DO GUIDE
4. Using the four included 6-32 x 1/4" Phillips head screws,
attach the device to the standoffs.
Inserting the Power Pack
into the Power Pack Holder
To insert the power pack into the power pack holder, do the
following:
1. Slide the power pack into the power pack holder.
2. Using the included 6-32 x 1/2" Phillips pan head screw,
thread the screw through either of the two provided
screw holes to hold the power pack in place.
3. Bundle the excess cable of the power pack into a loop,
and then fasten the bundled cable to the power pack
holder by doing the following:
a. Insert one of the included tie wraps through one of
the tie wrap holes in the power pack holder.
b. Wrap the tie wrap around the bundled cable.
DM-RMC-200-S/DM-RMC-200-S2
DigitalMedia 8G™ Fiber Receiver and Room Controller
DO Install the Device
The Crestron
®
DM-RMC-200-S and DM-RMC-200-S2 mount
onto a 2-gang electrical box using the included support
bracket. The support bracket provides a holder for the included
power pack.
Mounting the Device onto an Electrical Box
To mount the device onto an electrical box, do the following:
1. Attach the four included 6-32 x 1-1/4" standoffs to the
studs of the included support bracket.
2. Using the four included 6-32 x 3/4" combo truss head
screws, attach the included support bracket to the
electrical box.
3. Ground the device and then connect the proper cables to
the bottom of the unit.
DO Check the Box
QTY PRODUCT COLOR PART NUM.
1 Bracket, Support 2047591
2 Connector, 2-Pin 2003574
4 Connector, 2-Pin 2003582
2 Connector, 4-Pin 2003576
1 Connector, 5-Pin 2003577
1 Power Cord, 5' 10" (1.78 m) 2042043
1 Power Pack, 24 Vdc 2.5 A, 100-240 Vac 2045873
1 Screw, 6-32 x 1/2", Pan Head, Phillips Black 2007238
4 Screw, 6-32 x 1/4", Pan Head, Phillips Black 2007215
4 Screw, 6-32 x 3/4", Truss Head, Combo 2009211
4 Standoff, 06-32 x 1-1/4", 1/4" OD, Hex 2007056
2 Tie Wrap, Cable Tie, 15-1/2" x 1" Black 2013608
c. Repeat steps 3a and 3b if necessary using the other
included tie wrap and the remaining tie wrap hole in
the power pack holder.
Installation of the power pack in the holder appears as shown
below.
Tie wrap
hole
Screw
hole*
Tie wrap
hole
Screw
hole*
*Use either screw hole for the included 6-32 x 1/2" Phillips
pan head screw.
Ground
RELAY:
To relay
controllable
devices
AUDIO OUT:
Amplied stereo
audio output
DIG IN:
Software
programmable
digital input
