La Crosse Technology WS-9001U-IT Manual

La Crosse Technology Termometer WS-9001U-IT

Læs gratis den danske manual til La Crosse Technology WS-9001U-IT (16 sider) i kategorien Termometer. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 3.8 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om La Crosse Technology WS-9001U-IT, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/16

OUT

MAX

in / out

min / max

Language Page

English 2

French 38

Spanish 78

This product oers:

WS-9001U

915 MHz

Wireless Weather Station

Instruction Manual

Contents

GB GB

P.3 GB P.4 GB

P.5

INSTANT TRANSMISSION

is the state-of-the-art new

w i r e l e s s t r a n s m i s s i o n

technology, exclusively de-

s i g n e d a n d de vel o p e d by LA CR O S S E

TECHNOLOGY.

INSTANT TRANSMISSION

offers

you can an immediate update (every 27.5 seconds!)

of all your outdoor data measured from the

transmitters: follow your climatic variations in real-

time!

P.2

FCC ID: OMOTX38U (transmitter)

RF Exposure mobile:

The internal / external antennas used for this mobile transmitter must pro-

vide a separation distance of at least 20 cm (8 inches) from all persons and

must not be co-located or operating in conjunction with any other antenna

or transmitter.”

Statement according to FCC part 15.19:

This device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received, in-

cluding interference that may cause undesired operation.

Statement according to FCC part 15.21:

Modifications not expressly approved by this company could void the user’s

authority to operate the equipment.

Statement according to FCC part 15.105:

NOTE:

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful inter-

ference in a residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and used in accor-

dance with the instructions, may cause harmful interference to radio

communications.

However, there is no guarantee that interference will not occur in a particu-

lar installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help

INVENTORY OF CONTENTS

1. Temperature station.

2. Wireless Temperature Transmitter (TX38U-IT) and

mounting bracket.

3. Instruction Manual.

ADDITIONAL EQUIPMENT (not included)

1. 1 Philips screwdriver.

2. 2 Fresh “AAA” IEC LR3, 1.5V Alkaline Batteries.

3. 2 Fresh “AA” IEC LR6, 1.5V Alkaline Batteries.

TABLE OF CONTENTS

Topic Page

Inventory of Contents 3

Features 4

Setting Up 6

Battery Installation 7

Function keys 10

LCD Screen and Settings 11

Indoor Temperature Display and

Indoor MIN/MAX Records 11

Outdoor Temperature Display and

Outdoor MIN/MAX Records 13

Reset MIN/MAX records 14

915 MHz Reception 14

Mounting 15

Maintenance and care 19

Specification 20

Warranty Information 21

FAQ 25

FEATURES

The Temperature Station

OUT

MAX

in / out

min / max

• Temperature display in degrees Fahrenheit (˚F)

• Indoor and Outdoor temperature display with MIN/

MAX recording

• All MIN/MAX recordings can be reset

• Low battery indicator

• Wireless transmission at 915 MHz

• Outdoor signal reception intervals at 27.5-second

• Table standing or wall mounting

The Outdoor Temperature Transmitter

• Remote transmission of outdoor temperature to

Temperature Station by 915 MHz

LCD Display

Function Keys

Hanging hole

Battery

compartment

cover

Foldout Stand

DISPLAY OF OUTDOOR TEMPERATURE READING

AND OUTDOOR MIN/MAX RECORDS:

1. Press the IN/OUT key to view the current outdoor

temperature

2. Press the MIN/MAX key to view the MIN record

3. Press again the MIN/MAX key to view the MAX

record.

4. Press the MIN/MAX once more to return to current

outdoor temperature.

OUTIN

MAX

RX TX

Receiver low

battery icon

Transmitter low

battery icon

Temperature

display in ˚F

Outdoor signal

reception icon*

OUTIN

MAX

RX TX

MIN

GB P.6 GB

P.7 GB P.8 GB

P.9

GB P.10 GB

P.11 GB P.12 GB

P.13

• Shower proof casing

• Wall mounting case

• Mounting at a sheltered place. Avoid direct rain and

sunshine

SETTING UP

NOTE:

The temperature station will receive one out-

door transmitter only.

1. First, insert the batteries into the Temperature

transmitter. (see “Install and replace batteries in

the Temperature transmitter”).

2. Immediately after and within 1 minute, insert the

batteries into Temperature station (see “Install and

replace batteries in the Temperature station”).

Once the batteries are in place, all segments of the

LCD will light up briefly. Then the indoor tempera-

ture will de display. If these are not displayed after

60 seconds, remove the batteries and wait for at

least 10 seconds before reinserting them.

