INSTALLATION INSTRUCTIONS
C-DMM-123
2013-2017 FORD INTERCEPTOR UTILITY
SWING-OUT DASH MONITOR MOUNT
Always!
Read all instructions before installing any Havis, Inc. products.
Check for obstructions (Wires, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
The Dash Monitor Mount bracket system requires two or three main parts that are sold
separately. See web site Monitor Congurator for more detailed bracket informaon.
hp://www.havis.com/monitor_mounts.htm
1 123)- Vehicle Specic dash mount bracket. (C-DMM-
1 - Computer Specic Monitor adaptor bracket. (C- -200 series) MM
1 - Oset adaptor bracket. (C- -301) MM
The C- -301 oset adaptor goes between the C-DMM-123 and C- -2XX. MM MM
It may not be required in some applicaons.
Docking staons for tablet applicaons can be bolted directly to C-DMM without adaptor. Oset
adaptor C- -303 is available if addional posioning opons are desired for docking staon.MM
TOOLS REQUIRED:
• Ratchet Wrench Air Saw or Plasc cung tool
• Socket Set Dash panel removal tool
• Open End Wrench 7/16”- File
• Phillips Screwdriver
HARDWARE and PARTS:
QTY: DESCRIPTION: PART #:
1 Upper Support Bracket Driver Side CM004263
1 Upper Support Bracket Passenger Side CM004264
1 Lower Support Bracket Driver Side CM004265
1 Lower Support Bracket Passenger Side CM004266
4 1/4" Serrated Flange Hex Nut GSM30023
4 # 10 x 1/2" Phillips Pan head machine screw GSM33118
4 # 10 Star Washer GSM31034
Note: The swing door ulizes a gas spring to assist in opening the door and to eliminate the possibility of it
slamming shut. If addional damping is desired because of heavier equipment, an oponal stronger gas spring is
available under Part Number CM86662-30 (sold separately)
Installer must change out gas spring as needed