Hoselink Evolve Manual

Hoselink Haveslange Evolve

Læs gratis den danske manual til Hoselink Evolve (2 sider) i kategorien Haveslange. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 4.0 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om Hoselink Evolve, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Retractable Hose Reel

I N S T R U C T I O N M A N UA L

I N S TA L L AT I O N

Bracket into Masonry

1 Use the bracket as a template to

mark all four holes with a pencil,

using a spirit level to ensure it

is straight.

2 Drill holes 50mm deep using

a 10mm masonry drill bit.

TIP: Use sticky tape around the

drill bit to mark 50mm depth.

Be sure to set the drill to the

‘Hammer’ setting.

3 Hammer the plugs into each hole.

4 Set the bracket in place, then

use the supplied 200mm Phillips

Head drill bit to loosely screw in

each screw.

5 Once all are in place, tighten

each screw.

For speciﬁc instructions on all

surface types, visit the Product

Support page at hoselink.com.au.

Bracket into Timber

1 Use the bracket as a template

to mark all four holes with a

pencil, using a spirit level to

ensure it is straight.

2 Drill four holes 50mm deep using

a 5mm drill bit.

TIP: Use sticky tape around the

drill bit to mark 50mm depth.

3 Set the bracket in place, then

use the supplied 200mm Phillips

Head drill bit to loosely screw in

each screw (plugs not required).

4 Once all are in place, tighten

each screw.

C O M P L E T E S E T U P

Place Hose Reel

onto the Bracket

C O M P L E T E S E T U P

Attach Stopper Ball

Troubleshooting

Visit the Product Support

section on our website

or scan the QR code for

more information.

2 Open the stopper ball

lever from the side

closest to the ‘K’.

3 Put the stopper ball

approximately 20cm

behind the connector.

Push with your palm

from the ‘H’ side to

latch the lever.

Connector and

Sprayer Assembly

1 Push the Hose Connector with

Flow Control Body onto the end

of the main hose. Secure by tightly

screwing in the pre-attached nut.

2 Screw the Accessory Connector

with Swivel into the Sprayer.

3 Attach the sprayer to the main hose.

To join Hoselink ﬁttings, hold a ﬁtting

in each hand, line up the lugs and use

a point and twist motion to connect.

4 Screw the Universal Tap

Connector onto your outdoor tap.

If the connector appears too small,

unscrew the size reducer and

screw the main connector body

onto the tap.

5 Connect the 2m Leader Hose onto

the Universal Tap Connector with the

same point and twist action.

1 4

Tilt the reel at an angle over

the top post rst to attach, then

level the reel to slide it onto the

bottom post. Do this in reverse

to remove it.

T I P

Complete this step without water

pressure in the hose.

1 Pull the hose out about half

a metre and lock the length.

If this is too difcult, extend

the hose to the ground. Put

your foot on the ‘H’ side and

roll the ball forward to latch

the lever.

T I P

R E A DY T O U S E

Specications

Model Hose Length Weight Weight Max working

with water pressure

E10020B 20m Internal 12.35kg 13.85kg 150psi

E10020C Hose + 2m

Leader Hose

E10030B 30m Internal 14.80kg 17.90kg 150psi

E10030C Hose + 2m

Leader Hose

Using the Hose Reel

1 To use the hose, simply pull it out to the

desired length. The hose will retract slightly

and lock at that length.

2 To commence retraction, gently pull the

hose to unlock, then allow it to retract

automatically as you walk it back in.

3 Always fully retract the hose after use.

Masonry

Installation

Size

Reducer

Choose a Suitable

Location

The bracket must be mounted

to a solid surface, such as brick or

timber, to support the reel’s weight

during use. A shaded position,

if possible, is recommended to

prolong the life of the product.

For optimal performance of the

hose reel, install the bracket at

least 1m away from the corner

of a building.

I N S TA L L AT I O N

If you have an existing Hoselink

Classic Retractable Reel

installed, you can use the same

screw holes for mounting the

Evolve Hose Reel bracket. Please

note that the existing screw holes

and plugs can be used, but we

recommend using the supplied

Evolve hardware for mounting the

new bracket to ensure stability.

Up to 1.5m between

the bracket and tap

Recommended 850mm

from ground height

T I P

C O N TAC T U S

1300 900 617

hello@hoselink.com.au

Live Chat at hoselink.com.au

C AU T I O N

• The hose reel is not intended for

commercial use, as a drinking water

source or with hot water.

