Cotech LS9A123-2-01 Manual

Cotech Ikke kategoriseret LS9A123-2-01

Læs gratis den danske manual til Cotech LS9A123-2-01 (6 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 26 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 13.5 anmeldelser. Har du et spørgsmål om Cotech LS9A123-2-01, eller vil du spørge andre brugere om produktet?

Side 1/6
Risk of eye damage. Do not look directly at the light source.
The product is not suitable for illuminating a room.
The product is intended for indoor use only.
Class II mains adapter.
Class III strip light
Installation
Information
The LED strip light can be mounted using the double-sided adhesive tape (mounted).
For best adhesion, ensure that the surface is clean, dry and free of grease.
The length of the light strip can be adjusted by cutting it at one of the soldering points
which are spaced every 33 cm along its length.
Note: Once the strip light has been cut and shortened, it is no longer possible to
extend it with additional strip lights.
1. Strip light: Remove the protective film from the tape on the back of the light strip
and attach it to a clean, grease-free surface. The strip light may also be screwed
on with plastic clips.
2. Connectors. Connect the strip light and the control box together.
Note: Make sure the strip light is connected in the right way, with the arrows
pointing towards each other. Otherwise the strip light will not work.
3. IR Receiver.
Note: Make sure there are no obstacles between the IR receiver on the LED
control unit and the remote control.
4. Control unit
5. Connection cable: Connect the connection cable to the LED control unit.
6. Mains adapter: Plug the mains adapter into an electrical outlet.
LED strip light extension set
Art. no: 36-7975 (sold separately)
1. Unplug the adapter from the electrical outlet.
2. Remove the protective film from the tape on the back of the strip light and attach
the strip to a clean, grease-free surface. The strip light may also be screwed on
with plastic clips.
3. Connect the strip lights together with one another.
Note: Make sure the strip light is connected in the right way. Otherwise the strip
light will not work.
Remote control
1. 12 colour tones within the RGB spectrum
2. [ R ] Red light
[ G ] Green light
[ B ] Blue light
[ W ] White light
3. [ ] Increase light intensity
[ ] Decrease light intensity
4. [ OFF ] Turn the strip light off
[ ON ] Turn the strip light on
5. [ FLASH ] Change slowly between all the colours
6. [ STROBE ] Change quickly between all the colours
7. [ FADE ] Change between all the colours, the
colours fade into one another
8. [ SMOOTH ] Change between all colours with no visible transition
Care and maintenance
Unplug the mains lead from the wall socket before cleaning.
The product should be cleaned using a dry cloth or vacuum cleaner.
Responsible disposal
This symbol indicates that the product should not be disposed of with
general household waste. This applies throughout the entire EU. In order
to prevent any harm to the environment or health hazards caused by
incorrect waste disposal, the product must be handed in for recycling
so that the material can be disposed of in a responsible manner. When
recycling your product, take it to your local collection facility or contact the
place of purchase. They will ensure that the product is disposed of in an
environmentally sound manner.
Specifications
Mains adapter
Power supply 230 V AC, 50/60 Hz
Output 24 V DC, 1 A, 24 W
Strip light
36-7974 36-7975
Dimensions Dimensions 6000 x 10 mm 3000x10 mm
Light source Light source 324 xLED 162 xLED
Remote control
Range Max 7 m from straight ahead, 3 m from the sides.
