Ikan Stryder SW-IP100 Manual

Ikan Lys Stryder SW-IP100

Læs gratis den danske manual til Ikan Stryder SW-IP100 (4 sider) i kategorien Lys. Denne vejledning er vurderet som hjælpsom af 9 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 5 anmeldelser. Har du et spørgsmål om Ikan Stryder SW-IP100, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

www.ikancorp.com | 1.713.272.8822 | sales@ikancorp.com because we’re tooﬁlmmakers

SW-IP100

Quick Start Guide

Stryder 100 Watt LED IP54 Daylight Fresnel Light

What’s Included

1 x SW-IP100

1 x Fresnel Spot to Flood Mount

1 x Barn Doors

1 x Gel Frame

1 x Power Adapter w/ Stand Clamp

1 x V-Mount Adapter w/ Stand Clamp

www.ikancorp.com | 1.713.272.8822 | sales@ikancorp.com because we’re tooﬁlmmakers

Getting Started

Thank you for buying the Stryder IP54 LED Fresnel Spotlight from Ikan. Please carefully read the instructions and guide before operating the products.

The guide includes product usage and maintenance. When you operate the product, please make sure that you have read the instructions carefully. All the

content of the manual is based on up-to-date information; technical data subject to change without notice.

Safety Instructions

1. Connect the power supply to the SW-IP100 Light before plugging into the power source.

2. This light is rated IP54 meaning the ﬁxture is protected against ingress of dust, and water splashed against it from all directions. It is not waterproof.

Please do not submerge the light in water.

3. Don’t drag cables with excessive force. Any repairs on the products should be performed by Ikan technicians. Users should not remove the power

supply, or else the damage will not be covered under warranty.

4. Conﬁrm that the power is off before connecting and changing the ﬁxture head or disconnecting your cable from the power source. We recommend

using Ikan connecting cables and connectors to avoid electrical shock.

5. The voltage shouldn’t exceed the value in the technical speciﬁcations. If the voltage is greater than, or less than the regulated values, it could damage

the product.

Operating Instructions

1. Ensure power is off before installation.

2. Place the light on the light stand, release the tension knob on the 5/8” receiver, adjust the light in the desired direction, and then tighten the tension

knob on the 5/8” receiver.

3. When connecting the power cords, plug either the included power adapter or V-Mount battery adapter to 3-pin XLR power connection port (as shown

below).

Control Knob

3-pin XLR

Power Connection

On / Off Switch