Audison LRx 2.250 Manual

Audison Modtager LRx 2.250

Læs gratis den danske manual til Audison LRx 2.250 (12 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 31 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 16 anmeldelser. Har du et spørgsmål om Audison LRx 2.250, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/12

OWNER’S MANUAL

CAR POWER AMPLIFIERS

PRINTED IN ITALY - Code 10125760

62018 Potenza Picena (MC) Italy

Tel. 0733.870870 • Fax 0733.870880 • http://www.audison.com • e-mail: com@audison.com

is a division of

Audison measurement standards

(Power measures taken according to audison standard, 1998 edition)

- 12VDC and 13.8VDC;

- 1 kHz or crossover cut-off frequency;

- 0.3% THD @ nominal power; 1% THD @ continuous power;

- Tolerance: +10%; -5%;

- Continous power given by RMS Voltage measured on resistive load;

- The nominal power of the amplifier is measured upon a battery voltage of 12 Volts with

a 4 Ohm load and with all channels in function.

INTRODUCTION

Audison thanks you for preferring this product and compliments you on your choice since it was

designed in order to insure outstanding musical and instrumental performances.

Before use instructions, please carefully read the safety norms you have to respect in order to avoid

unpleasant inconveniences and to enjoy this product at best.

PRECAUTIONS

- Avoid to install the amplifier where temperature is below 0˚C or above 55˚C and in non ventilated

places.

- The amplifier needs 12VDC power supply voltage with negative to ground. Be sure that your car electric

system is compatible with the amplifier ordinary functioning.

- For safer driving, we recommend to adjust volume not to drown external traffic sounds.

WARNING!:

While installing the amplifier, make sure that the cable coming from the battery positive pole (+)

doesn’t touch the amplifier heat sink.

The heat sink is directly connected to the battery negative pole (-) through the screws which fix it to the

vehicle chassis. Its contact with the positive pole cable would cause short circuit and, thus, possible fires

and battery damages.

Please connect power supply cables to the amplifier terminal blocks (POWER + and -) before and

to battery AFTER, to get maximum safety.

CAUTIONS

INPUTS: If the source output signal ground (PRE OUT) is not connected to the source chassis and the

system sound is not powerful enough or is distorted, try to solve the problem by connecting the output

signal cable braided shield (PRE OUT) to a point of the source chassis.

OUTPUTS: Don’t connect –L and –R power outputs to each other or to ground (car chassis). In case you

use an external crossover, make sure that channels grounds are not connected one to the other.

INSTALLATION

audison cable PRODUCTS FOR ELECTRIC CONNECTIONS

Produkt Specifikationer

Mærke:	Audison
Kategori:	Modtager
Model:	LRx 2.250

Har du brug for hjælp?

Hvis du har brug for hjælp til Audison LRx 2.250 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Modtager Audison Manualer

Audison VOCE AV uno Manual

2 September 2024

Audison LR 604 XR Manual

2 September 2024

Audison AP4 D Manual

2 September 2024

Audison SR1.500 Manual

2 September 2024

Audison Voce AV 5.1k HD Manual

2 September 2024

Audison LR 1140 M Manual

2 September 2024

Audison SR4.500.2 Manual

2 September 2024

Audison Prima AP1 D Manual

2 September 2024

Audison LR 435 Manual

2 September 2024

Audison VOCE AV quattro Manual

2 September 2024

Modtager Manualer

Nyeste Modtager Manualer

Planet Audio MB1200.4D Manual

15 Juni 2025

Pure Acoustics AZ-2U-3240 Manual

15 Juni 2025

Ecler AURA-4B600 Manual

15 Juni 2025

Planet Audio TR3000.1D Manual

15 Juni 2025

Planet Audio MB1200.1D Manual

15 Juni 2025

Planet Audio TR4000.1D Manual

15 Juni 2025

Planet Audio PL3000.1D Manual

15 Juni 2025

Planet Audio PSX18 Manual

15 Juni 2025

Planet Audio MB600.2D Manual

15 Juni 2025

Planet Audio AC1600.4 Manual

15 Juni 2025