APC SYBT9-B4 Manual

APC Batteri SYBT9-B4

Læs gratis den danske manual til APC SYBT9-B4 (2 sider) i kategorien Batteri. Denne vejledning er vurderet som hjælpsom af 49 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 25 anmeldelser. Har du et spørgsmål om APC SYBT9-B4, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Battery Module Storage and Replacement (Symmetra PX and Smart-UPS VT) - 990-2958B 1

Battery Module Storage and Replacement

(Symmetra®

PX and Smart-UPS®

VT)

Directions for replacement

Battery Enclosures with four batteries in a row.

APC recommends that a whole battery module (one row of batteries) is replaced at the same time to

ensure optimal run-time (see Example 1). However it is only necessary to replace two batteries at the

same time according to Example 2 and 3 in the table below.

Battery Enclosures with two modules in a row.

Replace both batteries in one row at the same time.

Warning: Only trained persons familiar with the construction and operation of the

equipment, as well as the electrical and mechanical hazards involved, may install

and remove system components.

Caution: Wait until the system is ready to be powered up before installing Battery

Modules in the UPS. Failure to do so can result in a deep discharge of the batteries and

cause permanent damage (the time from the battery installation time till the UPS is

powered up should not exceed 72 hours or 3 days).

Caution: Do not mix battery units. Replace with same model.

Column A Column B Column C Column D

Example 1 New New New New

Example 2 New New Old Old

Example 3 Old Old New New

Column A Column B

New New

How to store the battery modules

The battery modules must be stored indoors and with their protective packaging still in place.

Stored batteries should be recharged at regular intervals depending on the storage temperature:

How to replace the battery modules

Holding the handle, gently lift the battery unit and pull it halfway out. A lock mechanism prevents it

from being pulled all the way out.

Release the lock by pushing the battery unit upwards and pull the battery unit all the way out while

supporting it

Take the replacement battery unit and push it into the system.

Ambient temperature:

-15° to 40°C/5°F to 104°F

Relative Humidity:

25-85% Non-condensing

Storage place free from vibration,

dust, direct sunlight, and moisture.

Storage Temperature Recharge interval

-15° to 20°C/5°F to 68°F 9 months

20° to 30°C/68°F to 86°F 6 months

30° to 40°C/86°F to 104°F 3 months

Caution: Do not store the batteries for more than 12 months.

Use two people to lift components weighing between 18–32 kg/40–70 lb.

Note

Allow for a 24-hour recharging period of the batteries after system start-up/battery

replacement for battery monitoring data to become fully reliable.

Pxb0026a





01/2007990-2958B *990-2958B*

Produkt Specifikationer

Mærke:	APC
Kategori:	Batteri
Model:	SYBT9-B4
Vægt:	100450 g
Batterikapacitet:	3456 mAh
Pakkevægt:	107400 g
Batteriteknologi:	Blybatterier (VRLA)
Opbevaringstemperatur (T-T):	-15 - 40 °C
Relativ luftfugtighed ved drift (H-H):	0 - 95 %
Relativ luftfugtighed ved opbevaring (H-H):	0 - 95 %
Driftstemperatur (T-T):	0 - 40 °C
Dimensioner (BxDxH):	428 x 700 x 159 mm
Certificering:	CE, UL 1778
Pakkens dimensioner (BxDxH):	600 x 810 x 180 mm
Harmoniseret systemkode (HS):	85044095
Driftshøjde:	0 - 999.9 m
Kompatible produkter:	Symmetra PX 160kW / PX 48kW