
Das USB zu RS 485 Kabel mit A Stecker stellt einen seriellen RS 485 Ausgang für PC, - - -
Workstation oder Server über den USB 1.1, 2.0 oder 3.2 Bus zur Verfügung. Durch die einfache
Installation muss der Rechner nicht geöffnet werden und das EX 13009 kann bei laufendem -
Betrieb installiert werden. Damit ist es ideal für kurzfristig aufgebaute RS 485 Installationen und -
z.B. im Servicekoffer von Systembetreuern.
Kompatibilität: USB 1.1, 2.0 & 3.2
Betriebssysteme: Windows 9.x / ME / 2000 / XP / Vista / 7 / 8.x / 10 / 11 / Server 20xx/
Anschlüsse: 1x USB 2.0 A Stecker, 1x 3 Pin seriell RS 485 Terminal Block - -
BESCHREIBUNG & TECHNISCHE DATEN
ANSCHLÜSSE & STATUS LED S‘
3 Pin Terminal Block seriell RS-485
RS- - 485 Anschlussbelegung 2 Draht:
CONNECTORS & STATUS LED S‘
Because there are large differences between PC’s, we can give you only a general installation
guide for the EX-13009. Please refer your computers reference manual whenever in doubt.
1. - - Connect the EX 13009 USB to the USB A Port at the your PC.
2. When you are ready you can start your PC and continue with the point Driver Installation„ “.
After the hardware installation Windows will recognize the device automatically and install the
drivers. If the driver shoul not be installed automatically, please download the driver from our
homepage (www.exsys.de / www.exsys.ch) first. Now select the folder with your operating
system and install the driver. Follow the hardware assistant and finish the installation.
Important! Restart your PC in any case after installing the drivers.
Open the . Now you should see at >Device manager< „Ports (COM & LPT) USB“ and „-
Controller “the following new entry:
If you see this or a similar information the device is installed correctly.
To clean the unit, use only a dry, lint free cloth and apply light pressure to remove dirt. Be -
careful not to leave any fibres of the cloth in the connector area.
Never use a damp or wet cloth for cleaning!
Kabelquerschnitt: 20 AWG / 0.75 mm 26-