Icom HM-162E Manual

Icom Modtager HM-162E

Læs gratis den danske manual til Icom HM-162E (8 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 54 personer og har en gennemsnitlig bedømmelse på 3.6 stjerner ud af 27.5 anmeldelser. Har du et spørgsmål om Icom HM-162E, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

INSTRUCTIONS

REMOTE-CONTROL MICROPHONE

HM-162E

Thank you for purchasing the HM-162E

REMOTE

CONTROL MICROPHONE

. The COMMANDMIC IIITM is a

remote control microphone for use with the IC-M603

or else.

Please read the connected transceiver’s instruction

manual carefully before installation and operation.

These instructions are just described the remote-

control operations only.

qBUSY/TRANSMIT INDICATOR

➥ “B

BBU

UUS

SSY

YY” appears when receiving a signal or when the

squelch opens.

➥ “T

TTX

XX” appears while transmitting.

wRX SPEAKER INDICATOR

Appears during the RX speaker mode.

eSCRAMBLER INDICATOR

“S

SSC

CCR

RRA

AAM

MM” appears when an optional voice scrambler is acti-

vated.

rSCAN INDICATOR

➥“

PPR

RRI

II-

--S

SSC

CCA

AAN

116

” appears during Priority scan; “ N

NNO

OOR

RR-

MMA

AAL

SSC

CCA

AAN

NN” appears during Normal scan.

➥“

DDU

UUA

AAL

116

66” appears during dualwatch; “

TTR

RRI

116

66” ap-

pears during tri-watch.

tSELECTOR STATUS INDICATOR

Indicates the active status;[SELECTOR]

“[

[

[[V

VVO

OOL

LL]

]

]] ” appears when [SELECTOR] functions as the

audio volume.

“[

[

[[S

SSQ

QQL

LL]

]

]] ” appears when [SELECTOR] functions as the

noise squelch controller.

“[

[

[[D

DDI

IIA

AAL

LL]

]

]] ” appears when [SELECTOR] functions as the

channel selector.

yPOSITION INDICATOR

➥ Shows the GPS position data.

• “?

???

??” may blink every 2 sec. instead of position data when

the GPS position data is invalid. In this case, the last position

data is held for up to 23.5 hours.

• “?

???

??” may blink every 2 sec. instead of position data 4 hours

after the position data is input manually, up until 23.5 hours

have past.

➥ “

iit

tti

iio

oon

” appears when no GPS receiver is con-

nected and no position data is input manually.

uTIME ZONE INDICATOR

➥ “L

LLo

ooc

cca

aal

ll” appears when the offset time data in the ‘Set

up’ menu is entered.

➥ “N

TTi

iim

mme

ee” appears when no GPS receiver is connected

and no time data is input manually.

iCHANNEL COMMENT INDICATOR

Channel comment appears, if programmed.

oCHANNEL NUMBER READOUT

Indicates the selected operating channel number.

!0 KEY LOCK INDICATOR

➥Appears while the Key Lock function is in use.

➥ Blinks while the All Key Lock function is in use.

!1 LOW BATTERY INDICATOR

“ ” blinks when the battery voltage drops to approx. 10 V

DC or below.

!2 CALL CHANNEL INDICATOR

“C

CCA

AAL

LLL

LL” appears when the call channel is selected.

!3 CHANNEL GROUP INDICATOR

Indicates whether an International “ I

IIN

NNT

TT,” U.S.A. “U

SSA

AA,”

DSC “D

DDS

SSC

CC” or ATIS “A

AAT

TTI

IIS

” channel is selected.

• Depending on the connected transceiver’s version.

!4 DUPLEX INDICATOR

Appears when a duplex channel is selected.

• Duplex channel has a different TX and RX frequency.

!5 TAG CHANNEL INDICATOR

Appears when a tag channel is selected.

!6 POWER INDICATOR

➥“2

225

55W

WW” appears when high power is selected.

➥“1

11W

WW” appears when low power is selected.

BUSY

BUSYBUSY

25W

25W25W

---

------

INT

INTINT---

---

------CALL

CALL

CALLCALL

LOC-

LOC-LOC-

-- -- DUP

DUP

DUPDUP

SCRAM

SCRAMSCRAM

----TAG

TAG

TAGTAG

NORMAL

NORMALNORMAL

--SCAN

SCAN

SCANSCAN

--34

3434

°°

34.506N

34.506N34.506N

123

123123

°°

23.236W

23.236W23.236W

Local

LocalLocal

----

1:10

1:101:10

- - CALLING

CALLING

CALLINGCALLING

RXRX

[VOL]

[VOL][VOL]

!6 !4!5 !3 !2

Accessories included with the HM-162E: Qty.

qConnection cable (OPC-1540*: 6 m; 20 ft) ....................... 1

wMounting base .................................................................. 1

eConnector cap .................................................................. 1

rMicrophone hanger .......................................................... 1

tScrews (M3 ×16; tapping) ............................................... 5

*: OPC 1540 has external speaker leads as illustrated at right.

(Yellow: Audio, Black: Speaker ground)

Icom, Icom Inc. and the logo are registered trademarks of Icom Incorporated (Japan) in the United States, the United Kingdom, Germany, France, Spain, Rus-

sia and/or other countries. COMMANDMIC III is a trademark of Icom Incorporated (Japan) in the United states.