LiftMaster 894LT Manual

LiftMaster Ikke kategoriseret 894LT

Læs gratis den danske manual til LiftMaster 894LT (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 96 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 48.5 anmeldelser. Har du et spørgsmål om LiftMaster 894LT, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

2-BUTTON AND 4-BUTTON REMOTE CONTROLS

MODELS 892LT AND 894LT

To prevent possible SERIOUS INJURY or DEATH from a

moving gate or garage door:

• ALWAYS keep remote controls out of reach of children.

NEVER permit children to operate or play with remote

controls.

• Activate gate or door ONLY when it can be seen clearly,

is properly adjusted and there are no obstructions to

door travel.

• ALWAYS keep gate or garage door in sight until

completely closed. NEVER permit anyone to cross path

of moving gate or door.

PROGRAMMING

AOPTION A

The instructions are written for garage door openers, however the

steps still apply for compatible products. Make sure the garage door

opener has a working light bulb because it is a programming

indicator. The illustrations are generic, so your garage door opener

may look different.

1Press and hold the program button on the remote control until

the LED on the front of the remote control turns on.

2 Press and release the remote control button you wish to use

the number of times that corresponds with the garage door

opener type:

# OF PRESSES GARAGE DOOR OPENER TYPE

1 Security+ 2.0® (Yellow Learn Button)

2 315 MHz Security+® (Purple Learn Button)

3 390 MHz Security+® (Red/Orange Learn Button)

3 To exit programming mode, press any remote control button

except the button that was just programmed.

4Press and release the Learn button on the garage door opener.

The Learn LED will light.

5Within 30 seconds, press the remote control button

programmed in step 2 until the garage door opener lights flash

or two clicks are heard.

6To test, press the programmed button the remote control. The

garage door opener will activate.

1 Make sure the existing dip-switch remote control and the

new remote control are in close proximity to each other.

2 Remove the battery cover from the remote control new

and locate the Program button.

3To enter programming mode on the new remote control,

press the program button until the LED on the remote

control turns on.

4 Press and hold the button that currently activates your

product on the existing remote control that you want to

copy to the new remote control. The LED on the new

remote control will flash.

5Press and release the button on the new remote control

that you want to program. The LED on the new remote

control will flash rapidly, then return to a flash slowly. DO

NOT press the button after the LED flashes.

6To exit programming mode, press and release the

Program button on the remote control. The LED on the

remote control will turn off.

7To test, press and release the programmed button on the

remote control. The gate operator or commercial door

operator will activate.

MODEL 892LT

MODEL 894LT

There are two different programming options depending on your application. If you are programming the remote control to an existing DIP switch remote control, refer to OPTION B. For all other

programming, refer to OPTION A.

The 892LT/894LT remote control is compatible with Security+ 2.0

® garage door openers, gate operators,