GE GXWH30C Manual

GE Vandfilter GXWH30C

Læs gratis den danske manual til GE GXWH30C (12 sider) i kategorien Vandfilter. Denne vejledning er vurderet som hjælpsom af 9 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 5 anmeldelser. Har du et spørgsmål om GE GXWH30C, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/12
REQUIRED TOOLS AND ACCESSORIES
FOR INSTALLATION
■2 Adjustable wrenches
■Pipe cutter or hacksaw
■File
■Emery paper
■Screwdriver
■Additional installation parts may be required:
•2 fittings to connect household plumbing to 1
″
female
NPT threads on filter housing. Installation Kit available
to connect to 3/4
″
copper plumbing:
– GE Part/Retail Part (HDKIT)
(Not performance tested or certified by NSF.)
•UL Approved grounding clamps and 6-gauge copper
grounding wire—Installation Kit available:
– GE Part/Retail Part (HDKIT)
(Not performance tested or certified by NSF.)
•Mounting Bracket (HDBRKT)
•Teflon Tape
•Sump Wrench
– Retail Part (HDWRNCH)
– GE Parts (WX5X3002)
Optional accessories are available (Visa, MasterCard or Discover cards
accepted) by visiting our Website at www.GEAppliances.com or from
Parts and Accessories, call 800.626.2002 (U.S.) or 800.663.6060 (Canada).
CONTENTS INCLUDED WITH PRODUCT
■Filter housing and head
■Product literature
1
GE Smar tWater ™
INSTALLATION INSTRUCTIONS
Heavy Duty Water Filtration System—GXWH30C (filters not included)
SAFETY PRECAUTIONS
■Check with your state and local public works department
for plumbing and sanitation codes. You must follow these
guidelines as you install the Heavy Duty Water Filtration
System. Using a qualified installer is recommended.
■
Be sure the water supply conforms with the Performance
Data. If the water supply conditions are unknown, contact
your municipal water company
.
WARNING: Do not use with water that is
microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
■I
t is highly recommended that a water shut-off valve be
placed directly upstream of your household filter.
■
Check with your local public works department for plumbing
codes. You must follow their guides as you install the
Heavy Duty Water Filtration System.
■
Use the Heavy Duty Water Filtration System on a potable,
safe-to-drink, home COLD water supply only. The filter
cartridge will not purify water or make unsafe water safe
to drink. DO NOT use on HOT water (100
°
F max).
■
Protect the Heavy Duty Water Filtration System and piping
from freezing. Water freezing in the system will damage it.
■
Your Heavy Duty Water Filtration System will withstand up to
100 psi water pressure. If your house water supply pressure
is higher than 100 psi during the day (it may reach higher
levels at night), install a pressure reducing valve before the
system is installed.
■
Do not install on HOT WATER. The temperature of the
water supply to the Heavy Duty Water Filtration System
must be between the minimum of 40
°F. and the maximum
of
1
00°F
. See the
Performance Data
section
.
■
Do not install the Heavy Duty Water Filtration System using
copper solder fittings. The heat from the soldering process
will damage the unit.
WARNING: Discard all unused parts and
packaging material after installation. Small parts
remaining after installation could be a choke hazard.
■
Do not install filter in an outside location or anywhere it
will be exposed to sunlight.
PROPER INSTALLATION
This Heavy Duty Water Filtration System must be properly installed and located in accordance with the Installation Instructions
before it is used.
GXWH30C is
Tested and Certified by NSF International
against ANSI/NSF
Standard 42 with Cartridge FXHTC
for the reduction of Chlorine: Taste and Odor.
251B6021P002 49-50048-6 145287 Rev. D(03-02 JR)
www.GEAppliances.com
GENERAL ELECTRIC COMPANY, Appliance Park, Louisville, KY 40225
2
CARTRIDGE SPECIFICATIONS
Filter Cartridge Replacement
You should change your filter when the water flow is noticeably reduced or at least every three months.
Influent Challenge Reduction Average
Substance Concentration Requirements Reduction
Standard 42
Chlorine 2.0 mg/L ± ≥10% 50% 95.5%
Turn off water to filter. Water must be shut off
from an upstream valve.
Press the red pressure release button to release
pressure.
Unscrew the filter canister and discard used
filter. Wash the filter canister with mild soap
and water. Do not use harsh cleaners or hot
water.
Inspect the filter canister O-ring. Make sure
it is lightly lubricated and completely seated
in the groove. It is recommended that you
replace the O-ring if it is damaged.
Place a new filter cartridge into the canister,
making sure it is centered and completely
seated on the bottom seal.
Reinstall the filter canister to the unit. Hand
tightening is all that is required to seal the
unit. DO NOT OVERTIGHTEN.
Slowly turn on water to the filter by using the
upstream shut-off valve.
Press the red pressure release button to
remove trapped air.
After installation, flush the cartridge for
10 minutes, wait one hour, then flush again
for 10 minutes before using the water.
9
8
7
6
5
4
3
2
1
Installation Overview
NOTE: Be sure to allow a minimum space
of 11⁄ –22″ ″ under the filter for removing
the sump to change the cartridge.
Turn sump wrench tool
clockwise to remove
Sump
Turn
clockwise
to remove
canister
Turn
counterclockwise
to tighten
Red pressure
release button
Filter
cartridge O-ring seal
Filter canister
Head
Performance Data
This system has been tested according to ANSI/NSF 42
for the reduction of the substances listed below. The
concentration of the indicated substances in water
entering the system was reduced to a concentration
less than or equal to the permissible limit for water
leaving the system, as specified in ANSI/NSF 42.
STEP-BY-STEP INSTALLATION INSTRUCTIONS
Recommended
shut-off valve
Recommended
shut-off valve
Adapter
Ferrule
Hex nut
Adapter
Ferrule
Hex nut
11⁄2″–2″
Typical installation
FXHTC Cartridge
Test Conditions
Flow Rate: 3 gpm (11.4 Lpm)
pH: 7.5 ±1
Inlet Pressure: 60 PSI (4.1 bar)
Temperature: 68°F ± 5°F (19.8°C ± 2.5°C)
Operating Requirements
Pressure: 30–100 PSI (2.1–6.9 bar)
Turbidity: 5 NTU Max.
Temperature: 40°F–100°F (4.4°C–37.7°C)
Capacity: 5,000 gallons (18,927L) or 3 months
Testing was performed under standard laboratory conditions, actual performance may vary.

