, plea se re-select th e washing cycle and operate the dishwas her
according to the original P owe r-on state ).
Switch on the appliance Press the On/Off button to switch on the applian c e, Open the door.
1.Open the door a little to sto p the dishwasher.
2.After the spra y arms stop working, you can ope n the door completely.
3.Add the forgotten dish es.
4.Close the door, the dishwa sher will star t running again after 10 sec onds.
For detailed operating method read the corresponding content on the instructio n manual.
1. A running cycle can only be modified if it has been running for a short time. O therwise the deterg ent
m ay have alre ady be en released and the water already drained. If this is the case, the de tergent
dispenser must be refilled.
2. Press the Start/Reset button for more than 3 sec ond s to cancel the running programme.
3. Select a new programme.
4. Restart the dishwash er.
