Xaoc Tirana II Manual

Xaoc Ikke kategoriseret Tirana II

Læs gratis den danske manual til Xaoc Tirana II (6 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 13 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 7 anmeldelser. Har du et spørgsmål om Xaoc Tirana II, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/6

utility micro

sequencer ii

Model of 1960

operator’s manual rev. 1960/2.0

Thank you for purchasing this Xaoc Devices

product. Tirana is a compact, expandable volt-

age source with a wide range of uses including

classic step sequencer, modulation source, volt-

age bank, and arpeggiator.

Tirana is equally suited to small and large sys-

tems alike, either as a single utility or chained

with more Tirana units. This is a second, vastly

improved revision to the original 2014 Tirana,

featuring an updated circuit and a new, more



The module requires 6hp worth of free space

in the eurorack cabinet. The ribbon type pow-

er cable must be plugged into the bus board,

paying close attention to polarity orientation.

The red stripe indicates the negative 12V rail

and is supposed to match a dot, or –12V red

stripe marks on both the unit and the bus

board. The module itself is secured against

reversed power connection, however revers-

ing the 16-pin header may cause serious

damage to other components of your system,

because it will short-circuit the +12V and +5V

power rails. The module should be fastened by

mounting the supplied screws before power-

ing up. To better understand the device, we

strongly advise the user to read through the

entire manual before using the module.

To operate, Tirana expects an external clock

source (up to 320Hz) in the clock input sock-

et . Patching any stable clock generator—

such as an LFO pulse or another sequencer’s

sync output—causes the sequence steps to

play sequentially in a loop. The value for each

step is adjustable by turning knobs 1-4 . By

default, the voltage set by the knob is unipolar

and within the 0V to 10V range. The jumper

on the back of the module allows for the

selection of bipolar voltages within –5 to +5V

range. Another jumper attenuates the volt-

age range to 0V to 5V and –2.5V to +2.5V re-

-

ages and gate/trigger impulses are available

at cv out and gate outputs.

       

pressing the corresponding button until its

light deactivates. Muting a step does not

note:

remove the step from the sequence. The control

voltage remains present for the selected step,

and only the gate/trigger itself is muted.

Sequence direction can be changed by patch-

ing a trigger impulse into the directn input

socket . Sequence can be reset to step 1

by patching a trigger impulse into the reset

input . Sequence can be transposed (offset)

by patching a control voltage into the transp

input .

Hold step 1 and step 4 buttons simultane-

ously for 2 seconds to change whether the

gate output generates a gate or trigger im-

pulse. note: Dynamic gate width modulation

is possible because Tirana’s gate width directly

matches that of the external clock impulse.

Each step can be multiplied (repeated) up to

four times (resulting in up to 16 steps in the se-

quence). The note length is retained upon repeat.

Alternatively, each step can be divided to achieve

the popular ratcheting effect. The trigger/gate

impulse is generated 2, 3 or 4 times per note. To

program these events on a given step, enter the

step menu as follows:

module

explained

Produkt Specifikationer

Mærke:	Xaoc
Kategori:	Ikke kategoriseret
Model:	Tirana II

Har du brug for hjælp?

Hvis du har brug for hjælp til Xaoc Tirana II stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Xaoc Manualer

Xaoc Koszalin Manual

6 August 2025

Xaoc Jena Manual

5 August 2025

Xaoc Odessa Manual

5 August 2025

Xaoc Ostankino II Manual

5 August 2025

Xaoc Timiszoara Manual

5 August 2025

Xaoc Gera Manual

5 August 2025

Xaoc Hrad Manual

5 August 2025

Xaoc NIN Manual

5 August 2025

Xaoc Moskwa II Manual

5 August 2025

Xaoc Mińsk Manual

5 August 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Quantum Turbo 3 Manual

15 Oktober 2025

Stihl TSA 300.0 Manual

15 Oktober 2025

TVS Orbiter Manual

15 Oktober 2025

SilverCrest HG01696C Manual

15 Oktober 2025

HiFi ROSE RS451 Manual

15 Oktober 2025

Samsung WF-F1056V Manual

15 Oktober 2025

Gastroback MultiCook 42568 Manual

15 Oktober 2025

American DJ H2O DMX PRO IR Manual

15 Oktober 2025

Emos DCGW15 Manual

15 Oktober 2025

Gamdias Athena M4M Wood Manual

15 Oktober 2025