Produkt Specifikationer

Mærke: GE
Kategori: Vandfilter
Model: GXWH30C

Har du brug for hjælp?

Hvis du har brug for hjælp til GE GXWH30C stil et spørgsmål nedenfor, og andre brugere vil svare dig


Vandfilter GE Manualer

GE

GE GXRLQK Manual

21 Februar 2025
GE

GE Profile PNRQ15RBL Manual

9 December 2024
GE

GE GX1S15C Manual

13 Oktober 2024
GE

GE GXSF18G Manual

2 September 2024
GE

GE Profile PNRQ20FBB Manual

2 August 2024
GE

GE GX1S01C Manual

2 August 2024
GE

GE GNWH38S Manual

31 Juli 2024
GE

GE Profile PXCR33KSSDM Manual

29 Juli 2024
GE

GE GXCF03KWW Manual

25 Juli 2024
GE

GE Profile PXCR33KSS Manual

25 Juli 2024

Vandfilter Manualer

Nyeste Vandfilter Manualer

Manitowoc

Manitowoc AR-40000-P Manual

15 Juni 2025
Manitowoc

Manitowoc AR-20000-P Manual

15 Juni 2025
Scotsman

Scotsman SSM2-P Manual

14 Juni 2025
Scotsman

Scotsman SSM3-P Manual

14 Juni 2025
Emga

Emga 340001 Manual

31 Marts 2025
Everpure

Everpure H-1200 Manual

21 Februar 2025
Philips

Philips AWP1812 Manual

7 Februar 2025
Oase

Oase AquaSkim 20 Manual

3 Februar 2025
Seagull

Seagull IV X-1F Manual

16 Januar 2025
AstralPool

AstralPool Oslo Manual

11 Januar 2025