Atlona AT-VCC-RS232-KIT Manual

Atlona Ikke kategoriseret AT-VCC-RS232-KIT

Læs gratis den danske manual til Atlona AT-VCC-RS232-KIT (12 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 24 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 12.5 anmeldelser. Har du et spørgsmål om Atlona AT-VCC-RS232-KIT, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/12

Installation Guide

AT-VCC-RS232-KIT

IP to RS-232 Command Converter for Velocity Control

System

AT-VCC-RS232-KIT

The Atlona AT-VCC-RS232-KIT is an accessory for the Atlona Velocity™ Control System that

provides conversion between IP and RS-232 control commands. This Velocity Control Converter

is very compact and can be placed anywhere a device requires control and is not IP-capable.

The VCC-RS232-KIT is remotely powered through Power over Ethernet (PoE), or locally from a

USB power source. The primary unit installs onto any surface via a convenient mounting dock. A

simple “click” locks it into place for a secure, reliable installation. An RS-232 gender changer is

included.

1 x AT-VCC

1 x AT-VCC-RS232

Package Contents

Operating Notes

• The AT-VCC-RS232-KIT is PoE, to power the unit, simply plug it into a PoE compatible

network switch. If the network switch is not PoE capable, a PoE injector (purchased separately)

or USB can be used.

• All devices (AT-VCC, Velocity, AT-VTP, switchers, etc) should be set to static IPs or the

DHCP IP address reserved for each individual device.

IMPORTANT: Velocity Gateway (AT-VGW-HW) must be set up before the AT-VCC-RS232-

KIT is fully functional.

Installation Guide

AT-VCC-RS232-KIT

16 2 3 4 5

1 Ethernet

Connect an Ethernet cable from this

port to the same network as the Velocity

Gateway .

2 USB

Not used at this time.

3 3.5mm Port

Connect to a VCC RS-232 3.5mm

connector.

4 RS-232 Connector

Connect the RS-232 connector into the

RS-232 port of the controlled device.

5 3.5mm Connector

Connect the 3.5mm connector to the

3.5mm port of the VCC.

6 Factory Reset Button

Press and hold this button to reset all

settings to the factory default.

Panel Description

RS-232

The VCC RS-232 comes with a 3.5mm to DB9 adapter. To ensure the signal passes correctly,

verify the pins match the device connecting to. The pin out is found below.

Pin 2 - RX

Pin 3 - TX

Pin 5 - Ground

Pin 7 - RTS

Pin 8 - CTS

Pin 4 - DTR

Pin 6 - DSR

Data Data Flow Control Modem Control

GND

RXTX

NOTE: Do not alter or cut the RS-232 3.5mm cable in any way. The cable is

proprietary and is the only compatible 3.5mm connector for the VCC.

Produkt Specifikationer

Mærke:	Atlona
Kategori:	Ikke kategoriseret
Model:	AT-VCC-RS232-KIT
Bredde:	15.24 mm
Dybde:	32.51 mm
Højde:	55.88 mm
Vægt:	40 g
Produktfarve:	Sort
Værtsgrænseflade:	RJ-45
Intern:	Ingen
Output-grænseflade:	RS-232