Wolf 801641 Manual

Wolf Ikke kategoriseret 801641

Læs gratis den danske manual til Wolf 801641 (8 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 2 anmeldelser. Har du et spørgsmål om Wolf 801641, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

MODEL 801641

Page 1

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN-

JURY TO PERSONS, OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manufac-

turer. If you have questions, contact the manufacturer or your

distributor.

2. Before servicing or cleaning unit, switch power off at service

panel and lock the service disconnecting means to prevent

power from being switched on accidentally. When the ser-

vice disconnecting means cannot be locked, securely fasten

a prominent warning device, such as a tag, to the service

panel.

3. Installation work and electrical wiring must be done by a

qualified person(s) in accordance with all applicable codes

and standards, including fire-rated construction codes and

standards.

4. Sufficient air is needed for proper combustion and exhaust-

ing of gases through the flue (chimney) of fuel burning equip-

ment to prevent backdrafting. Follow the heating equipment

manufacturer’s guidelines and safety standards such as

those published by the National Fire Protection Association

(NFPA), and the American Society for Heating, Refrigeration

and Air Conditioning Engineers (ASHRAE), and the local

code authorities.

5. When cutting or drilling into wall or ceiling, do not damage

electrical wiring and other hidden utilities.

6. Ducted fans must always be vented to the outdoors.

7. Do not use this unit with an additional speed control device.

8. To reduce the risk of fire, use only steel ductwork.

9. This unit must be grounded.

TO REDUCE THE RISK OF A COOKTOP GREASE FIRE:

1. Never leave surface units unattended at high settings.

Boilovers cause smoking and greasy spillovers that may ig-

nite. Heat oils slowly on low or medium settings.

2. Always turn hood ON when cooking at high heat or when

cooking flaming foods.

3. Clean ventilating fans frequently. Grease should not be al-

lowed to accumulate on fan or filter.

4. Use proper pan size. Always use cookware appropriate for

the size of the surface element.

TO REDUCE THE RISK OF INJURY TO PERSONS IN THE

EVENT OF A COOKTOP GREASE FIRE, OBSERVE THE

FOLLOWING:*

1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or

metal tray, then turn off the burner. BE CAREFUL TO PRE-

VENT BURNS. If the flames do not go out immediately,

EVACUATE AND CALL THE FIRE DEPARTMENT.

2. NEVER PICK UP A FLAMING PAN - You may be burned.

3. DO NOT USE WATER, including wet dishcloths or towels -

violent steam explosion will result.

4. Use an extinguisher ONLY if:

A. You know you have a Class ABC extinguisher and you

already know how to operate it.

B. The fire is small and contained in the area where it started.

C. The fire department is being called.

D. You can fight the fire with your back to an exit.

* Based on “Kitchen Fire Safety Tips” published by NFPA.

CAUTION

1. For general ventilating use only. Do not use to exhaust haz-

ardous or explosive materials and vapors.

2. To avoid motor bearing damage and noisy and/or unbal-

anced impellers, keep drywall spray, construction dust, etc.

off power unit.

3. Your ventilator motor has a thermal overload which will auto-

matically shut off the motor if it becomes overheated. The

motor will restart when it cools down. If the motor continues to

shut off and restart, have the hood serviced.

4. Please read specification label on product for further infor-

mation and requirements.

EXTERIOR VENTILATOR KITS

SPECIFICATIONS

MODEL VOLTS AMPS CFM DUCT SIZE

801641 120 5.7 900 10 "DIA.

PLAN THE INSTALLATION

1. Locate the ventilator so the length of the duct run and number

of elbows and transitions needed are kept to a minimum.

2. Where possible, ventilator should be located between wall

studs or roof rafters.

3. Avoid pipes, wires, or other ductwork that may be running

through the wall.

4. Be sure that there is enough space for any transitions that may

be needed between the ventilator and the connecting

ductwork.

5. For best performance, locate transitions nearest to ventilator.

Produkt Specifikationer

Mærke:	Wolf
Kategori:	Ikke kategoriseret
Model:	801641

Har du brug for hjælp?

Hvis du har brug for hjælp til Wolf 801641 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Wolf Manualer

10 November 2025

7 November 2025

4 November 2025

2 November 2025

27 August 2024

Wolf CWL-2-325 Manual

27 August 2024

Wolf SM15TF/S Manual

29 Juli 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Martin FiberSource QFX150 Manual

10 November 2025

Ikea TJUSIG 501.609.58 Manual

10 November 2025

IFM EBC050 Manual

10 November 2025

Dahua Technology HAC-HDBW3231E-ZT Manual

10 November 2025

Schuberth F130 Manual

10 November 2025

Adventys MO4I 16000 Manual

10 November 2025

Wooden Camera 152200 Manual

10 November 2025

RTS TM‑10K Gen 2 Manual

10 November 2025

Beverage-Air Horizon HH1-1S-PT Manual

10 November 2025

Sony EVI-D70 Manual

10 November 2025