Klein Tools 60552 Manual

Klein Tools Ikke kategoriseret 60552

Læs gratis den danske manual til Klein Tools 60552 (5 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om Klein Tools 60552, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/5

60552

(M/L - M/G)

60553

(S/M - P/M)

FIG. 1

FIG. 4

FIG. 3

FIG. 6

BASED ON: 1390554 Rev 05/23 A

10.016.0638.00.AA

ENGLISH

FEATURES

Lower Strap

Upper Strap

Lower Strap Clip End (×2)

Lower Strap Buckle (×2)

Upper Strap Clip End (×2)

Upper Strap Buckle (×2)

Bottom Tab

Exhalation Valve

Face Piece

10.

Inhalation Valves (×2)

11.

Respirator Body

12.

Grille

13.

1/4-Turn Latches (×2)

14.

Sample Port Plug

FIG. 2

FIG. 5

CARACTERÍSTICAS

Correa inferior

Correa superior

Extremo del clip de la correa inferior (×2)

Hebilla de la correa inferior (×2)

Extremo del clip de la correa superior (×2)

Hebilla de la correa superior (×2)

Pestaña inferior

Válvula de exhalación

Pieza facial

10.

Válvulas de inhalación (×2)

11.

Cuerpo del respirador

12.

Rejilla

13.

Bloqueos de 1/4 de vuelta (×2)

14.

Tapón del puerto de muestras

ESPAÑOL

CARACTÉRISTIQUES

Courroie inférieure

Courroie supérieure

Extrémité de la courroie inférieure (×2)

Boucle de la courroie inférieure (×2)

Extrémité de la courroie supérieure (×2)

Boucle de la courroie supérieure (×2)

Languette inférieure

Soupape d’expiration

Masque

10.

Soupape d’inhalation (×2)

11.

Corps du respirateur

12.

Grille

13.

Loquet à quart de tour (×2)

14.

Orifice pour prise d’échantillon

FRANÇAIS

P100 HALF-MASK RESPIRATOR INSTRUCTIONS

INSTRUCCIONES DEL RESPIRADOR DE MEDIA

CARA P100

INSTRUCTIONS POUR LE DEMI-MASQUE

RESPIRATOIREP100

GENERAL SPECIFICATIONS

STANDARDS

The P100 Half Mask Respirator 60552 / 60553 is approved as a half-mask respirator in accordance with NIOSH Standards

42 CFR Part 84. The P100 filter 60554 is part of the approved assembly and only when the above items are used togethe

is the device approved for occupational applications

APPLICATIONS

The P100 half-mask respirator together with P100 filters give protection against all particulate aerosols; including soli

and liquid particules such as dust, metal fumes, and oil mist. The protection provided by classification P100 also cover

the protection provided by lower class filters. Guidelines for the selection and use may vary between countries, alway

check prior to use to ensure that your selection for the intended application meets national requirement

WARNINGS

To ensure safe operations, follow these instructions. Failure to observe these warnings instructions may result in

sickness or death.

•

NOT FOR USE

in atmospheres containing less than 19.5% oxygen

•

NOT FOR USE

in atmospheres immediately dangerous to life or health

•

DO NOT

exceed maximum use concentrations established by regulatory standards. Failure to properly use and

maintain this product could result in injury or death

•

Follow the manufacturers Users Instructions for changing cartridges, canisters and/or filters

•

All approved respirators shall be selected, fitted, used and maintained in accordance with MHSA, OSHA and othe

applicable regulations

•

NEVER

substitute, modify, add or omit parts. Use only exact replacement parts in the configuration as specified by th

manufacturer

•

Refer to user’s instructions and/or maintenance manuals for information on use and maintenance of these respirator

•

NIOSH does not evaluate respirators for use as surgical masks

•

ALWAYS

conduct a pressure face fit check prior to each use. If the check fails the respirator may be faulty or require

replacement depending on age, frequency of use and replacement of filters

The use of this respirator presupposes exact knowledge of the instructions for use, applicable health and safet

standards, guidelines for selection and use, and appropriate training in matters of personal respiratory protection

Leave the contaminated area immediately if

•

Dizziness or distress is experienced

•

You taste or smell contaminants or irritation occurs

•

Breathing becomes difficult

•

A defect is discovered in the respirator

Store respirator as per instructions

Before occupational use of this respirator a written respiratory protection program must be implemented meeting a

the local government requirements. In the United States employers must comply with OSHA 29 CFR 1910.134 whic

includes medical evaluation, training, and fit testing

FITTING

The respirator must be inspected by the wearer before and after each use to ensure that it is in good working conditio

and valves and filters are seated correctly. Remove eyewear (if worn). If facial hair goes beyond the border of the

respirator, an effective seal will not be achieved, and a powered respirator will be required

NOTE:

OSHA regulations

require that all users be fit tested prior to use either qualitatively or quantitatively.

Hold the respirator with one hand and the Lower Strap

with the other hand, put the Headband over your head and

allow to rest around the neck (FIG. 1)

Place the respirator over mouth and nose then lift the Upper Strap

over the crown of your head to support the

respirator. Ensure that the straps are not twisted and are sitting flat against the head (FIG. 2)

Grip Lower Strap Clip End(s)

at the Lower Strap Buckle(s)

and gently pull towards back of head to tighten (FIG. 3)

Grip Upper Strap Clip Ends

at the Upper Strap Buckle(s)

, and gently pull towards back of head to tighten. Check

respirator is seated correctly and tight enough to prevent air leakage between respirator and face (FIG. 4)

Clip all Strap Clip Ends

onto the Upper and Lower Straps

so that none of the strap ends are hanging

loosely (FIG. 5).