3. After inserting the batteries into the transmitter, the

Temperature station will start receiving data from

the transmitter. The outdoor temperature and the

signal reception icon should then be displayed on

the Temperature station. If this does not happen

after 3 minutes, the batteries will need to be re-

moved from both units and reset from step 1.

4. In order to ensure sufficient 915 MHz transmission

however, this should under good conditions be a

distance no more than 330 feet (100 meters) be-

tween the final position of the Temperature Station

and the transmitter (see notes on “Mounting” and

“915 MHz Reception”).

INSTALL AND REPLACE BATTERIES IN THE

TEMPERATURE TRANSMITTER

The Temperature Transmitter uses 2 x AAA, IEC LR3,

1.5V battery. To install and replace the batteries, please

follow the steps below:

1. Pull out the battery holder at the bottom of the

transmitter.

2. Insert the batteries, observing the correct polarity

(see marking).

3. Replace the battery holder on the unit.

Note:

In the event of changing batteries in any of the units,

all units need to be reset by following the setting up

procedures. This is because a random security code is

assigned by the transmitter at start-up and this code

must be received and stored by the Weather station in

the first minute of power being supplied to it

INSTALL AND REPLACE BATTERIES IN THE TEM-

PERATURE STATION

The Temperature station uses 2 x AA, IEC LR6, 1.5V

batteries. To install and replace the batteries, please

follow the steps below:

SIZE AAA LR03

1. Remove the cover at the back of the temperature

station.

2. Insert batteries observing the correct polarity (see

marking).

3. Replace compartment cover.

BATTERY CHANGE

It is recommended to replace the batteries in

all units on an annual basis to ensure optimum

accuracy of these units.

Please participate in the preservation of the

environment. Return used batteries to an

authorised depot.

FU NCTI ON KEYS

Weather station:

The weather station has 2 easy to use function keys.

IN/OUT key

• To toggle between the indoor and outdoor tempera-

ture display

MIN/ MAX key

• To toggle between the current and MIN/MAX in-

door and outdoor temperature display

• Press and hold to reset at the MIN/MAX indoor and

outdoor temperature records

LCD SCREEN AND SETTINGS

• When the outdoor signal is successfully received

by the Temperature Station, this icon will be

switched on. (If not successful, the icon will not be

shown in LCD) So user can easily see whether the

last reception was successful (icon on) or not (icon

off).

DISPLAY OF INDOOR TEMPERATURE READING

AND INDOOR MIN/MAX RECORDS:

1. Press the IN/OUT key to view the current indoor

temperature

2. Press the MIN/MAX key to view the MIN record

3. Press again the MIN/MAX key to view the MAX

record.

4. Press the MIN/MAX once more to return to current

indoor temperature.

OUTIN

MAX

RX TX

MIN

OUTIN

MAX

RX TX

MIN

OUT

MAXMIN

OUT

MAX

Indoor data

icon

Indoor

Temerature in

˚F

MIN icon

MAX icon

Outdoor data icon

Outdoor

Temperature in

˚F

MIN icon

MAX icon

in / out

min / max

IN/OUT key MIN/MAX key

Produkt Specifikationer

Mærke:	La Crosse Technology
Kategori:	Termometer
Model:	WS-9001U-IT

Har du brug for hjælp?

Hvis du har brug for hjælp til La Crosse Technology WS-9001U-IT stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Termometer La Crosse Technology Manualer

La Crosse Technology 204-1520I Manual

5 December 2024

La Crosse Technology 104-106BL Manual

4 Oktober 2024

La Crosse Technology 104-20747MV Manual

17 September 2024

La Crosse Technology HD81762 Manual

16 September 2024

La Crosse Technology K84377 Manual

16 September 2024

La Crosse Technology HD81786 Manual

10 September 2024

La Crosse Technology 308-1409TH-11 Manual

6 September 2024

La Crosse Technology 314-519 Manual

6 September 2024

La Crosse Technology M71800 Manual

6 September 2024

La Crosse Technology 914-4928 Manual

4 September 2024

Termometer Manualer

Nyeste Termometer Manualer

Emos EGS0102 Manual

1 August 2025

Braun Sensian 3 BNT050 Manual

24 Juli 2025

Milwaukee Temp-Gun 2268-20 Manual

22 Juli 2025

Milwaukee Temp-Gun 2267-20 Manual

22 Juli 2025

Alecto BT5 Manual

21 Juli 2025

Steinberg SBS-IR-1300-16 Manual

19 Juli 2025

Comelec TN400 Manual

18 Juli 2025

Sauter JIT 200 Manual

17 Juli 2025

Laica TH1004 Manual

16 Juli 2025

Inkbird ITH-13-B Manual

16 Juli 2025