Hoselink 3005 Manual

Hoselink Haveslange 3005

Læs gratis den danske manual til Hoselink 3005 (2 sider) i kategorien Haveslange. Denne vejledning er vurderet som hjælpsom af 56 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 28.5 anmeldelser. Har du et spørgsmål om Hoselink 3005, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

MANUAL WIND HOSE REEL

INSTRUCTION MANUAL

1. INTRODUCTION

This high quality manual wind hose reel is manufactured from steel with a powder coating. It is a durable and practical hose storage solution.

This reel has been especially manufactured with a high level coating. However, given the varying conditions it will be used under, the

warranty does not cover the unit for rust or deterioration of the coating. The 12 month warranty covers the working of the unit and

construction of the frame.

This hose reel will take a maximum length of 30m of garden hose. To complete the set up of this product, we recommend you purchase (or

use) the following additional products, sold separately:

• Outback, Ned Kelly or Tradie’s Choice Starter Kit

• 18m or 30m Profirm or Premiumflex hose

• Tap to Hose Connector (Product Code: 2310)

This reel can be mounted vertically to a post or wall, or horizontally “on ground” to a floor, path or driveway, etc. See Fig. 1.

The operation of the reel, if mounted to a post, or wall, can be enhanced by installing a Hose Guide (supplied).

2. SE TTING UP AN D M OUNTIN G TH E H OSE R EEL

For optimum use, we recommend mounting the reel to a wall or post, or securing it to the ground.

To use this reel, it requires a short length of hose to go from the tap to the hose reel, called the “Leader hose”. This can be any length of hose

you may already have, or it can be cut from your hose. When cutting any hose, ensure it is cut straight (not angled or jagged). Sharp

secateurs are the best tool for this task.

There are 4 hose connection points (see Fig. 2)

A. At the tap

B. To the outside of the reel (from the tap)

C. To the inside of the reel

D. At the spray end

1. Connect the Starter Kit as per supplied Fitting Instructions, to Connection Point A (at the tap from the leader hose) and Connection

Point D (spray end of the hose).

2. Using the additional Tap to Hose Connector screw the Tap Connector direct onto Connection Point B. Install the hose connector to

the other end of the leader hose as per Fitting Instructions. See Fig. 3.

3. Feed the long hose length through the inside of the drum to Connection Point C. You will need to soften the end of the hose in hot

water, slide the supplied jubilee clip over the end of the hose, then push the hose onto the barbed stem. Tighten the jubilee clip

with a screwdriver, taking care to ensure the screwdriver does not slip off and cause injury. See Fig. 4.

4. When securing the hose reel to a wall or a post, ensure the leader hose is long enough to reach from the tap to the reel. The Top

mounting hole should be about 1200mm above the ground (or a convenient height for you to wind the handle). If the hose reel

needs to be mounted further from the tap, an extra length of hose can be added using a Hoselink Hose Joiner Set (Product Code:

2410).

5. The hose reel has 2 holes by which to secure it, and the necessary screws are enclosed together with plastic plugs for installing to a

masonry wall. We recommend using the hose reel as a template to mark the holes prior to drilling. Use a spirit level to ensure the

holes are vertically aligned. When drilling, use a 5.5mm drill bit for the plugs (orange spaghetti).

6. If you want the reel to be REMOVABLE, drill holes to coincide with the top of the slotted bracket holes. If you want it permanently

installed, the top hole should coincide with the top of the slotted bracket hole and the bottom hole with the bottom of the slotted

bracket.

7. Now you can connect the leader hose between the tap and the reel, and roll up the hose. You are ready to use your Hoselink reel!

3. CARE AN D M AINTE N ANC E

We recommend that the hose is fed through the supplied Hose Guide, when being rolled or pulled out. To prolong the life of your hose, we

recommend that you store it out of direct sunlight where possible. To clean the hose reel, simply wipe with a damp cloth. Do not use

abrasive cleaners. Keep lubricated where the handle is retained by the flat bracket.

4. IMAGES

Fig. 1. Recommended set up with hose guide Fig. 2. Diagram shows Connection Points A, B, C, D, and leader hose

Fig. 3. Outside connection of hose reel connection Fig 4. Inside connection of hose reel connection

For more exciting garden products visit or call 02 9939 4171 to request a catalogue. w w w. h o s e l i n k . c o m . a u

Hose-Pro International Pty Ltd. Tel: 02 9939 4171

Unit 8, 106 Old Pittwater Road Web: w w w. h o s e l i n k .c o m .a u

Brookvale, NSW 2100 Email: h o s e l i n k @ho s e l i n k. c o m .a u

Now Australia’s most preferred and trusted garden hose fittings,

hoses, hose reels and garden products.

Produkt Specifikationer

Mærke:	Hoselink
Kategori:	Haveslange
Model:	3005

Har du brug for hjælp?

Hvis du har brug for hjælp til Hoselink 3005 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Haveslange Hoselink Manualer

Hoselink 3315 Manual

9 September 2025

Hoselink Evolve Manual

20 Juni 2025

30 Juli 2024

30 Juli 2024

30 Juli 2024

30 Juli 2024

Hoselink 5642-WG Manual

30 Juli 2024

Haveslange Manualer

Nyeste Haveslange Manualer

Draper 10000 Manual

23 September 2025

Coxreels PC13-5012 Manual

17 September 2025

Reelcraft DP7850 OMP Manual

16 September 2025

Reelcraft F7925 OLP Manual

16 September 2025

Hozelock AutoReel Mobile 35m Manual

11 September 2025

Hillvert HT-LOUIS 30 Manual

3 September 2025

Hillvert HT-LOUIS 10 Manual

2 September 2025

Hillvert HT-LOUIS 20 Manual

2 September 2025

Reelcraft RT450-OLP Manual

28 August 2025

Reelcraft RT605-OLP Manual

28 August 2025