Intermatic T106R Manual

Intermatic bryter T106R

Læs gratis den danske manual til Intermatic T106R (1 sider) i kategorien bryter. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om Intermatic T106R, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

WARNING

Risk of Fire or Electric Shock

• Disconnect power at the circuit breaker(s) or disconnect switch(es) before installing or servicing.

• Installation and/or wiring must be in accordance with national and local electrical code requirements.

• Use wires rated at least 90°C - COPPER conductors ONLY.

• For outdoor locations, raintight, or wet location, conduit hubs that comply with requirements of UL514B (standard

for ﬁttings for conduit and outlet boxes) are to be used.

• Replace plastic insulator covering terminals before powering ON.

• KEEP DOOR CLOSED AT ALL TIMES when not servicing.

NOTICE

• Rotate timer dial clockwise only.

• Do not move the clock hands on the timer. Moving the clock hands can damage the timer.

AVERTISSEMENT

Risque d’incendie ou de choc électrique

• Utiliser des ﬁls classés 90°C minimum - Conducteurs en CUIVRE UNIQUEMENT.

• Pour les emplacements extérieurs, étanches à la pluie ou les emplacements mouillés, des entrées de conduit qui

sont conformes aux exigences de UL514B (norme pour les pièces de ﬁxation pour conduit et boîtes de sortie)

doivent être utilisées

LR3730

CLOCK

MOTOR

WIRING DIAGRAM

FROM

208V

240V

277V

SUPPLY

LOAD

GROUND

LINE

GRD

4321

TYPICAL WIRING SINGLE POLE NORMALLY OPEN - 277 V

SEE WIRING INSTRUCTIONS BELOW FOR OTHER TYPES

N or

LINE 2

TIME

POINTER

TIME

DIAL

OFF

TRIPPER

MANUAL

LEVER

TRIPPER

CLOCK MOTOR: 208-277 VAC, 60 HZ.

CLOCK MOTOR VOLTAGE AND CYCLE MUST BE AS SPECIFIED. TO ORDER

REPLACEMENT, INDICATE ART NO. (WG--) ON MOTOR COVER.

PROGRAMMING INSTRUCTIONS

1. TO SET “ON” AND “OFF” TIMES: Hold trippers against edge of CLOCK-DIAL, pointing

to time (AM or PM) when and operations are desired, tighten tripper screws ON OFF

firmly. For additional tripper pairs on order 156T1978A.CLOCK-DIAL

2. TO SET TIME-OF-DAY: Pull CLOCK-DIAL outward. Turn in either direction and align

the exact time-of-day on the (the time now, when switch is being put into CLOCK-DIAL

operation) to the pointer. DO NOT MOVE POINTER.

OPERATING INSTRUCTIONS

•

TO OPERATE SWITCH MANUALLY: MANUAL LEVERMove

CLOCK-DIAL below left or

right as indicated by arrows. This will not effect next operation.

• IN CASE OF POWER FAILURE, reset CLOCK-DIAL to proper time-of-day. See

programming instructions.

INTERMATIC INCORPORATED

SPRING GROVE, ILLINOIS 60081-9698

154--02053

PRESSURE PLATE

TERMINAL SCREW

MAKE SURE WIRE

INSULATION CLEARS

PRESSURE PLATE

MINIMUM

COPPER

WIRE SIZE

(AWG)

MAX.

LOAD

(AMP)

MIN.

INSUL-

ATION

TEMP(°C)

75°C INSULATION MAX. MOTOR

LOAD (HP)

SINGLE PHASE

3 PHASE

120 V. 240 V. 208 V.

240 V.

1/2

2 1/2

N/A

WIRING INSTRUCTIONS: Remove 1/2 inch of insulation from wire ends. Tighten terminal screws firmly

(2-18 in-lbs). Use solid or stranded COPPER only. May use two wires of the same size and conductors

type. To wire switch follow diagram above. To wire as SINGLE POLE NORMALLY CLOSED, move clock motor

lead from terminal 3 to 1, and connect LINE to 1, LOAD to 2. To wire as SINGLE POLE DOUBLE THROW,

install

jumper (the same gauge as line wire) between 2 and 3 and connect LINE 1 to 2; N.O. LOAD to Terminal 4

and N.C. LOAD to Terminal 1. Connect LINE 2 to Terminal A and also to LOADS.

HOLOGRAM

LABEL

MODEL: T106R

24 HOUR DIAL TIME SWITCH

TYPE 3R RAINPROOF ENCLOSURE

SUITABLE FOR POOL EQUIPMENT CONTROL IF INSTALLED 5 FT. OR MORE FROM EDGE

OF POOL. ONE NORMALLY OPEN - ONE NORMALLY CLOSED CONTACTS. MAY BE

WIRED AS SINGLE POLE DOUBLE THROW. 40 A RESISTIVE, INDUCTIVE, TUNGSTEN

OR 1000 VA PILOT DUTY PER POLE - 120-277 VAC;

2 HP (24 FLA) - 120 VAC; 5 HP (28 FLA) - 240 VAC

16 A ELECTRONIC BALLAST, 277 VAC

Produkt Specifikationer

Mærke:	Intermatic
Kategori:	bryter
Model:	T106R

Har du brug for hjælp?

Hvis du har brug for hjælp til Intermatic T106R stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

bryter Intermatic Manualer

Intermatic T1871BR Manual

29 Juli 2025

Intermatic T1471BR Manual

29 Juli 2025

Intermatic T106M Manual

29 Juli 2025

Intermatic T1471BCR Manual

29 Juli 2025

Intermatic T1976 Manual

29 Juli 2025

Intermatic DTAV40Q Manual

19 Juli 2025

Intermatic T7401B Manual

15 Juni 2025

Intermatic T103M Manual

10 Juni 2025

Intermatic T106R Manual

9 Juni 2025

Intermatic T1905E Manual

9 Juni 2025

bryter Manualer

Nyeste bryter Manualer

TP-Link Omada DS106GPP Manual

19 Oktober 2025

Draytek VigorSwitch PQ2200xb Manual

17 Oktober 2025

Kramer VS-88H2 Manual

16 Oktober 2025

Lancom GS-3126X Manual

16 Oktober 2025

Lancom GS-2310 Manual

16 Oktober 2025

Lancom GS-3628X Manual

16 Oktober 2025

Lancom GS-3528 Manual

16 Oktober 2025

Eberle ZTM 2 Manual

15 Oktober 2025

Manhattan 154390 Manual

7 Oktober 2025

Draytek VigorSwitch P2121 Manual

6 Oktober 2025