Zoeller N42 Manual

Zoeller Vandpumpe N42

Læs gratis den danske manual til Zoeller N42 (2 sider) i kategorien Vandpumpe. Denne vejledning er vurderet som hjælpsom af 18 personer og har en gennemsnitlig bedømmelse på 4.1 stjerner ud af 9.5 anmeldelser. Har du et spørgsmål om Zoeller N42, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

1. Check to be sure your power source is capable of handling the voltage

requirements of the motor, as indicated on the pump name plate.

2. These pumps are not designed or intended to be used to handle sewage

or efuent.

3. This pump has been evaluated for use with WATER only.

4. Maximum continuous operating water temperature for standard model

pumps must not exceed 104 °F (40 °C).

5. These pumps are not designed or intended to be used as a primary or

backup sump pump.

Note: Pumps with the "CSA" mark are tested to CSA Standard C22.2 No. 108.

REFER TO WARRANTY ON PAGE 2.

PERFORMANCE

Your pump is designed to effectively pump all clear storm and drain waters.

Although it will usually pass small particles suspended in water; grass, heavy

mud, sand or pea gravel can clog the pump and reduce pump performance.

This can usually be cleaned out by backushing with a garden hose through

the discharge. The normal performance that can be expected is as follows:

MODEL HP

GALLONS PER HOUR AT

DISCHARGE HEIGHT ABOVE

PUMPING LEVEL

SHUT-OFF

HEAD

5 ft 10 ft 15 ft

42 1/6 900 660 360 20 ft

44 1/4 1800 1320 720 20 ft

46 1/2 3300 2820 2160 34 ft

DO NOT USE FOR PUMPING OILS, GASOLINE OR ANY PETROLEUM BY-PRODUCTS.

Notice to Installer: Instructions must remain with installation.

1. Inspect your pump. Occasionally, products are damaged during shipment. If the unit is damaged, contact your dealer before

using. DO NOT remove the test plug in the cover.

2. Carefully read the literature provided to familiarize yourself with specic details regarding installation and use. These materials should be retained

for future reference.

1. Make sure there is a properly installed ground fault circuit interrupter (GFCI)

protected circuit available. All pumps are furnished with provisions for

proper grounding to help protect you against the possibility of electrical

shock.

2. Make certain that the ground fault receptacle is within the reach of the

pump’s power supply cord. DO NOT USE AN EXTENSION CORD. Extension

cords that are too long or too light do not deliver sufcient voltage to the

pump motor. But, more important, they could present a safety hazard if

the insulation were to become damaged or the connection ends were to

fall into water.

3. Make sure the pump electrical supply circuit is equipped with fuses

or circuit breakers of proper capacity. A separate branch circuit is

recommended, sized according the National Electrical Code for the current

shown on the pump name plate.

4. TESTING FOR GROUND. As a safety measure, each electrical outlet should

be checked for ground using an Underwriters Laboratory Listed circuit

analyzer which will indicate if the power, neutral and ground wires are

correctly connected to your outlet. If they are not, call a qualied licensed

electrician.

5. Installation and checking of electrical circuits and hardware should only

be performed by a qualied licensed electrician.

6. FOR YOUR PROTECTION, ALWAYS DISCONNECT PUMP FROM ITS POWER

SOURCE BEFORE HANDLING.

7. These pumps are supplied with a 3-prong grounded plug to help protect

you against the possibility of electrical shock. DO NOT UNDER ANY

CIRCUMSTANCES REMOVE THE GROUND PIN. The 3-prong plug must be

inserted in a mating 3-prong fault interrupter receptacle. If the installation

does not have such a receptacle, it must be changed to the proper type,

wired, and grounded in accordance with the National Electrical Code and

all applicable local codes and ordinances.

8. Risk of electric shock. This pump has not been tested for use in swimming

pool or marine areas.

9. Prop65 Warning for California residents: Cancer and Reproductive harm-

www.P65Warnings.ca.gov.

CAUTION

SEE BELOW FOR LIST OF

CAUTIONS

SEE BELOW FOR

LIST OF WARNINGS

INSTALLATION INSTRUCTIONS

MODEL: N42, LM44, N44, N46

PREINSTALLATION CHECKLIST - ALL INSTALLATIONS

FM2427

0219

Supersedes

1016

P/N 022508

Product information presented

here reects conditions at time

of publication. Consult factory

regarding discrepancies or

inconsistencies.

MAIL TO: P.O. BOX 16347 • Louisville, KY 40256-0347

SHIP TO: 3649 Cane Run Road • Louisville, KY 40211-1961

TEL: (502) 778-2731 • 1 (800) 928-PUMP • FAX: (502) 774-3624

Visit our web site:

zoellerpumps.com

Zoeller Pump Company

Product on our website:

http://reg.zoellerpumps.com/

DATE INSTALLED:

MODEL NUMBER:

Produkt Specifikationer

Mærke:	Zoeller
Kategori:	Vandpumpe
Model:	N42

Har du brug for hjælp?

Hvis du har brug for hjælp til Zoeller N42 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Vandpumpe Zoeller Manualer

17 September 2025

21 August 2025

20 August 2025

15 Juni 2025

15 Juni 2025

Zoeller 519-0005 Manual

24 August 2024

Zoeller Aquanot Spin 508 Manual

23 August 2024

Zoeller M73 Manual

23 August 2024

Zoeller M53 Manual

23 August 2024

Zoeller Flex 540 Manual

23 August 2024

Vandpumpe Manualer

Nyeste Vandpumpe Manualer

Hayward AquaRite Neo pH Manual

17 December 2025

Hayward AquaRite Neo Manual

16 December 2025

Little Giant 501020 Manual

11 December 2025

Little Giant P-AAA Manual

10 December 2025

Little Giant 5-ASP-FS Manual

10 December 2025

Little Giant PE-1 Manual

9 December 2025

Vevor NMDP42-G30-55-12 Manual

1 December 2025

Vevor HCP370-D Manual

1 December 2025

Eden PAS 3000 Manual

1 December 2025

Vevor FLO500 Manual

1 December 2025