Intermatic T174 Manual

Intermatic bryter T174

Læs gratis den danske manual til Intermatic T174 (1 sider) i kategorien bryter. Denne vejledning er vurderet som hjælpsom af 27 personer og har en gennemsnitlig bedømmelse på 3.5 stjerner ud af 14 anmeldelser. Har du et spørgsmål om Intermatic T174, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

DAY

ARROW

TIME

POINTER

TIME

DIAL

OFF

TRIPPER

MANUAL

LEVER

ON/CUTOUT

TRIPPER

SKIPPER

WHEEL

SKIPPING

SCREW

CLOCK MOTOR: 208-277 VAC, 60 HZ.

CLOCK MOTOR VOLTAGE AND CYCLE MUST BE AS SPECIFIED. TO ORDER

REPLACEMENT, INDICATE PART NO. (WG--) ON MOTOR COVER.

MODEL: T174

24 HOUR DIAL TIME SWITCH

WITH “SKIPPER

”

TYPE 1 INDOOR USE ONLY

DOUBLE POLE SINGLE THROW (DPST)

40 A RESISTIVE, PER POLE 120 - 480 VAC; 40 A INDUCTIVE,

TUNGSTEN OR 1000 VA PILOT DUTY PER POLE 120 - 277 VAC;

2 HP (24 FLA) - 120 VAC; 5 HP (28 FLA) - 240 VAC

16 A ELECTRONIC BALLAST, 277 VAC

WARNING

Risk of Fire or Electric Shock

• Disconnect power at the circuit breaker(s) or disconnect switch(es) before installing or servicing.

• Installation and/or wiring must be in accordance with national and local electrical code requirements.

• Use wires rated at least 90°C - COPPER conductors ONLY.

• Replace plastic insulator covering terminals before powering ON.

• KEEP DOOR CLOSED AT ALL TIMES when not servicing.

NOTICE

• Rotate timer dial clockwise only.

• Do not move the clock hands on the timer. Moving the clock hands can damage the timer.

AVERTISSEMENT

Risque d’incendie ou de choc électrique

• Utiliser des ﬁls classés 90°C minimum - Conducteurs en CUIVRE UNIQUEMENT.

HOLOGRAM

LABEL

LR3730

PRESSURE PLATE

TERMINAL SCREW

MAKE SURE WIRE

INSULATION CLEARS

PRESSURE PLATE

MINIMUM

COPPER

WIRE SIZE

(AWG)

MAX.

LOAD

(AMP)

MIN.

INSUL-

ATION

TEMP(°C)

75°C INSULATION MAX. MOTOR

LOAD (HP)

SINGLE PHASE

3 PHASE

120 V. 240 V. 208 V.

240 V.

1/2

2 1/2

N/A

WIRING INSTRUCTIONS: Remove 1/2 inch of insulation from wire ends. Tighten terminal screws firmly

(2-18 in-lbs). Use solid or stranded COPPER only. May use two wires of the same size and type.conductors

INTERMATIC INCORPORATED

SPRING GROVE, ILLINOIS 60081-9698

154--02068

PROGRAMMING INSTRUCTIONS

1. TO SET “ON” AND “OFF” TIMES: Hold trippers against edge of CLOCK-DIAL, pointing to

time (AM or PM) when and operations are desired, tighten tripper screws firmly. ON OFF

For additional tripper pairs on order 156T1948A.CLOCK-DIAL

2. TO SET TIME-OF-DAY: Pull CLOCK-DIAL outward. Turn in either direction and align

the exact time-of-day on the (the time now, when switch is being put into CLOCK-DIAL

operation) to the pointer. DO NOT MOVE POINTER.

3. TO SKIP OPERATION(S) ON SELECTED DAY(S): SKIPPING SCREW(S) SKIPPER Insert in

WHEEL for day(s) automatic operation(s) is/are NOT required. Tighten screws firmly. Move

MANUAL LEVER SKIPPER WHEEL to “OFF” and rotate to locate correct day-of-week

opposite DAY ARROW--”YESTERDAY” if ON/CUTOUT TRIPPER has not yet advanced

wheel “TODAY” if it has.

OPERATING INSTRUCTIONS

• TO OPERATE SWITCH MANUALLY: MANUAL LEVER Move below CLOCK-DIAL left or

right as indicated by arrows. This will not effect next operation.

CAUTION: TO AVOID SLOW SWITCH ACTION FAILURE, DO NOT OPERATE

SWITCH MANUALLY NOR PLACE A TRIPPER 4 HOURS PRIOR TO

ON/CUTOUT TRIPPER SWITCHING.

• IN CASE OF POWER FAILURE, reset CLOCK-DIAL to proper time-of-day. See

programming instructions.

CLOCK

MOTOR

277/480 VOLT CONNECT MOTOR LEADS TO TERMINALS “A”

AND 1 AND SUPPLY NEUTRAL TO TERMINAL “A”.

LOAD(S)

LINE 2

WIRING DIAGRAM

240V 2 WIRE

AND GROUND

LINE 1

240V

SUPPLY

GROUND

Produkt Specifikationer

Mærke:	Intermatic
Kategori:	bryter
Model:	T174

Har du brug for hjælp?

Hvis du har brug for hjælp til Intermatic T174 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

bryter Intermatic Manualer

Intermatic T1871BR Manual

29 Juli 2025

Intermatic T1471BR Manual

29 Juli 2025

Intermatic T106M Manual

29 Juli 2025

Intermatic T1471BCR Manual

29 Juli 2025

Intermatic T1976 Manual

29 Juli 2025

Intermatic DTAV40Q Manual

19 Juli 2025

Intermatic T7401B Manual

15 Juni 2025

Intermatic T103M Manual

10 Juni 2025

Intermatic T106R Manual

9 Juni 2025

Intermatic T1905E Manual

9 Juni 2025

bryter Manualer

Nyeste bryter Manualer

Emko Trans Manual

7 September 2025

BZBGear BG-MKVM41R Manual

6 September 2025

Speaka SP-HSW-300 Manual

6 September 2025

Speaka SP-KVM-340 Manual

6 September 2025

Alcatel OmniSwitch 6450 Manual

6 September 2025

Raritan T1700-LED Manual

4 September 2025

Gefen EXT-MFP Manual

4 September 2025

Generac RTSW100K3 Manual

3 September 2025

Generac RTSW100J3 Manual

3 September 2025

Generac RTSW400A3 Manual

3 September 2025