Battery 1 x CR2025 (included)
Extendable RGBW LED Strip Light
Art. no 36-7974 Model LS9A123-1-01
36-7975 LS9A123-2-01
Read the entire instruction manual before use and save it for future reference. We
apologise for any text and picture errors and any changes of technical data. If you have
any questions concerning technical problems please contact our Customer Services.
Safety
Warning:
Neither the product nor its mains adapter may be dismantled or modified in any
way.
Never use the product or the mains adapter if it is in any way damaged or
malfunctioning. Unplug the product immediately if it is damaged.
Do not use the product in environments where explosive or flammable gases are
stored or used.
The product must only be connected to the included mains adapter.
Never connect several or other types of devices to the mains adapter.
The product must not be installed on a wet or electrically conductive surface.
Make sure that the cables are not damaged whilst the product is being installed.
Always unplug the mains adapter from the wall socket when the product is not in
use.
Do not carry the product using the mains lead and do not use it for other
unsuitable purposes.
Never let children play with the product.
The product may be used by persons with reduced physical, sensory or mental
capabilities or persons with a lack of experience or knowledge which could
jeopardise their safety, provided they have been instructed in the safe operation of
the product and understand the hazards involved.
Important
The LEDs cannot be replaced. When the LEDs have reached the end of their
service life, the entire product must be discarded.
This product is intended only for private use.
UNITED KINGDOM CUSTOMER SERVICE tel. 020 8247 9300 e-mail customerservice@clasohlson.co.uk internet www.clasohlson.co.uk
postal Clas Ohlson Ltd, Aquilla House (Firstoor), 1 Becketts Wharf, Lower Teddington Road, Hampton Wick, Kingston Upon Thames, KT1 4ER
Ver. 20200611
5
6
32
14
5
6
7
8
1
2
34
Fjärrkontroll
1. Färgnyanser, 12 nyanser inom RGB-spektrat
2. [ R ] Rött ljus
[ G ] Grönt ljus
[ B ] Blått ljus
[ W ] Vitt ljus
3. [ ] Öka ljusstyrkan
[ ] Minska ljusstyrkan
4. [ OFF ] Släck ljuslisten
[ ON ] Tänd ljuslisten
5. [ FLASH ] Växla långsamt mellan alla färger
6. [ STROBE ] Växla snabbt mellan alla färger
7. [ FADE ] Växla mellan alla färger, tonas in i varandra
8. [ SMOOTH ] Växla mellan alla färger utan synlig övergång
Skötsel och underhåll
Dra ut nätadaptern ur vägguttaget innan rengöring.
Torka av produkten med entorr trasa eller dammsug den vid behov.
Avfallshantering
Denna symbol innebär att produkten inte får kastas tillsammans med
annat hushållsavfall. Detta gäller inom hela EU. För att förebygga eventuell
skada på miljö och hälsa, orsakad av felaktig avfallshantering,ska
produkten lämnas till återvinning så att materialet kan tas omhand
ettansvarsfullt sätt. När du lämnar produkten till återvinning, använd dig
av de returhanteringssystem som finns där du befinner dig eller kontakta
inköpsstället. De kan se till att produkten tas om hand på ettför miljön
tillfredställande sätt.
Specifikationer
Nätenhet
Anslutning 230 V AC, 50/60 Hz
Utgång 24 V DC, 1 A, 24 W
Ljuslist
36-7974 36-7975
Mått Mått 6000×10 mm 3000×10 mm
Ljuskälla Ljuskälla 324×LED 162×LED
Fjärrkontroll
Räckvidd Max 7 m rakt framifrån, 3 m från sidorna.
Batteri 1×CR2025 (medföljer)
Risk för ögonskador! Titta aldrig direkt in iljuskällan.
Produkten lämpar sig inte som rumsbelysning.
Produkten är endast avsedd för inomhusbruk.
Klass II nätadapter.
Klass III-ljusslinga.
Montering
Information
Ljuslisten monteras med dubbelhäftande tejp (monterad).
