AudioSource AMP 50 Manual

AudioSource Modtager AMP 50

Læs gratis den danske manual til AudioSource AMP 50 (2 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 32 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 16.5 anmeldelser. Har du et spørgsmål om AudioSource AMP 50, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

AMP 50

Stereo Power Ampliﬁer

Congratulations on your purchase of the AudioSource® AMP 50.

Please take a few moments to read this entire manual, and be sure to

retain this document for future reference. Please read and observe all

safety instructions detailed on page 2.

NOTE: If any part of this product is damaged or missing, please call your

dealer or AudioSource® directly at 1.877.715.5439 or 503.914.4688.

Please read your warranty and retain your receipt and original carton

for possible future use.

For more information about AudioSource® electronics, speakers and

accessories please visit www.audiosource.net

FEATURES:

Separate Bass & Treble Controls

Front Panel Volume Controls

Signal Sensing “Power On / Off”

Mini Form Factor / Light Weight

SPECIFICATIONS

Stereo (8 ohm): 25W per channel, 20Hz ~ 20kHz, <1% THD+N*

Stereo (4 ohm): 30W per channel, 20Hz ~ 20kHz, <1% THD+N*

Bridged Mono (8 ohm): N/A

Frequency Response: 10Hz ~ 20kHz, +0dB/ -3dB

Signal to Noise Ratio: 100dBA

Channel Separation: 65dB @ 1kHz

Input Sensitivity: 900mV input for rated output

into 8 ohms

AC Power Consumption: 250W maximum

Net Weight: 2.1lbs / 1kgs

8.5” (216mm)

6”

(153mm)

2.75”

(70mm)

AMP 50

Power

Auto On/Off

Bass Treble Volume

MIN MAX MIN MAX MIN MAX

Stereo Power Ampliﬁer

0 0

13970 SW 72nd Ave. Portland, OR 97223 • 503.914.4688 • www.audiosource.net

AMP 50 Owners Manual

AMP 50

OWNER’S MANUAL

*Peak Power

2 x 15 Watts RMS @ 8 Ohms

50’ or less - 16 Gauge 2-Cond. CL3 Rated

50’ - 150’ - 12 Gauge 2-Cond. CL3 Rated

150’ - 200’ - 10 Gauge 2-Cond. CL3 Rated

For stereo output connect the speaker’s positive (red) terminal to the ampliﬁer’s

positive (red) terminal, and the speaker’s negative (black) terminal to the

ampliﬁer’s negative (black) terminal for each Right and Left speaker.

NOTE: To prevent sonic degradation in your speaker installation, total speake r

wire resistance should be kept below 0.5 ohms. This table lists recommended

speaker wire gauge versus wire run length.

SPEAKER TERMINALS

CAUTION

RISK OF ELECTRICAL SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER. NO

USER SERVICABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL!

Limited Warranty

AudioSource® warrants its ampliﬁer products against defects in materials

and workmanship for a limited period of time. For a period of two years from

date of original purchase, we will repair or replace the product, at our option,

without charge for parts and labor. Customer must pay all parts and labor

charges after the limited warranty period expires. The limited warranty period

for factory refurbished products expires after ninety (90) days from date of

original purchase.

This limited warranty applies only to purchases from authorized AudioSource®

electronics retailers. This limited warranty is extended only to the original

purchaser and is valid only to consumers in the United States.

Consumers are required to provide a copy of the original sales invoice from

an authorized AudioSource® dealer when making a claim against this limited

warranty. This limited warranty only covers failures due to defects in materials

or workmanship that occur during normal use. It does not cover failures

resulting from accident, misuse, abuse, neglect, mishandling, misapplication,

alteration, faulty installation, modiﬁcation, service by anyone other than

AudioSource®, or damage that is attributable to Acts of God. It does not

cover costs of transportation to AudioSource® or damage in transit. The

customer should return his defective product, freight prepaid and insured, to

AudioSource® only after receiving a Return Authorization.

This warranty will become void if the serial number identiﬁcation has been

wholly or partially removed, altered or erased. Repair or replacement under

the terms of this warranty does not extend the terms of this warranty. Should

a product prove to be defective in workmanship or material, the consumer’s

sole remedies will be repair or replacement as provided under the terms

of this warranty. Under no circumstances shall AudioSource® be liable for

loss or damage, direct, consequential or incidental, arising out of the use of

or inability to use the product. There are no express warranties other than

described above.

REAR PANEL CONTROLS

8. Speaker Zone A Output

Speaker output terminals for zone A.

9. Speaker Zone B Output

Speaker output terminals for zone B

7. Power Cord & Fuse Holder

This ampliﬁer is conﬁgured for operation at 115V. (North America) A fuse

in the integrated holder provides safety protection from fault conditions.

Replace fuse with 5 x 20mm T4A 250V.

5. RCA Input

This is the primary input connector used by most home audio sources

6. Mini Stereo Input

This is the primary input connector used by most portable audio source

as well as most computers

10. Auto-On / Normal Switch

Changes amplifier power on function from manual to auto sensing.

13970 SW 72nd Ave. Portland, OR 97223 • 503.914.4688 • www.audiosource.net 2

13970 SW 72nd Ave. Portland, OR 97223 • 503.914.4688 • www.audiosource.net

AMP 50 Owners Manual

AMP 50

OWNER’S MANUAL

1. Power Switch

Switches the AMP 50 on or off. A red LED indicates connection to AC power

while in standby mode.

2. Bass Adjustment Control

3. Treble Adjustment Control

4. Volume

Adjusts ampliﬁer volume.

FRONT PANEL CONTROLS

321 4

13970 SW 72nd Avenue Portland, Oregon 97 223

503.914.4688 Fax: 503.746.5224 Support: 877.715.5439

www.audiosource.net su pport@au diosou rce.net

Left Input

Right Input

Stereo

Input

FUSE 4A/250V

AC 18V

AUTO ON

NORMAL AUTO

Figure 2. Rear Panel

Figure 1. Front Panel

AMP 50

Power

Auto On/Off

Bass Treble Volume

MIN MAX MIN MAX MIN MAX

Stereo Power Ampliﬁer

0 0

Produkt Specifikationer

Mærke:	AudioSource
Kategori:	Modtager
Model:	AMP 50
Tænd-/slukkontakt:	Ja
Bredde:	215.9 mm
Dybde:	152.4 mm
Højde:	69.85 mm
Vægt:	952.5 g
Produktfarve:	Sort
Volumenkontrol:	Dreje
Frekvensområde:	20 - 20000 Hz
Forbindelsesteknologi:	Ledningsført
Lyd-output kanaler:	2.0 kanaler
LED-indikatorer:	Ja
Formål:	Hjem
Lyd (L, R) indgang:	1
AC (strøm) indgang:	Ja
klirfaktor (THD):	1 %
Signal/støjforhold:	101 dB
Bas indstillinger:	Ja
Diskant indstillinger:	Ja
Spidseffekt pr. kanal:	- W
Højttalere tilslutningstype:	Klemmeterminaler
RMS udgangseffekt pr. kanal (4 Ohm):	30 W
Linie indgående (RCA):	2
RMS udgangseffekt pr. kanal (8 ohm):	25 W
Mulighed for flere oner:	Ja