Gamber-Johnson 7160-1425 Manual

Gamber-Johnson Ikke kategoriseret 7160-1425

Læs gratis den danske manual til Gamber-Johnson 7160-1425 (3 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 20 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 10.5 anmeldelser. Har du et spørgsmål om Gamber-Johnson 7160-1425, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/3

cab mount top plate

overhead guard bars

Revision

If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868

Form Product

INSTALLATION INSTRUCTIONS

Product Mounting Disclaimer

Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage

of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson

products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brake lines, electrical, drive train or other systems), air-bags and other safety equipment is

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with original vehicle manufactures specifications

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

clevis

cab mount bottom plate

1" carriage bolts

3-1/2" carriage bolts

7160-1425

PS-001

CAB OVERHEAD GUARD MOUNT

Rev B

Printing Spec:

INST-936

located.

Attaching the mount when there is

a minimum 1/2" clearance between

the cab roof and the overhead

guard bars:

1. Attach the clevis portion of the

mount to the cab mount bottom plate

with the (4) 3/8 x 1" carriage bolts

and serrated flange nuts found in

hardware bag 7120-0932. There are

multiple mounting locations, so pick

the one that best fits your application.

2. Loosely attach the (2) 3/8 x 3-1/2"

carriage bolts and serrated flange

nuts into the long slot of the bottom

plate as shown.

3. Place the cab mount top plate on

top of the overhead bars (between

the bars and the roof glass) in the

approx. location the mount will be

1/1

This instruction sheet is for the Gamber-Johnson Cab Overhead Guard Mount

(7160-1425). It is designed to mount a computer cradle or docking station near the

roof of an enclosed cab forklift. There are 2 ways to mount it based on how close

the roof is to the overhead guard bars.

Attaching the mount:

4. Insert the heads of the 3/8" x

3-1/2" carriage blots through the

keyhole opening in the top plate

and slide the carriage bolts

outward so they are next to the

overhead guard vertical bars.

Fine tune the position of the

mount in the vehicle and tighten

the nuts on the 3/8 x 3-1/2"

carriage bolts to hold the mount

in place.

keyhole opening

Produkt Specifikationer

Mærke:	Gamber-Johnson
Kategori:	Ikke kategoriseret
Model:	7160-1425
Type:	Passiv holder
Bredde:	139.7 mm
Dybde:	311.2 mm
Højde:	279.4 mm
Vægt:	4580 g
Produktfarve:	Sort
VESA montering:	Ja
Materiale:	Stål
Normal brug:	Bil
Indbygget oplader:	Ingen