
Congratulations on Bushman DCyour purchase of a -L fridge. these instructions carefully Please read
before installation use. and
Please be safe and use common sense and caution when installing, operating and cleaning this appliance. If
you are unsure about any of these instructions, contact your local dealer before proceeding.
Do not lay your fridge on its back, top If your fridge has been or sides or at any angle exceeding 30º.
incorrectly handled, ensure that the fridge is placed in a level upright position for 12 hours to allow the internal
fluids to redistribute evenly.
Never operate your fridge directly from a 240 V or AC power . supply
Do not use a modified sine wave inverter to operate your fridge.
At delivery, please check that the fridge is complete and is not damaged in any way. Remove all packaging
and securing tapes from the fridge. To avoid injury and causing damage to the appliance, be extremely
cautious when using sharp or pointed tools to complete this task.
Do not connect an appliance that has been damaged, contact your local stockist immediately.
Installation of the DC-L range of fridges must be completed by a suitably trained professional only.
Your fridge V V must be connected to a stable and regulated 12 or 24 DC power supply only. The compressor
will automatically detect which voltage is present adjust accordingly.
If you are using a generator or other power supply, the output must be a pure sine wave. Any fluctuations in
generator current may damage the compressor.
For optimum results, you will need the correct sized wire depending on the distance from your power supply
to the fridge. Wiring must be to your directly from your fridge battery and should be continuous without joins.
Please also ensure the earth is wired directly to your battery, not to a chasse. If your sufficientwiring is in , your
fridge may not perform correctly or may be even be damaged.
MAXIMUM LENGTH OF WIRE IN
Any switches must have a breaking load not less than 20 A on 12 V or 10 A on 24 volts.
Ensure the wiring polarity is correct. Connect the red wire to the positive terminal (+) and the black wire to the
Never connect bare electric wires. Use only connections of a size suitable for the cross section of the wire