Audio-Technica ATW-902A Manual

Audio-Technica Ikke kategoriseret ATW-902A

Læs gratis den danske manual til Audio-Technica ATW-902A (10 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 38 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 19.5 anmeldelser. Har du et spørgsmål om Audio-Technica ATW-902A, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/10
System 9
VHF Wireless System
Installation and Operation
ATW-901a/G
Guitar System
ATW-901a/H
Headworn Microphone System
ATW-901a/L
Lavalier Microphone System
ATW-902a
Handheld Microphone System
PEAKRF
1 2 3 4
CHANNEL
System 9 Installation and Operation
2
This device complies with part 15 of the FCC Rules. Operation is subject
to the condition that this device does not cause harmful interference.
A copy of the declaration of conformity can be found on the internet at
www.audio-technica.com.
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
CAUTION! Electrical shock can result from removal of the receiver
serviceable parts inside. Do not expose to rain or moisture.
The circuits inside the receiver and transmitter have been precisely
adjusted for optimum performance and compliance with federal
regulations. Do not attempt to open the receiver or transmitter. To do so
will void the warranty, and may cause improper operation.
Notice to individuals with implanted cardiac pacemakers or AICD
devices:
Any source of RF (radio frequency) energy may interfere with normal
functioning of the implanted device. All wireless microphones have
low-power transmitters (less than 0.05 watts output) which are unlikely
However, since a “body-pack” mic transmitter typically is placed against
the body, we suggest attaching it at the belt, rather than in a shirt
pocket where it may be immediately adjacent to the medical device.
Note also that any medical-device disruption will cease when the RF
transmitting source is turned off. Please contact your physician or
medical-device provider if you have any questions, or experience any
problems with the use of this or any other RF equipment.
Thank you for choosing an Audio-Technica professional wireless
have chosen our products because of their quality, performance and
reliability. This wireless microphone system is the successful result of
years of design and manufacturing experience.
Audio-Technica’s System 9 is a four-channel frequency-agile wireless
system designed to provide rock-solid performance along with
easy setup and clear, natural sound quality. Featuring stackable,
contemporary styling, System 9 is available in handheld, headworn,
compatible user-switchable channels in one of four available VHF
frequencies (169.505, 170.245, 171.045, and 171.905 MHz).
Each System 9 professional VHF wireless system includes a receiver
and either a body-pack transmitter or a handheld microphone/transmitter.
ATW-901a UniPak® body-pack transmitter systems include models
pre-packaged with either an AT-GCW guitar cable (/G), a PRO 8HEcW
headworn microphone (/H), or a lavalier mic (/L) for particular applications.
All A-T Wireless Essentials
® microphones and cables, available separately,
are pre-terminated for use with any ATW-901 system.
Because System 9 packaging is designed to hold all versions
of the system, some compartments in the carton may be intentionally
left empty.
The ATW-R900a receiver includes a switching power supply that
automatically adapts to changes in mains voltage.
The versatile ATW-T901a UniPak body-pack transmitter has both
a high-impedance input for instruments, and a low-impedance input
with bias connection for use with dynamic and electret condenser
microphones. The ATW-T902a handheld transmitter features a
unidirectional dynamic microphone element.
Both the body-pack and handheld transmitters use internal AA batteries
and have Power/Mute switches and input Trim (level) adjustments.
Receiver Installation
Location
For best operation the receiver should be at least 3' (1 m) above the
ground and at least 3' (1 m) from a wall or metal surface to away
sources such as digital equipment, motors, automobiles and neon
lights, as well as away from large metal objects. In multi-channel
systems, position receivers at least 3' (1 m) apart and keep operating
transmitters at least 6' (2 m) from the receivers to help assure
maximum RF performance.
Output Connections
There are two audio outputs on the back panel: balanced and
unbalanced. Use shielded audio cable for the connection between the
receiver and the mixer. If the input of the mixer is a
1/4" jack, connect a
cable from the 1/4" unbalanced audio output on the back of the receiver
housing to the mixer. If the input of the mixer is an XLR-type input,
connect a cable from the balanced XLR-type audio output on the back
panel to the mixer.
Power Connection
Connect the DC plug on the included AC power adapter to the DC
power input on the back of the receiver. Secure the cord over the cord
hook on the back of the receiver, to keep the plug from being detached
by an accidental tug on the cord. Then plug the adapter into a standard
120 Volt 60 Hz AC power outlet.
(Note that the receiver has no power Off/On switch. The receiver will be
energized whenever the power adapter is connected and plugged into
the AC outlet. Unplug the power supply from the AC outlet when the
system is not in use — both for safety, and to conserve energy.)
Antennas
A novel “dipole” antenna system on the receiver improves operation
by providing a “ground” element in addition to the usual “signal”
element. Position the two antennas at 90° in the form of a “V,” or
position the left (“signal”) antenna vertically and the right (“ground”)
antenna horizontally, in the shape of an “L” (Fig. A). Use the position
that performs better in your operating environment. Be certain to
extend both antennas to their full 15" (38 cm) length by holding them at
their bases and pulling out on their caps. Both antenna elements may
be swiveled to the left and right, but do not attempt to rotate them in a
screwing/unscrewing motion. To do so may damage the antenna and/or
receiver. For best performance, locate the receiver so its antennas are
in direct line-of-sight to the transmitter’s likely operating position.

Produkt Specifikationer

Mærke: Audio-Technica
Kategori: Ikke kategoriseret
Model: ATW-902A

Har du brug for hjælp?

Hvis du har brug for hjælp til Audio-Technica ATW-902A stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Audio-Technica Manualer

Audio-Technica

Audio-Technica AT6028 Manual

20 Juli 2025
Audio-Technica

Audio-Technica AT-VM670xSP Manual

19 Juni 2025
Audio-Technica

Audio-Technica AT-VM740xML Manual

18 Juni 2025
Audio-Technica

Audio-Technica AT-VM510xCB Manual

18 Juni 2025
Audio-Technica

Audio-Technica AT-VM520xEB Manual

18 Juni 2025
Audio-Technica

Audio-Technica AT-VM750xSH Manual

18 Juni 2025
Audio-Technica

Audio-Technica AT-VM520xEBH Manual

17 Juni 2025
Audio-Technica

Audio-Technica AT-VM610xMONO Manual

17 Juni 2025
Audio-Technica

Audio-Technica AT-VMN40xML Manual

17 Juni 2025
Audio-Technica

Audio-Technica AT-VM745xML Manual

17 Juni 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Intellinet

Intellinet 561730 Manual

31 Juli 2025
Oppo

Oppo X7 Ultra Manual

31 Juli 2025
Oppo

Oppo K11 Manual

31 Juli 2025
Bestway

Bestway Hydro-Force 6531R Manual

31 Juli 2025
RYOBI

RYOBI RSCR4 Manual

31 Juli 2025
Advantech

Advantech AIMB-286EF Manual

31 Juli 2025
Tripp Lite

Tripp Lite SUT40KMBP Manual

31 Juli 2025
Tripp Lite

Tripp Lite Protect It! TLP28PD57WCAM Manual

31 Juli 2025
Advantech

Advantech PCIE-1751 Manual

31 Juli 2025
Intellinet

Intellinet 713078 Manual

31 Juli 2025