• The hose reel must be mounted

on the supplied wall bracket or

Hoselink’s Mounting Post before

use.

• Do not let the hose retract

unassisted, always walk the hose

back into the reel.

• Do not use harsh chemicals

to clean the hose reel or hose.

• Do not submerge hose reel in water.

• Do not allow children to use or play

with the hose reel.

• Do not unscrew the hose reel

case. It contains a tensioned spring

that is dangerous if released.

• Turn o the water at the tap and

release pressure from the spray

end when the reel will not be in use

for prolonged periods.

• During winter, in frost-prone

areas, release water pressure from

the spray end, disconnect from the

water source and store the hose

reel inside.

Warranty

Hoselink warrants that this product will be free from defects in workmanship and materials that result in failure during

normal usage, from the date of purchase as follows: 5 years on the Hose Reel unit including the hose, 2 years on the

Hose Connectors and Comfort 8-Pattern Flow Control Sprayer. The warranty does not cover misuse, unauthorised

modiﬁcations, general wear and tear, or external causes such as acts of nature.

For all warranty claims, please contact our Customer Care Team in the ﬁrst instance. A photo or video may be

requested to assist with assessing your claim. If a Hoselink product is defective, we will provide a repair or oer you

a replacement or refund.

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a

replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You

are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure

does not amount to a major failure.

Read this manual before installation and use.

Installation

See reverse side for

installation instructions

or scan the QR code

to watch an installation

video.

Congratulations

on purchasing Hoselink’s

latest innovation, the Evolve

Retractable Hose Reel!

We take pride in our commitment

to bring manufacturing to

Australia, and we’re thrilled

to share that we craft this

retractable hose reel unit in the

heart of Sydney, sourcing select

components internationally,

such as the hose and sprayer.

Designed with a modern, sleek

look to complement your home,

this hose reel has been

engineered with durability in

mind, ensuring years of reliable

service. Plus, many components,

including the hose itself, are

now replaceable for your peace

of mind.

We hope you enjoy using

your new Evolve Hose Reel

to help your garden ﬂourish!

1 x Hose Reel with

2m Leader Hose

1 x Wall Bracket

1 x Stopper Ball

1 x Comfort 8-Pattern

Flow Control Sprayer

1 x Universal Tap

Connector

1 x Accessory Connector

with Swivel

1 x Hose Connector with

Flow Control Body

1 x Mounting Hardware

(4 x Screws,

4 x Masonry Plugs)

1 x 200mm Phillips Head

Drill Bit

Tools required

B OX CO N T E N T S

Hose Connector

with Flow

Control Body

Universal Tap

Connector

Hose End

Connector

2m Leader Hose

Bracket

Hose Reel Unit

Screws

Masonry

Plugs

Comfort

8-Pattern Flow

Control Sprayer

Electric Drill

5mm Timber Drill Bit OR

10mm Masonry Drill Bit

Pencil

Level

Tape Measure

Stopper Ball

Accessory

Connector

with Swivel

200mm

Phillips

Head

Drill Bit

Produkt Specifikationer

Mærke:	Hoselink
Kategori:	Haveslange
Model:	Evolve

Har du brug for hjælp?

Hvis du har brug for hjælp til Hoselink Evolve stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Haveslange Hoselink Manualer

Hoselink 3315 Manual

9 September 2025

Hoselink Evolve Manual

20 Juni 2025

30 Juli 2024

30 Juli 2024

30 Juli 2024

30 Juli 2024

Hoselink 5642-WG Manual

30 Juli 2024

Haveslange Manualer

Nyeste Haveslange Manualer

Draper 10000 Manual

23 September 2025

Coxreels PC13-5012 Manual

17 September 2025

Reelcraft DP7850 OMP Manual

16 September 2025

Reelcraft F7925 OLP Manual

16 September 2025

Hozelock AutoReel Mobile 35m Manual

11 September 2025

Hillvert HT-LOUIS 30 Manual

3 September 2025

Hillvert HT-LOUIS 10 Manual

2 September 2025

Hillvert HT-LOUIS 20 Manual

2 September 2025

Reelcraft RT450-OLP Manual

28 August 2025

Reelcraft RT605-OLP Manual

28 August 2025