För bästa vidhäftning, se till att underlaget är rent, torrt och fritt från fett.
Anpassa vid behov ljuslistens längd genom att klippa av den vid någon av lödpunkterna
(var 33:e cm längs ljuslistens längd).
OBS! När ljuslisten har kortats av kan man inte längre bygga ut slingan.
1. Ljuslist: Ta bort skyddsfilmen från tejpen på ljuslistens baksida och tryck fast listen
på en ren fettfri yta. Alternativt kan ljuslisten skruvas fast med plastklämmor.
2. Kontaktstycken. Koppla samman ljuslist och kontrollbox.
OBS! Se till att ljuslisten kopplas in åt rätt håll med pilarna mot varandra. Annars
kommer inte ljuslisten att lysa.
3. IR-mottagare.
OBS! Säkerställ att det inte finns några hinder mellan LED-kontrollens
IR-mottagare och fjärrkontrollen.
4. Kontrollbox
5. Anslutningskabel: Anslut anslutningskabeln till kontrollboxen.
6. Nätadapter: Anslutadaptern iett vägguttag.
Utbyggnadset
Art.nr 36-7975 ( säljs separat)
1. Dra ut nätadaptern ur väggutaget.
2. Ta bort skyddsfilmen från tejpen på ljuslistens baksida och tryck fast listen på en
ren fettfri yta. Alternativt kan ljuslisten skruvas fast med plastklämmor.
3. Koppla samman ljuslisterna med varandra.
OBS! Se till att ljuslisten kopplas in åt rätt håll. Annars kommer inte ljuslisten att
lysa.
5
6
7
8
1
2
34
Utbyggbar LED-list RGBW
Art.nr 36-7974 Modell LS9A123-1-01
36-7975 LS9A123-2-01
Läs igenom hela bruksanvisningen före användning och spara den sedan för framtida
bruk.Vi reserverar oss för ev. text- och bildfel samt ändringar av tekniska data. Vid
tekniska problem eller andra frågor, kontakta vår kundtjänst.
Säkerhet
Varning!
Produkten eller nätadaptern får inte modifieras eller demonteras på något sätt.
Använd aldrig produkten om den eller nätadapterngot sätt är skadade eller inte
fungerar normalt. Dra omedelbart ur stickproppen vid skador.
Använda inte produkten i miljöer där explosiva eller brännbara gaser eller vätskor
förvaras eller används.
Produkten får endast anslutas till medföljande nätadapter.
Anslut aldrig flera eller andra typer av produkter till nätadaptern.
Installera inte produkten på enfuktig eller elektriskt ledande yta.
Se till att kablarna inte skadas när produkten installeras.
När produkten inte annds ska tadaptern alltid vara utdragen ur vägguttaget.
Lyft inte produkten ikabeln och använd inte kabeln till oförenliga ändamål.
Låt aldrig barn leka med produkten.
I Produkten får användas av personer med någon form av funktionsnedsättning,
brist på erfarenhet eller kunskap som skulle kunna äventyra säkerheten, om de
har fått instruktioner om hur produkten på ett säkert sätt ska användas och förstår
faror och risker som kan uppkomma.
Viktigt
Ljuskällorna är inte utbytbara. När ljuskällan har passerat sin livslängd ska hela
produkten kasseras.
Produkten är endast avsedd för privat bruk.
5
6
32
14
Ver. 20200611
SVERIGE • KUNDTJÄNST tel 0247/445 00 e-post kundservice@clasohlson.se
internet www.clasohlson.se brev Clas Ohlson AB, 793 85 INSJÖN


Produkt Specifikationer

Mærke: Cotech
Kategori: Ikke kategoriseret
Model: LS9A123-2-01

Har du brug for hjælp?

Hvis du har brug for hjælp til Cotech LS9A123-2-01 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Cotech Manualer

Cotech

Cotech HT7715 Manual

18 September 2024
Cotech

Cotech K-CPL-LS4W-IR-S3 Manual

16 September 2024
Cotech

Cotech J1x-JF2-210/20 Manual

14 September 2024
Cotech

Cotech TD9511-3 Manual

12 September 2024
Cotech

Cotech S1J-AJ8-10 Manual

31 August 2024
Cotech

Cotech J5218D Manual

27 August 2024
Cotech

Cotech 50053 Manual

27 August 2024
Cotech

Cotech 51097X23 Manual

27 August 2024
Cotech

Cotech 36-6286 Manual

27 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer