Allen & Heath GL2 Manual

Allen & Heath Ikke kategoriseret GL2

Læs gratis den danske manual til Allen & Heath GL2 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 85 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 43 anmeldelser. Har du et spørgsmål om Allen & Heath GL2, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

L2SM2 ALLEN & HEATH

FREQUENCY RESPONSE: 20Hz to 20kHz +0/-1dB

DISTORTION: . THD 0.01% Line in to mix out at 1kHz

CROSSTALK: . output mute better than 98 dB at 1kHz

channel mute better than 88 dB at 1kHz

fader shutoff better than 88 dB at 1kHz

NOISE: ............ 22Hz to 22kHz

MIC EIN -127.5 dB into 150 ohms

LINE pre-amp at 0dB -88 dBu

MIX noise -85 dB ref 0VU

INTERNAL OPERATING LEVEL: -2 dBu

INTERNAL HEADROOM: ............ +23 dB

MAX OUTPUTS: .......................... balanced +27 dBu 600 ohms max load

unbalanced +21 dBu 2kohms max load

All console inputs and outputs are in-phase except for the GROUP INSERTS on GL2

METERS: ..................................... Peak responding bargraph

0VU = +4dBu at XLR outputs

PEAK LEDs: ................................. Turn on 5dB before clipping

SIG LEDs:

(GL2 only)

.................. dynamic responding Turn on at -20dBu

SPECIFICATION

0 dBu = 0.775 Volts RMS

0 dBV = 1 Volt RMS

POWER REQUIREMENTS: ........ 50/60Hz 40W max

Mains voltage set for local requirements.

PHANTOM POWER: ................... +48V DC 50mA

Channel XLR inputs individually switched

DIMENSIONS:

Width ............... 19.0" standard 19" rack .......... (483mm)

Height .............. 19.2" 11U rack space ............. (488mm)

Depth ............... 3.5" ........................................... (90mm)

WEIGHTS:

Unpacked ........ 21lbs ................... (10.5kg)

Packed ............ 28lbs ................... (13kg)

CONSTRUCTION:

All metal chassis.

Standard 19" rack mount in 11U space.

Single front panel with individual removable circuit assemblies.

Removable base for service access.

Removable internal power supply unit.

OUTPUTS:

L-R OUT ........................ XLR ............................ pin 2 hot, 3 cold balanced .......... 50 ohms ........... +4 dBu +27 dBu max

ST1/2 (GL2-S only) .......... 1/4" JACK .................. tip hot, ring gnd unbalanced ...... 75 ohms ........... variable +21 dBu max

MONO OUT (GL2 only) .. XLR............................ pin 2 hot, 3 cold balanced .......... 50 ohms ........... +4 dBu +27 dBu max

GROUP OUT (GL2 only) XLR ............................ pin 2 hot, 3 cold balanced .......... 50 ohms ........... +4 dBu +27 dBu max

DIRECT OUT ................. 1/4" JACK .................. tip hot, ring gnd unbalanced ...... 75 ohms ........... -2 dBu . +21 dBu max

AUX OUT ....................... 1/4" JACK .................. tip hot, ring gnd unbalanced ...... 75 ohms ........... variable +21 dBu max

2-TRACK SEND ............ RCA PHONO....................................... unbalanced ...... 1 kohm ............. -10 dBV

INSERT SEND ............... 1/4" JACK .................. tip send, ring ret unbalanced ...... 75 ohms ........... -2 dBu . +21 dBu max

MONITOR OUT (GL2 only) 1/4" jack ................. tip left, ring right unbalanced ...... 100 ohms ......... variable +21 dBu max

MONITOR OUT (GL2-S only) RCA PHONO ................................ unbalanced ...... 700 ohms ......... variable +15 dBu max

PHONES OUT ............... 1/4" jack ..................... tip left, ring right for stereo headphones 8 to 400 ohms

INPUTS:

MIC IN ............................ XLR ............................ pin 2 hot, 3 cold balanced .......... 2 kohms ........... variable -60 to -10dBu

LINE IN .......................... XLR............................ pin 2 hot, 3 cold balanced .......... 10 kohms ......... variable -40 to +10 dBu

or 1/4" JACK .................. tip hot, ring cold balanced .......... 10 kohms ......... variable -40 to +10 dBu

STEREO IN A ................ 1/4" JACK .................. tip hot, ring cold unbalanced ...... 20 kohms ......... variable -20 to +22 dBu

STEREO IN B ................ RCA PHONO....................................... unbalanced ...... 20 kohms ......... variable -20 to +22 dBu

RETURN IN ................... 1/4" JACK .................. tip hot, ring gnd unbalanced ...... >10kohms ........ variable -10 dBV min

2-TRACK RETURN ....... RCA PHONO....................................... unbalanced ...... >6 kohms ......... -10 dBV

INSERT RETURN .......... 1/4" JACK .................. tip send, ring ret unbalanced ...... >6 kohms ......... -2dBu

CONNECTIONS

Produkt Specifikationer

Mærke:	Allen & Heath
Kategori:	Ikke kategoriseret
Model:	GL2

Har du brug for hjælp?

Hvis du har brug for hjælp til Allen & Heath GL2 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Allen & Heath Manualer

Allen & Heath MixWizard WZ3 Manual

12 August 2025

Allen & Heath MixWizard WZ2 Manual

12 August 2025

Allen & Heath DT22 Manual

27 Juli 2025

Allen & Heath SQ-Rack Manual

10 Juli 2025

Allen & Heath IP4 Manual

4 Februar 2025

Allen & Heath dLive DM64 Manual

19 September 2024

Allen & Heath Studio 12 Manual

19 September 2024

Allen & Heath Scepter Manual

1 September 2024

Allen & Heath Avantis Manual

29 August 2024

Allen & Heath DL1000 Manual

15 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Golden Lighting Glenn 3699-A1W Manual

31 Oktober 2025

Iogear GCS1412TAA4C Manual

31 Oktober 2025

RaySafe Pro Stand Manual

31 Oktober 2025

Be Cool BCRDTI2026 Manual

31 Oktober 2025

Adventys KTWI Manual

31 Oktober 2025

OmniMount SCTVPK Manual

31 Oktober 2025

Golden Lighting Skye 2090-WSC Manual

31 Oktober 2025

Golden Lighting Lautner 6082-OWM Manual

31 Oktober 2025

Simrad RF70N Manual

31 Oktober 2025

Darkglass Tone Capsule Manual

31 Oktober 2025