DPA 4017B Manual

DPA Mikrofon 4017B

Læs gratis den danske manual til DPA 4017B (2 sider) i kategorien Mikrofon. Denne vejledning er vurderet som hjælpsom af 49 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 25 anmeldelser. Har du et spørgsmål om DPA 4017B, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

4017B Shotgun Microphone

A combination of the MMC4017 microphone capsule and the MMP-B

preampliﬁer with ﬁlters, the 4017B Shotgun Microphone is part of the

Pencil Microphone Series

Performance

The supplied calibration chart shows the specially tailored individual

frequency response of the MMC4017 capsule, measured with a linear

MMP-A preamp.

Typical on- and o-axis frequency response of 4017B (MMC4017+MMP-B)

Filters

DPA 4017B features a permanent third-order 50 Hz low cut and two

switchable ﬁlters, which are controlled at the switchable rings. No tools

are needed to activate the ﬁlters, use ﬁngers only.

High boost: a 4 dB boost at 8 kHz.

Low cut: a ﬁrst order (6 dB/oct) bass roll-o below 120 Hz.

Frequency responses of switching ﬁlters on 4017B

dpamicrophones.com/4017

DPI-4017B-QG

Service & repair

If you are not satisﬁed with the characteristics exhibited by this product, please contact your nearest DPA

Microphones representative for support.

Warranty

4017B is covered by a ﬁve-year limited warranty.

CE marking

This product conforms with all relevant directives approved by the European Commission.

20 Hz 50 100 200

500

1 kHz 2 5 10 20 40

-10

-20

-30

0°

30°

60°

90°

140

20 Hz 50 100 200

500

1 kHz 2 5 10 20 40

-10

-20

-30

Without low cut

With high boost +4 dB @ 8 kHz

Without high boost

With low cut

@ 120 Hz

6 dB / oct

Speciﬁcations

Directional pattern

Supercardioid, lobe-shaped

Principle of operation

Pressure gradient, with interference tube

Capsule type

Pre-polarized condenser

Frequency response

20 Hz - 20 kHz, permanent third order high pass ﬁlter at 50 Hz

Eective frequency range, ± 2 dB, at 60 cm (23.6 in)

70 Hz - 18 kHz with typ. 3 dB soft boost at 15 kHz

Sensitivity, nominal, ± 2 dB at 1 kHz

19 mV/Pa, -34.4 dB re 1 V/Pa

Equivalent noise level, A-weighted

Typ. 13 dB(A) re. 20 µPa (max. 15 dB(A))

Switchable attenuator, ﬁlters etc.

High boost: +4 dB at 8 kHz. Low cut: First order ﬁlter, below 120 Hz

Rated output impedance

< 100 Ω

Output balance principle

Signal balanced

Common Mode Rejection Ratio (CMRR)

> 40 dB

Power supply (for full performance)

P48 (Phantom Power)

Current consumption

4.5 mA

Polarity

+V at Pin 2 for positive sound pressure

Connector

XLR-3M. Pin 1: Shield, Pin 2: signal + phase, Pin 3: signal – phase

Weight

68 g (2.4 oz)

Operating temperature range

-40 °C to 45 °C (-40 °F to 113 °F)

Relative humidity

Up to 90%

Produkt Specifikationer

Mærke:	DPA
Kategori:	Mikrofon
Model:	4017B

Har du brug for hjælp?

Hvis du har brug for hjælp til DPA 4017B stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Mikrofon DPA Manualer

DPA d:mension 5100 Manual

8 December 2024

DPA 6061 Manual

14 September 2024

DPA d:screet 4061 Manual

9 September 2024

4 September 2024

4 September 2024

4 September 2024

28 August 2024

DPA 4560 CORE Binaural Manual

1 August 2024

DPA 4560 CORE Manual

31 Juli 2024

DPA D:screet 60 Manual

29 Juli 2024

Mikrofon Manualer

Nyeste Mikrofon Manualer

Rane GM 16 Manual

15 Juni 2025

Kogan KAGMICBOMLA Manual

15 Juni 2025

Omnitronic UHF-601 Manual

14 Juni 2025

Omnitronic UHF-604 Manual

14 Juni 2025

Omnitronic UHF-602 Manual

14 Juni 2025

Neewer VM11 Manual

14 Juni 2025

Neewer KM23 Manual

13 Juni 2025

AmpliVox S1695 Manual

13 Juni 2025

Comica BooMax Manual

12 Juni 2025

DNA UWM 1 Manual

9 Juni 2025