Intermatic T1905 Manual


Læs nedenfor 📖 manual på dansk for Intermatic T1905 (1 sider) i kategorien bryter. Denne guide var nyttig for 2 personer og blev bedømt med 4.8 stjerner i gennemsnit af 1.5 brugere

Side 1/1
MODEL: T1905
PROGRAM TIME SWITCH
FOR UP TO 48 TIMING OPERATIONS
0N 24 HOUR SCHEDULE
SINGLE POLE DOUBLE THROW
SWITCH RATING: 20 AMP. 125-480 VOLTS A.C. 1/2 HP-125V 1 HP-250V.
WIRING INSTRUCTIONS
This Time Switch can be wired to control two circuits as Single Pole
Double throw, or to control one circuit as Single Pole Single Throw.
Either normally open (NO) or normally closed (NC). To wire switch see
TO PROGRAM TIME SWITCH, Depress tripper(s) into dial at
desired time(s) operation(s) is/are required.
ON TIME: First tripper turns on the load for 16-20 minutes. Each
additional tripper will lengthen the on time by 15 minutes.
OFF TIME: First tripper in raised position turns off the load for
10-14 minutes.Each additional space will lengthen the of time by
15 minutes.
SET TIME-OF-DAY: Turn dial in clockwise direction only and align
the exact time-of-day (the time now when switch is being put into
operation) to the “TIME” arrow on insulator.
TIME
DIAL
INSULATOR
MANUAL
LEVER
CAP
NUTS
CLOCK
MOTOR
SUPPLY
NORMALLY CLOSED CIRCUIT
NORMALLY OPEN CIRCUIT
FIG. 1 WIRING DIAGRAM
CLOCK
COM.
N.C.
N.O.
N.C.
LOAD
NO.
LOAD
1.
2.
OPERATING INSTRUCTIONS
TO CONTROL LOADS MANUALLY, Move manual lever (See Figure 1)
up. This lever will close normally open circuit and open the normally
closed circuit. To return, to automatic control, move lever back to its
original position .
IN CASE OF POWER FAILURE, reset dial. See step (2) of programming
instructions.
INTERMATIC INCORPORATED
LIBERTYVILLE, ILLINOIS 60048
154--03517
CLOCK MOTOR: 125 VOLTS - 60 HZ.
LR3730


Produkt Specifikationer

Mærke: Intermatic
Kategori: bryter
Model: T1905

Har du brug for hjælp?

Hvis du har brug for hjælp til Intermatic T1905 stil et spørgsmål nedenfor, og andre brugere vil svare dig