Atlas Sound Z-SIGN Manual
Atlas Sound
Modtager
Z-SIGN
Læs nedenfor 📖 manual på dansk for Atlas Sound Z-SIGN (10 sider) i kategorien Modtager. Denne guide var nyttig for 6 personer og blev bedømt med 3.7 stjerner i gennemsnit af 3.5 brugere
Side 1/10
©2019 Atlas Sound LP. The Atlas “Circle A”, Soundolier, and Atlas Sound are trademarks of Atlas Sound L.P. IED is a Registered Trademark of Innovative Electronic Designs LLC. All rights reserved.
All other Trademarks are property of their respective owners. No endorsement is implied. Due to continual product development, specifications are subject to change without notice. ATS005891 RevF 6/19
AtlasIED.com
TELEPHONE: (800) 876-3333
SUPPORT@ATLASIED.COM
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
Quick Start Guide
Z-SIGN
Overview
Thank you for purchasing the AtlasIED Z-SIGN - Wireless Privacy Transceiver. This quick start guide describes how to connect the Z-SIGN to a Z Series
High Definition Acoustical System. The Z-SIGN can be used in three different operations. The most common use for the Z-SIGN is to be used as a
wireless switch to activate the Speech Privacy Enhancement mode in a Z Series unit. This application also serves as visual indicator to show when
enhanced speech privacy is engaged. The Z-SIGN can also be used strictly as a visual indicator with the activation button being disabled. In this
application, it is common for the Z-SIGN to be used as a second or third visual indicator in a meeting room. Finally, the Z-SIGN can be used as a data
transmission / receiving conduit between a mobile device and a Z Series unit (see the example below). The Z-SIGN incorporates BLE
®
communication
technology for pairing to a mobile device for short distance data communication (not streaming audio), and uses 915MHz ISM Band to transmit longer
distances to a Z Series unit. The Z Series mobile App is needed for this function. Using the mobile App with a Z-SIGN allows for mobile control of the
Z Series unit and status of the Z system. For more information on the Z Series App, refer to the App User Guide.
Panels
1. Settings A Button
2. Settings B Button
3. Privacy Activation Button
4. Micro USB Charge Port or Direct Power and PC Firmware Upload
5. Removable Mounting Plate
6. Battery Tab
7. Battery Door and Screw
8. Firmware Label
9. Serial Number
10. Displayed Color Functions
1
5
9
8
6
4
7
10
2
3
Z Series App Z-SIGN Z2 or Z4 Base Unit
Bluetooth
®
BLE
®
Bluetooth
®
Streaming
UHF
©2019 Atlas Sound LP. The Atlas “Circle A”, Soundolier, and Atlas Sound are trademarks of Atlas Sound L.P. IED is a Registered Trademark of Innovative Electronic Designs LLC. All rights reserved.
All other Trademarks are property of their respective owners. No endorsement is implied. Due to continual product development, specifications are subject to change without notice. ATS005891 RevF 6/19
AtlasIED.com
TELEPHONE: (800) 876-3333
SUPPORT@ATLASIED.COM
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
Basic Set-up and Pairing for Installation
Note: This Guide assumes that the Z2 or Z4 unit has already been installed and is working. Before pairing, reset the Z-SIGN to Factory Default if it has
been previously paired to another Z Series System.
1. Remove the battery tab (#6) at upper left of battery door (#7) or if the batteries are not installed remove the battery door (#7). Open the battery
door (#7) and insert batteries. It is recommended to charge the batteries for 1 - 2 hours before use. See below for battery charging instructions. Pay
close attention to the battery polarities. Secure the door. Do not over tighten the screw.Caution:
2. Peel off the Z-SIGN protective covering.
3. Go to the Z Series menu tree. Navigate to “Pair Z Signs” and press ( ), then Enter.
4. While the menu says “Pairing……” (within 20 seconds), press and hold the Privacy Activation button (#3) on the Z-SIGN until you see “Pairing
Successful” in the menu tree display. The "Enhanced Privacy In Use" will flash green while holding the Activation button (#3), indicating it is
establishing the connection.
5. The screen will revert to the “Paired Z Signs” screen and will indicate that 1 Z-SIGN is paired to the Z Series unit. The Z-SIGN will remain Note:
paired to the Z Series unit it was originally set up with until a Reset to Factory Default action is initiated. (See A & B Option Key Settings)
6. Repeat these steps to pair up to 10 Z-SIGNs to 1 Z Series unit.
7. It is very important to start with fully charged batteries before using the Z-SIGN. Refer to the "Recharging Batteries" section.
Testing the Enhanced Speech Privacy Function
1. Press the Privacy Activation button (#3) and the “Enhanced Privacy In Use” will illuminate green. The Speaker Wave icon will go into a slow pulse
“Heart-Beat” indicating it is now paired and Enhanced Privacy is activated.
2. When activated, the Z Series home menu screen will change from “Status = Active” to blinking “Status = Enhanced Privacy”.
3. Press the Privacy Activation button (#3) again and the Enhanced Privacy function will stop.
4. The Z-SIGN is now ready to be mounted in the desired location. Be aware of the range between the Z-SIGN and Z Series unit. It is important Note:
to read the “Installation Out of Range Indication” section.
Pair Z Signs
1 Paired-Pair Signs>
*To Pair Sign
Press Enter
Pairing. . . . . Pairing Successful
Pair Z Signs
4 Paired-Pair Signs>
Model Z4 - ID 7968
Status=Enhanced Privacy
Z-SIGN Z2 or Z4 Base Unit
UHF
100'
Produkt Specifikationer
| Mærke: | Atlas Sound |
| Kategori: | Modtager |
| Model: | Z-SIGN |
Har du brug for hjælp?
Hvis du har brug for hjælp til Atlas Sound Z-SIGN stil et spørgsmål nedenfor, og andre brugere vil svare dig
Modtager Atlas Sound Manualer
10 Juni 2025
19 December 2024
18 December 2024
18 December 2024
18 December 2024
18 December 2024
18 December 2024
18 December 2024
18 December 2024
5 September 2024
Modtager Manualer
- Modtager Taga Harmony
- Modtager Technical Pro
- Modtager AVMATRIX
- Modtager Motorola
- Modtager RetroSound
- Modtager Yaesu
- Modtager Loxjie
- Modtager Pyle
- Modtager Zalman
- Modtager AEA
- Modtager Planet Audio
- Modtager Bosch
- Modtager Hotone
- Modtager KanexPro
- Modtager Behringer
Nyeste Modtager Manualer
10 Juni 2025
10 Juni 2025
10 Juni 2025
10 Juni 2025
9 Juni 2025
9 Juni 2025
8 Juni 2025
8 Juni 2025
8 Juni 2025
8 Juni 2025