Chapin 22251XP Manual

Chapin Ikke kategoriseret 22251XP

Læs gratis den danske manual til Chapin 22251XP (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 53 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 27 anmeldelser. Har du et spørgsmål om Chapin 22251XP, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

018380R0322

6-6136

Hose

Manguera

Tuyau

1. Hose to Tank

Discharge/ Assembly

• Make sure white outlet tube is attached to outlet tube adapter (Fig. 1A).

• Insert the outlet tube portion of the discharge assembly into the tank adapter (Fig. 1B).

• Proper placement of white outlet tube (Fig. 1C).

• Firmly insert the outlet tube adapter into the tank adapter (Fig. 1D) Lining up tab

with notches on the tank adapter.

• Firmly tighten the retaining nut to the tank adapter (Fig. 1E).

Discharge

Assembly

Outlet

Tube

Retaining Nut -

Securely tightened.

Gap

Tank

Adapter

Outlet Tube

Adapter

Tab/

Notch

Outlet Tube

Adapter

Outlet

Tube

Parts, Piezas, Pièces

8. Troubleshooting

Clean Nozzle Assembly (Fig.8A)

Nozzle Cap

301892-4

Shut-off Handle

Mango de cierre

Poignée du robinet

4. Pressurizing and Spraying

Do: Turn handle

clockwise to tighten.

Push handle down,

turn 1/4 turn

counterclockwise to

release.

Do: Pump until you

feel resistance.

Do: Push handle, down,

turn 1/4 turn clockwise to

lock. Begin spraying. Re-

pump sprayer as required

to maintain spray force.

4A4A 4C

4C4C

4B4B

5. To Release Pressure

1) Your sprayer is equipped with a pressure relief/

release valve (Fig. 5A). To release pressure lift

and hold the cap until air is completely exhausted,

OR, turn the valve slowly counterclockwise until

you hear air escaping and wait air is completely

exhausted (Fig. 5B).

2) Do: Stay away from the sprayer until all air has

escaped.

5A5A 5B

5B5B

6. Wand Dock Clip

Choose the holder that ﬁts your wand.

6-4606

Pressure Relief Valve

Válvula de descarga de presión

Soupape de décompression

WARNING: Improper use or failure to follow instructions can result in explosive failure causing

serious eye or other injury. For safe use of this product you must read and follow all instructions. Do

not leave a pressurized sprayer in the hot sun. Heat can cause pressure build-up resulting in possible

explosion. Do not store or leave solution in tank after use. Always wear goggles, gloves, long sleeve

shirt, long pants and full foot protection when spraying. Never use any tool to remove pump if there is

pressure in sprayer. Never stand with face or body over top of tank when pumping or loosening pump

to prevent ejecting pump assembly and/or solution from striking and injuring you. Never pressurize

sprayer by any means other than the original pump. Do not attempt to modify this sprayer. Replace

parts only with manufacturer’s original parts. This sprayer is designed for acidic solutions only.

Never spray ﬂammable, chlorine or bleach, caustic, or other corrosive solutions or heat, pressure,

or gas producing chemicals. Always read and follow chemical manufacturer’s instructions

before use with this sprayer as some chemicals may be hazardous when used with this sprayer.

Sk-1159-1

WARNING

Note: Your particular sprayer may not include all parts pictured above.

Nota: Es posible que este pulverizador en particular no incluya todas las partes que se ilustran arriba.

Remarque : Votre pulvérisateur particulier pourrait ne pas inclure toutes les pièces illustrées plus haut.

Congratulations!

You have just purchased a quality Chapin product.

Call us @ 1-800-950-4458 or www.chapinmfg.com

6-4602

Repair Parts Kit Gaskets and Seals

(not included),

Juego de piezas de reparación,

empaquetaduras y juntas (no incluido)

Kit de pièces de réparation, joints et garniture

d’étanchéité (non inclus)

1) Check tightness of hose nut to be sure hose is securely attached to the tank outlet. Do:

2) Do: Inspect hose for deterioration, cracks, softness, or brittleness. If any of these

conditions are found, replace hose before using. Replace with original manufacturer’s

parts only.

3) Remove pump (see Filling, Pressurizing and Spraying Instructions), inspect interior and Do:

exterior of tank for signs of deterioration of body and bottom. Any sign of deterioration

indicates possible tank weakening and could result in explosive bursting under pressure.

If any of these signs are found, discard tank immediately and replace. Do not attempt to

patch leaks, etc., as this could result in serious injury.

4) Follow Filling, Pressurizing and Spraying Instructions, except use water only Do:

(Pump plunger 10-20 strokes and inspect for leaks).

5) Direct shut-off away from you and open to make sure discharge is not clogged. Do:

6) Do: If unit passes this test, release pressure (see Pressure Releasing Instructions),

empty tank, and proceed with Filling, Pressurizing and Spraying Instructions.

7) Inspect all metal parts including the wand, nozzle and ﬁttings for rust, corrosion Do:

and pitting. If any of these conditions are found, replace affected part with original

manufacturer’s part before using.

1) Turn pump handle counterclockwise and remove pumpDo:

2) Do: Prepare spray solution following all directions and safety warnings on chemical label.

3) Fill tank to no more than the proper gallon marker. Do:

over ﬁll to accommodate pump.Do NOT:

4) Check pump to make sure that no grass or dirt is stuck to barrel. Do:

Replace pump in tank and tighten securely.

7. Care, Storage and Maintenance

Remove nozzle cap by unscrewing. Clean and re-assemble.

P.O. Box 549 700 Ellicott St.

Batavia, NY 14021-0549 U.S.A.

1-800-950-4458 www.chapinmfg.com

2. Pre-Use Check

3. Filling

1) Follow chemical manufacture’s instructions for cleaning. Rinse thoroughly with Do:

recommended solvent. Follow Filling, Pressurizing and Spraying Instructions, except pump

unit only 8-10 strokes. Be sure that the wand and nozzle are thoroughly rinsed after each use.

2) Do: Open shut-off and allow recommended solvent to run through discharge assembly.

3) Release pressure (Follow Pressure Release Instructions), remove pump and empty sprayer. Do:

4) Store sprayer tank upside down, with pump removed, in a warm dry location. Do:

5) Periodically oil pump by dropping 10-12 drops of light oil down pump rod through opening Do:

in cover.

Produkt Specifikationer

Mærke:	Chapin
Kategori:	Ikke kategoriseret
Model:	22251XP

Har du brug for hjælp?

Hvis du har brug for hjælp til Chapin 22251XP stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Chapin Manualer

17 September 2025

27 August 2025

27 August 2025

26 August 2025

26 August 2025

22 Juni 2025

20 Juni 2025

20 Juni 2025

20 Juni 2025

20 Juni 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Brondell LumaWarm L60 Manual

18 December 2025

Vaxcel T0701 Manual

18 December 2025

Bravilor Bonamat Bolero 32 CS Manual

18 December 2025

Foscam SD8EP Manual

18 December 2025

Dals DCP-LWS19 Manual

18 December 2025

Vaxcel T0249 Manual

18 December 2025

TOTO TS110J1 Manual

18 December 2025

ORNO OR-CR-298 Manual

18 December 2025

Wine-Mate WM-4500SSLWC Manual

18 December 2025

Aqprox appLS05HD2D Manual

18 December 2025