Aerohive AP170 Manual

Aerohive Adgangspunkt AP170

Læs gratis den danske manual til Aerohive AP170 (12 sider) i kategorien Adgangspunkt. Denne vejledning er vurderet som hjælpsom af 17 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 9 anmeldelser. Har du et spørgsmål om Aerohive AP170, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/12
P/N 330052-03, Rev. A 1
AP170 INSTALLATION GUIDE
This guide explains how to mount an Aerohive AP170 Outdoor Access Point to a pole or flat
surface in virtually any outdoor setting, and connect it to Aerohive HiveManager Network
Management over the network. To register, get the latest product documentation, see compliance
information, and download software updates, visit www.aerohive.com/support.
KIT CONTENTS, REQUIRED ACCESSORIES, AND TOOLS
The AP170 kit includes the items shown in Figure 1.
Figure 1 AP170 kit contents
To install your AP170, you will need the following accessories (ordered separately) and tools:
• (2) 2.4 GHz antennas (AH-ACC-170-ANT-2G)
• (2) 5 GHz antennas (AH-ACC-170-ANT-5G)
• A switch that provides PoE power, or a PoE provisioning device
• (1) shielded cat5 Ethernet cable rated for outdoor use; length not to exceed 328 feet (100 m)
• Crosshead screwdriver for 1/4” (6 mm) x 3/8” (10 mm) screws
• Drive sockets (nut drivers) for 3/8” (10 mm) nuts
• Flat blade screwdriver to tighten hose clamp
S AFETY INSTRUCTIONS AND S HITE AZARD WARNINGS
Read and follow these safety instructions and hazard warnings before installing an AP170 outdoors. Keep these
instructions for future reference.
• To comply with RF (radio frequency) exposure limits, do not place the AP170 within 8" (20 cm) of people.
• You can install the AP170 in wet, windy locations. Therefore, make sure to install the Ethernet cable housing for
a complete waterproof connection.
• To protect the AP170 from lightning, do not place it at the highest point of a building or structure.
• To protect your network from lightning, place an Ethernet protector (SKU AH-ACC-1G-ETH-PROT) inline between
the AP170 and the rest of the network. Refer to the installation instructions that ship with the Ethernet
protector.
Plane Bracket (1)
AP170
Base
Bracket (1)
(4) Sleeve-Bolt Assembly
Sleeve, 5/8” (16 mm),
Bolt 1 15/16” (5 cm),
Hex nut 3/8” (10 mm),
Washer 5/8” (16 mm)
(4) Round Head Screw 1/4” (6 mm)
Lock Washer, Flat Washer
(4) Hex Head Bolt, 3/8”x1/2”
(10 mm x 13 mm)
Lock Washer, Flat Washer 1/2” (13 mm)
Hose Strap (1)
Ground Cable (1)
Ethernet
Housing (1)
Aerohive Networks
2
DEVICE, POWER, EAND NVIRONMENTAL SPECIFICATIONS
Understanding the range of specifications for the AP170 is necessary for optimal deployment and device operation.
The following specifications describe the hardware components, PoE (Power over Ethernet) electrical requirements,
and the environmental ranges in which the device can operate.
Device and Enclosure Specifications
• AP170 dimensions (without antennas): 9 5/8” long x 7 7/8” wide x 3" high (22.4 cm x 20 cm x 7.6 cm)
• AP170 weight: 4.85 lb. (2.199 kg) with antennas, 6.05 lb (2.744 kg) with antennas and brackets
• Antennas: 4 N-type female connectors for external antennas
• Ethernet connector: autosensing 10/100/1000 Base-T Mbps; compliant with the IEEE 802.3at standard for PoE
• Mounting options:
• Horizontal or vertical pole mount; pole must be 1" to 3.5" (2.5 cm to 8.9 cm) in diameter
• Wall or flat surface mount
Power Specifications
• PoE nominal input voltages: 48 V, 30 watts
Environmental Specifications
• Operating temperature: -40 to 131 degrees F (-40 to 55 degrees C)
• Storage temperature: -40 to 176 degrees F (-40 to 80 degrees C)
• Relative humidity: Maximum 100%
• Wind survivability: > 165 mph (266 kph)
• Environmental compliance: IP68
To install the AP170, you must be a qualified installation professional, licensed or certified in accordance
with local regulations.
Use only attachments and accessories specified by Aerohive.
During operation, the surfaces of the AP170 can become hot. Use caution when handling it.
Make sure that the AP170 is connected to a suitably installed ground conductor. Contact the appropriate
electrical inspection authority if you are uncertain that suitable grounding is available.
Do not locate the AP170 enclosure near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. During installation, exercise extreme care not to come
into contact with these circuits, which can cause serious injury or death. For proper installation and
grounding of the product, refer to national and local electrical codes: NFPA (National Fire Protection
Association) 70, National Electrical Code Article 810 (U.S.); Canadian Electrical Code, Part I, CSA 22.1 and
Section 54 (Canada); and if local or national electrical codes are not available, refer to IEC (International
Electrotechnical Commission) 364, Part 1 through 7 (other countries).
Do not connect or disconnect antennas or cables from the AP170 during periods of lightning activity.

Produkt Specifikationer

Mærke: Aerohive
Kategori: Adgangspunkt
Model: AP170

Har du brug for hjælp?

Hvis du har brug for hjælp til Aerohive AP170 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Adgangspunkt Aerohive Manualer

Aerohive

Aerohive AP330 Manual

15 August 2024
Aerohive

Aerohive AP121 Manual

12 August 2024
Aerohive

Aerohive AP370 Manual

12 August 2024
Aerohive

Aerohive AP130 Manual

12 August 2024
Aerohive

Aerohive AP1130 Manual

10 August 2024
Aerohive

Aerohive AP170 Manual

10 August 2024
Aerohive

Aerohive AP230 Manual

7 August 2024

Adgangspunkt Manualer

Nyeste Adgangspunkt Manualer

Lancom

Lancom LX-7400 Manual

8 Oktober 2025
Draytek

Draytek Vigor AP 1000C Manual

7 Oktober 2025
Conceptronic

Conceptronic C150APM Manual

7 Oktober 2025
Draytek

Draytek VigorAP 910C Manual

6 Oktober 2025
Draytek

Draytek VigorAP 1062C Manual

6 Oktober 2025
Draytek

Draytek AP918RPD Manual

6 Oktober 2025
Draytek

Draytek VigorAP 918R Manual

6 Oktober 2025
Draytek

Draytek VigorAP 960C Manual

5 Oktober 2025
Draytek

Draytek VigorAP 912C Manual

5 Oktober 2025
Draytek

Draytek VigorAP 902 Manual

5 Oktober 2025