Icom IC-78 Manual

Icom Modtager IC-78

Læs gratis den danske manual til Icom IC-78 (48 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 51 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 26 anmeldelser. Har du et spørgsmål om Icom IC-78, eller vil du spørge andre brugere om produktet?

Side 1/48
INSTRUCTION MANUAL
HF TRANSCEIVER
i78
This device complies with Part 15 of the FCC rules. Operation is sub-
ject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
IMPORTANT
READ THIS INSTRUCTION MANUAL
CAREFULLY before attempting to operate the
transceiver.
SAVE THIS INSTRUCTION MANUAL. This
manual contains important safety and operating in-
structions for the IC-78.
EXPLICIT DEFINITIONS
i
PRECAUTIONS
RWARNING HIGH VOLTAGE! NEVER at-
tach an antenna or internal antenna connector during
transmission. This may result in an electric shock or
burn.
RNEVER apply AC to the [DC13.8V] jack on the
transceiver rear panel. This could cause a fire or ruin
the transceiver.
RNEVER apply more than 16 V DC, such as a 24 V
battery, to the [DC13.8V] jack on the transceiver rear
panel. This could cause a fire or ruin the transceiver.
RNEVER let metal, wire or other objects touch any
internal part or connectors on the rear panel of the
transceiver. This may result in an electric shock.
NEVER expose the transceiver to rain, snow or any
liquids.
AVOID using or placing the transceiver in areas with
temperatures below –1C (+14°F) or above +60°C
(+140°F). Be aware that temperatures on a vehicle’s
dashboard can exceed 80°C (+176°F), resulting in per-
manent damage to the transceiver if left there for ex-
tended periods.
AVOID placing the transceiver in excessively dusty en-
vironments or in direct sunlight.
AVOID placing the transceiver against walls or putting
anything on top of the transceiver. This will obstruct
heat dissipation.
During mobile operation, operate the trans-DO NOT
ceiver without running the vehicle’s engine. When the
transceiver power is ON and your vehicle’s engine is
OFF, the vehicles battery will soon become ex-
hausted.
Make sure the transceiver power is OFF before start-
ing the vehicle. This will avoid possible damage to the
transceiver by ignition voltage spikes.
During maritime mobile operation, keep the transceiver
and microphone as far away as possible from the mag-
netic navigation compass to prevent erroneous indica-
tions.
BE CAREFUL! The heatsink will become hot when op-
erating the transceiver continuously for long periods.
BE CAREFUL! If a linear amplifier is connected, set
the transceiver’s RF output power to less than the lin-
ear amplifier’s maximum input level, otherwise, the lin-
ear amplifier will be damaged.
Use Icom microphones only (supplied or optional).
Other manufacturer’s microphones have different pin
assignments, and connection to the IC-78 may dam-
age the transceiver.
WORD DEFINITION
RWARNING Personal injury, fire hazard or electric
shock may occur.
CAUTION Equipment damage may occur.
NOTE Inconvenience only. No risk of per of
personal injury, fire or electric shock.


Produkt Specifikationer

Mærke: Icom
Kategori: Modtager
Model: IC-78

Har du brug for hjælp?

Hvis du har brug for hjælp til Icom IC-78 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Modtager Icom Manualer

Icom

Icom IC-M15 Manual

14 Oktober 2024
Icom

Icom IC-4008E Manual

5 Oktober 2024
Icom

Icom AT-140 Manual

5 Oktober 2024
Icom

Icom IC-25H Manual

5 Oktober 2024
Icom

Icom IC-T7H Manual

26 September 2024
Icom

Icom IC-M600E Manual

22 September 2024
Icom

Icom IC-PS25 Manual

20 September 2024
Icom

Icom IC-A22 Manual

19 September 2024
Icom

Icom IC-T81A Manual

16 September 2024
Icom

Icom IC-745 Manual

10 September 2024

Modtager Manualer

Nyeste Modtager Manualer