Chauvet Rogue R2X Spot Manual

Chauvet lampe Rogue R2X Spot

Læs gratis den danske manual til Chauvet Rogue R2X Spot (16 sider) i kategorien lampe. Denne vejledning er vurderet som hjælpsom af 15 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 8 anmeldelser. Har du et spørgsmål om Chauvet Rogue R2X Spot, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/16

English EN

Español ES

Français FR

Deutsch DE

Nederlands NL

Quick Reference Guide

Model ID: ROGUER2XSPOT

Scan the QR code to

access the product page,

warranty terms, and the

complete User Manual

QUICK REFERENCE GUIDE

Rogue R2X Spot QRG Rev. 1

Safety Notes

These Safety Notes include important information about installation, use, and maintenance of the Rogue R2X Spot .

FCC Compliance

This device complies with Part 15 Part B of the FCC rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s

authority to operate the equipment.

RF Exposure Warning for North America and Australia

Warning! This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This

equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body. This

transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

• The luminaire is intended for professional use only.

• The luminaire should be positioned so that prolonged staring into the luminaire at a distance closer than

12.2 m is not expected.

• If the external flexible cable or cord of this luminaire is damaged, it shall be replaced by a special cord or cord

exclusively available from the manufacturer or its service agent.

• The light source contained in this luminaire shall only be replaced by the manufacturer or its service agent or

a similar qualified person.

• CAUTION:

• This product’s housing may be hot when operating. Mount this product in a location with adequate

ventilation, at least 20 in (50 cm) from adjacent surfaces.

• When transferring the product from extreme temperature environments, (e.g., cold truck to warm humid

ballroom) condensation may form on the internal electronics of the product. To avoid causing a failure,

allow the product to fully acclimate to the surrounding environment before connecting it to power.

• Flashing light is known to trigger epileptic seizures. User must comply with local laws regarding notification

of strobe use.

• ALWAYS:

• Disconnect from power before cleaning the product or replacing the fuse.

• Replace the fuse with the same type and rating.

• Use a safety cable when mounting this product overhead.

• Connect this product to a grounded and protected circuit.

• DO NOT:

• Open this product. It contains no user-serviceable parts.

• Look at the light source when the product is on.

• Leave any flammable material within 50 cm of this product while operating or connected to power.

• Connect this product to a dimmer or rheostat.

• Operate this product if the housing, lenses, or cables appear damaged.

• Operate this product outdoors or in any location where dust, excessive heat, water, or humidity may affect

it (adhere to standards for the published IP rating).

• Submerge this product (adhere to standards for the published IP rating). Regular outdoor operation is fine.

• Permanently install outdoors in locations with extreme environmental conditions. This includes, but is not

limited to:

• Exposure to a marine/saline environment (within 3 miles of a saltwater body of water).

• Locations where normal temperatures exceed the temperature ranges in this manual.

• Locations that are prone to flooding or being buried in snow.

• Other areas where the product will be subject to extreme radiation or caustic substances.

• ONLY use the hanging/mounting bracket to carry this product.

• The maximum ambient temperature is 113 °F (45 °C). Do not operate this product at higher temperatures.

• The minimum startup temperature is -4°F (-20°C). Do not start the product at lower temperatures.

• The minimum ambient temperature is -22°F (-30°C). Do not operate the product at lower temperatures.

• To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely disconnect the

product from power via breaker or by unplugging it.

• In the event of a serious operating problem, stop using immediately.

Produkt Specifikationer

Mærke:	Chauvet
Kategori:	lampe
Model:	Rogue R2X Spot

Har du brug for hjælp?

Hvis du har brug for hjælp til Chauvet Rogue R2X Spot stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

lampe Chauvet Manualer

Chauvet Wash FX Hex ILS Manual

24 Marts 2025

Chauvet SlimPAR T6BT ILS Manual

23 Februar 2025

Chauvet COLORstrip Pix ILS Manual

5 Januar 2025

Chauvet COLORado Solo Bar 1 Manual

4 Januar 2025

Chauvet COLORado Solo Bar 6 Manual

4 Januar 2025

Chauvet Rogue Outcast 1M Beam Manual

4 Januar 2025

Chauvet CoDot ILS Manual

24 December 2024

Chauvet Intimidator Hybrid 251SR Manual

24 December 2024

Chauvet EVE E-160ZQ Manual

24 December 2024

Chauvet Shocker P2 Manual

20 December 2024

lampe Manualer

Nyeste lampe Manualer

NUVO Arabel 60/6967 Manual

4 April 2025

NUVO Gotham 60/191 Manual

4 April 2025

NUVO Cordello 60/7884 Manual

4 April 2025

NUVO Clarksville 60/8061 Manual

4 April 2025

NUVO Gotham 60/190 Manual

4 April 2025

Integral LED ILSTRGBWB028E Manual

4 April 2025

Trust Shyne 25483 Manual

3 April 2025

Trust Vybz GXT 904 Manual

3 April 2025

Schonbek Priscilla BC7106N-48PBZ Manual

2 April 2025

Bresser BR-7RGB Mini Tube Manual

2 April 2025