POSITIVE PRESSURE FACE FIT CHECK:

Grab the Bottom Tab

and push in to seal off the exhalation valve

Next, exhale moderately. If the face piece

bulges slightly and no air leaks between the face and the Face Piec

are detected, a proper fit is achieved. If air leakage is detected, reposition the respirator on the face and/or readjust th

Straps

to eliminate the leakage (FIG. 6)

SAMPLE PORT

The Sample Port can be used to perform non-destructive quantitative fit-testing. Ensure the Sample Port Plug

is fully

inserted and seated when using this respirator

PERIODIC AND DEEP CLEANING

ALWAYS REMOVE FILTERS PRIOR TO ANY CLEANING ACTIVITY - DO NOT WASH FILTERS.

Both periodic and deep cleaning should be logged as part of the respirator routine

PERIODIC CLEANING:

Clean

Face Piece

assembly periodically with a soft cloth and mild soapy water (no solvents)

DEEP CLEANING:

When necessary, deep-clean per the following procedure

Disassemble Respirator Body by rotating the 1/4-Turn Latches

counterclockwise and removing the Grille

filters, and Head Straps

from the Respirator Body

(FIG. 7)

NOTE: Valve bodies

are integral to the

respirator body and remain in place.

Immerse Respirator Body

and Grille

in warm water and scrub with soft brush. Neutral detergent may be used i

necessary.

Respirator Body

can also be soaked in a disinfectant for a short period of time

All parts should then be rinsed in clean, warm water and allowed to air dry in a non-contaminated atmosphere

Reassemble straps through the strap tabs in the Grille

, Replace filters with new (Cat. No. 60554) and reattach the

Grille

to the Respirator Body using the 1/4-Turn Latches

STORAGE

The respirator should be stored out of direct sunlight, away from sources of high temperature, and in an uncontaminated

environment. Spare filters should also be stored in a cool dry atmosphere at a temperature of between 14°F (-10°C) and

104°F (40°C). Storage under conditions other than those specified may affect shelf life. Respirator must be discarded

when it reaches its expiration date printed on exterior of packaging

FILTER INSPECTION & REPLACEMENT

Inspect respirator and filter before and after use for damage such as tears or cracks and immediately replace o

discard as required. Filters should be changed once a month or more frequently if you find a resistance to breathing

A maintenance record should be kept of these filter changes. Filter fitting instructions are supplied with replacemen

filters (Refer to instructions with Klein Tools Cat. No. 60554 or on www.kleintools.com for full details). Each filter pack is

individually marked with the month and year of their expiration date. Shelf life is 5 years for P100 filters. Filters must b

discarded when they reach their Expiration date

S – SPECIAL OR CRITICAL USER INSTRUCTIONS

These P100 Half-Mask Respirator(s), sizes S/M (P/N: 60553) or M/L (P/N:60552) used with filter (P/N:

60554), have been manufactured by Air Filtration Solutions for Klein Tools under TC-84A-9447.

WARRANTY

www.kleintools.com/warranty

CUSTOMER SERVICE

KLEIN TOOLS, INC.

450 Bond Street Lincolnshire, IL 60069 1-800-553-4676

customerservice@kleintools.com

www.kleintools.com

Read instructions

before using

104°F

(40°C)

14°F

(-10°C)

0 – 95%

R.H.

Temperature range of storage

conditions

Year/Month

Expiration date

<95%

R.H.

Humidity range of storage conditions

ENGLISH

KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE

CONSERVE ESTAS INSTRUCCIONES PARA CONSULTARLAS EN EL FUTURO

Produkt Specifikationer

Mærke:	Klein Tools
Kategori:	Ikke kategoriseret
Model:	60552

Har du brug for hjælp?

Hvis du har brug for hjælp til Klein Tools 60552 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Klein Tools Manualer

Klein Tools 50550 Manual

13 Juni 2025

Klein Tools VDV826-704 Manual

3 Juni 2025

Klein Tools 34055 Manual

18 Marts 2025

Klein Tools 60957 Manual

18 Marts 2025

Klein Tools 60953 Manual

18 Marts 2025

Klein Tools 34056 Manual

17 Marts 2025

Klein Tools MODbox 54801MB Manual

12 Marts 2025

Klein Tools 56417 Manual

13 Februar 2025

Klein Tools 54825MB Manual

14 Januar 2025

Klein Tools ESF100 Manual

5 Januar 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

AmpliVox Airvox SW695 Manual

15 Juni 2025

Stiga SBC 635 KD Manual

15 Juni 2025

Cleveland 36CGM300 Manual

15 Juni 2025

Gourmia GTF7970 Manual

15 Juni 2025

Planet Audio P9630B Manual

15 Juni 2025

ORNO OR-DOM-YR-934UD Manual

15 Juni 2025

Lavex 842CD12VST12 Manual

15 Juni 2025

Marshall RCP-PLUS Manual

15 Juni 2025

Hughes & Kettner BassForce XL Manual

15 Juni 2025

Hughes & Kettner Red Box Mk III Manual

15 Juni 2025