Bushman DC230-X Manual

Bushman Køleskab DC230-X

Læs gratis den danske manual til Bushman DC230-X (8 sider) i kategorien Køleskab. Denne vejledning er vurderet som hjælpsom af 29 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 15 anmeldelser. Har du et spørgsmål om Bushman DC230-X, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/8
Owners Manual &
Operating Instructions
BUSHMAN DC230-X
Congratulations on your purchase of DC230 a Bushman -X. Please read these instructions carefully
before installation and use.
IMPORTANT INFORMATION
Do not lay your fridge on its back, top or sides or at any angle exceeding 30º. If your fridge has been handled
this way, stand the fridge upright for 12 hrs to allow the internal fluids to redistribute evenly before use.
Never operate your fridge directly from a 240 V or AC power . supply
Do not use a modified sine wave inverter to operate your fridge.
PRIOR TO INSTALLATION
DELIVERY
At delivery, please check that the fridge is complete and is not damaged in any way. Remove all packaging and
securing tapes from the fridge. To avoid injury and causing damage to the appliance, be extremely cautious
when using sharp or pointed tools to complete this task. Do not connect an appliance that has been damaged,
contact Bushman immediately.
INSTALLATION
2
Installation of the DC230-X must be completed by a suitably trained professional only.
POWER SUPPLY
Your fridge V V must be connected to a stable and regulated 12 or 24 DC power supply only. The compressor
will automatically detect which voltage is present and adjust accordingly.
If you are using a generator or other power supply, the output must be only a pure sine wave.
WIRING
Always wire your fridge directly to your battery terminals. Do not run the wires via a buss bar, battery
management system or shared circuit. Please also ensure the earth is wired directly to your battery, not to a
chassis.
Ensure the wiring polarity is correct. Connect the red wire to the positive terminal (+) and the black wire to the
negative terminal (-). Never connect bare electric wires. Use only connections of a size suitable for the cross
section of the wire being used.
CROSS
SECTION
IN MM
2
AWG
(AMERICAN
WIRE GAUGE)
MAXIMUM LENGTH OF WIRE IN
METRES
12 V
24 V
2.5
14
2.5
5
4
12
4
8
6
10
6
12
10
8
10
20
ISOLATION SWITCH AND FUSE
We recommend installing an isolation switch for the fridge circuit as close to your battery bank as possible. Any
switches must have a breaking load not less than 20 A on 12 V or 10 A on 24 V.
The power supply wiring must also be protected with a 15 A fuse.
INSTALLATION IN A CAVITY
Your new fridge 5is designed to be installed in a cavity. We recommend allowing a minimum mm gap on each
side and the top for ease of installation. A minimum gap of 25mm is required for the rear. Refer to the following
table for the recommended - cut out dimensions.
MODEL
CUT- OUT CAVITY DIMENSIONS (MM)
WIDTH
DEPTH
HEIGHT
DC230-X
605
550
1460
MOUNTING KIT
Position the mounting kit flush with the front edge of the fridge cabinet and mark the position of the holes. Drill
shallow, to the side and top of 3mm drill bit, pilot holes through the sheet metal cabinet. Affix the mounting kit
the fridge cabinet using the screws provided.
Once the fridge has been connected to the power supply and moved into its final position, the mounting kit can
be affixed to the front of the cavity.
INTERNAL MOUNTING SLEEVES
There are 4 internal mounting sleeves on internal mounting sleevethe inside 2 of the fridge cabinet, and s in the
inside of the freezer compartment. Access is provided by gently levering off the plastic caps. M5 screws or
bolts need to be used. Drill 4mm pilot holes through the plastic sleeve and right through the fridge cabinet
sides. Put a small nylon washer onto the screw / bolt heads before inserting. Ensure that the exterior of the
fridge cabinet is flush with your cabinetwork before affixing the screws / bolts. If there is a gap, pack it out with
a suitable hard material. C heck for screw / bolt tightness after your first trip.
VENTILATION

Produkt Specifikationer

Mærke: Bushman
Kategori: Køleskab
Model: DC230-X

Har du brug for hjælp?

Hvis du har brug for hjælp til Bushman DC230-X stil et spørgsmål nedenfor, og andre brugere vil svare dig


Køleskab Bushman Manualer

Bushman

Bushman XCD280-W Manual

11 Juli 2025
Bushman

Bushman DF30-HD Manual

10 Juli 2025
Bushman

Bushman XCD185-W Manual

9 Juli 2025
Bushman

Bushman DC285L-X Manual

10 Marts 2025
Bushman

Bushman DC190L-X Manual

10 Marts 2025
Bushman

Bushman DC190L-W Manual

10 Marts 2025
Bushman

Bushman XCD100-X Manual

10 Marts 2025
Bushman

Bushman DC230-X Manual

10 Marts 2025

Køleskab Manualer

Nyeste Køleskab Manualer

Iberna

Iberna FR IC320 SIN Manual

10 Oktober 2025
Miele

Miele KFN 7774 B Manual

10 Oktober 2025
Iberna

Iberna FR ICM 38 A Manual

10 Oktober 2025
Iberna

Iberna FR ID 33 Manual

10 Oktober 2025
Iberna

Iberna FR ID 29 Manual

10 Oktober 2025
Siemens

Siemens KG39FP08 Manual

10 Oktober 2025
Whirlpool

Whirlpool ART 6600 LH E Manual

10 Oktober 2025
Finlux

Finlux FR-FV1DA0IX Manual

10 Oktober 2025
AEG

AEG NSF5O880ES Manual

9 Oktober 2025
CHiQ

CHiQ CRTM200NB Manual

9 Oktober 2025