Digital Watchdog DWC-P336PARAMW Manual


Læs gratis den danske manual til Digital Watchdog DWC-P336PARAMW (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 45 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 23 anmeldelser. Har du et spørgsmål om Digital Watchdog DWC-P336PARAMW, eller vil du spørge andre brugere om produktet?

Side 1/2
DWC-P336PARAMW
Parapet mount bracket for white IP PTZ cameras
Quick Start Guide
Tel: +1 (866) 446-3595 / (813) 888-9555
Technical Support Hours: 9:00AM 8:00PM EST, Monday through Friday
digital-watchdog.com
NOTE: Download all your support materials and tools in one place.
1. Go to: http://www.digital-watchdog.com/resources
2. Search your product by entering the part number in the search bar. Results Search by Product
for applicable part numbers will populate automatically based on the part number you enter.
3. Click Search’. All supported materials, including manuals
and quick start guide (QSGs) will appear in the results.
WHAT’S IN THE BOX
1x Teflon tape 12x hex screws (M10x30)
3x nuts (M6) 12x nuts (M10)
3x wrench screws (M6x30) 12x spring washers (M10)
1x hex Allen wrench (2.5) 12x flat washers (M10)
1x hex Allen wrench (5) 1x quick setup guide
Quick Start Guide
Rev Date: 01/20
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.
INSTALLING THE MOUNTING ACCESSORY
Roof mount installationParapet mount installation
Before the installation
1. The hardware necessary to install the mount depends on your installation
requirements.
2. The mount has pre-drilled holes for use with 3/8-16 (M10) type hardware
(recommended). Use as many of the mounting holes as possible.
3. Multiple fastening positions facilitate mounting flexibility. For a roof or
parapet installation, mount the camera using a minimum of five fasteners
on each side of the mounting plate.
4. Adding a sealant around the bolt holes between the mount and mounting
surface can prevent damage from water leakage
5. Be sure that the mount is installed in a location that can support the load.
All mounting hardware must have a minimum pullout strength of 600 lb
(272 kg) per bolt.
6. When mounting to wood, use screws long enough to penetrate at least
2.5” (64 mm).
7. When mounting to a steel structure, drill holes according to the
mounting pattern.
8. When mounting to masonry or concrete, use lead anchors or expansion
bolts installed according to the manufacturer’s instruction.
9. Run all necessary cabling to the location selected for the installation. Pass
the cables through the mount’s pole and connect to the camera as needed.
Mount hole size: inch (mm)


Produkt Specifikationer

Mærke: Digital Watchdog
Kategori: Ikke kategoriseret
Model: DWC-P336PARAMW

Har du brug for hjælp?

Hvis du har brug for hjælp til Digital Watchdog DWC-P336PARAMW stil et spørgsmål nedenfor, og andre brugere vil svare dig