Linn Kivor k Manual

Linn Skrige Kivor k

Læs gratis den danske manual til Linn Kivor k (48 sider) i kategorien Skrige. Denne vejledning er vurderet som hjælpsom af 17 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 9 anmeldelser. Har du et spørgsmål om Linn Kivor k, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/48

Important safety information

Explanation of symbols used in this manual and on the product:

This symbol is intended to alert the user to the presence of uninsulated

dangerous voltages within the enclosure of sufficient magnitude to

cause electric shock.

This symbol is intended to alert the user to the presence of important

maintenance and servicing information in the instruction and service

manuals.

CAUTION

TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE THE COVER.

NO USER SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

WARNING: SHOCK HAZARD. DO NOT OPEN.

AVIS: RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR.

CAUTION: REPLACE FUSE WITH SAME TYPE AND RATING.

ATTENTION: UTILISER UN FUSIBLE DE RECHANGE DE MÊME TYPE.

DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE.

ATTENTION: DEBRANCHER AVANT DE REMPLACER LE FUSIBLE.

WARNING

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS

APPLIANCE TO RAIN OR MOISTURE.

MAINS PLUGS

This appliance is supplied with a non-rewireable mains plug for the intended

country.

Replacement mains leads can be obtained from your Linn retailer.

Should you need to change the plug please dispose of it carefully.

A plug with bared conductors is dangerous if engaged in a live socket.

The Brown wire must be connected to the Live (Line) supply pin.

The Blue wire must be connected to the Neutral supply pin.

The Green/Yellow wire must be connected to the Earth (Ground) supply pin.

Please contact your retailer or a competent electrician if you are in any doubt.

GENERAL SAFETY INSTRUCTIONS

1. Read instructions. Read the safety and operating instructions before operating the

appliance.

2. Retain instructions. Retain the safety and operating instructions for future reference.

3. Heed warnings. Observe all warnings on the appliance and in the operating instructions.

4. Follow instructions. Follow all operating and use instructions.

5. Water and moisture. Do not use the appliance near water, for example near a bathtub,

washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool and

the like.

6. Carts and stands. Use only with a cart or stand that is recommended by the manufacturer.

6a. An appliance and cart combination should be used with care. Quick stops, excessive

force, and uneven surfaces may cause the appliance and cart combination to overturn.

7. Wall or ceiling mounting. Mount to a wall or ceiling only as recommended by the

manufacturer.

8. Ventilation. Site the appliance so that its location or position does not interfere with its

proper ventilation. For example, the appliance should not be situated on a bed, sofa,

rug, or similar surface that may block the ventilation openings, or placed in a built-in

installation such as a bookcase or cabinet that may impede the flow of air through the

ventilation openings.

9. Heat. Site the appliance away from heat sources such as radiators, heaters, stoves, or

other appliances (including amplifiers) that produce heat.

10. Power sources. Connect the appliance to a power supply only of the type described in

the operating instructions or marked on the appliance.

11. Grounding or polarisation. Do not defeat the safety purpose of the polarised or

grounding type plug. A polarised plug has two blades with one wider than the other. A

grounding type plug has two blades and a third grounding prong. The wide blade or

the third prong are provided for your safety. When the provided plug does not fit into

your outlet, consult an electrician for replacement of the obsolete outlet.

12. Power cord protection. Route power cords so that they are not likely to be walked on or

pinched by items placed upon or against them, paying particular attention to cords at

plugs, power sockets, and at the point where they exit from the appliance.

13. Protective attachment plug. As a safety feature the product is equipped with an

attachment plug containing overload protection. See the instruction manual about

resetting or replacing the plug. Should the plug need replacing ensure that a

replacement is used which has the same overload protection as the original.

14. Cleaning. The product should be cleaned only as recommended by the manufacturer.

15. Power lines. An outdoor antenna should be located away from power lines.

16. Outdoor antenna grounding. If an outdoor antenna is connected to the tuner/receiver

ensure that the antenna system is grounded to provide some protection against voltage

surges and static build up.

In the USA see article 810 of the National Electrical Code ANSI/NFPA 70 concerning

installation requirements.

17. Unplug this apparatus during lightning storms or when unused for long periods of time.

18. Objects and liquid entry. Take care not to let objects or liquids fall into the product.

19. Damage requiring service. The product should be serviced by qualified personnel if:

a) The power cord or plug has been damaged.

b) Objects or liquid have fallen into the product.

c) The product has been exposed to rain.

d) The product does not appear to operate normally or exhibits a marked change in

operation.

e) The product has been dropped or the enclosure damaged.

20. Servicing. Don’t attempt to service the product beyond that described in the operating

instructions. All other servicing should be referred to qualified service personnel.

UK USERS PLEASE READ THIS IMPORTANT SAFETY INFORMATION

Fuse replacement

This appliance is fitted with a non-rewireable 13 Amp mains plug. The plug

contains a 5 Amp fuse. If the fuse has blown it can be replaced as follows:

a) Pull out the red fuse cover/carrier.

b) Remove and dispose of the blown fuse.

c) Fit a new 5 Amp BS1362 approved fuse into the carrier and push the carrier

back into the plug.

Always ensure the fuse cover is fitted. If the fuse cover is missing do not use the

plug. Contact your Linn retailer to obtain a replacement fuse cover.

Fuses are for fire protection and do not protect against electric shock.

Mains plug replacement

Should your mains plug need replacing and you are competent to do this

proceed as follows. If you are in doubt contact your Linn retailer or a competent

electrician.

a) Disconnect the plug from the mains supply.

b) Cut off the plug and dispose of it safely. A plug with bared conductors is

dangerous if engaged in a live socket.

c) Only fit a 13 Amp BS1363A approved plug with a 5 Amp fuse.

d) The cable wire colours or a letter will be marked at the connection points of

most quality plugs.

Attach the wires securely to their respective points. The Brown wire must go to

the Live pin, the Blue wire must go to the Neutral pin, and the Green/Yellow wire

must go to the Earth pin.

e) Before replacing the plug top ensure that the cable restraint is holding the

outer sheath of the cable firmly and that the wires are correctly connected.

WARNING

THIS APPLIANCE MUST BE EARTHED.

CE Declaration of Conformity

Linn Products Ltd declare that this product is in conformance with the Low

Voltage Directive 73/23/EEC and Electromagnetic Compatibility 89/336/EEC as

amended by 92/31/EEC and 93/68/EEC.

The conformity of the designated product with the provisions of Directive

number 73/23/EEC (LVD) is proved by full compliance with the following

standards:

Standard number Date of issue Test type

EN60065 1993 General requirements

Marking

Ionizing

Heating under normal conditions

Shock hazards under normal

operating instructions

Insulation requirements

Fault conditions

Mechanical strength

Parts connected to the mains supply

Components

Terminal devices

External flexible cords

Electrical connections and

mechanical fixings

The conformity of the designated product with the provisions of Directive

number 89/336/EEC (EMC) is proved by full compliance with the following

standards:

Standard number Date of issue Test type

EN55013 1994 Conducted emissions

EN55013 1994 Absorbed emissions

EN60555-2 1987 Harmonics

EN60555-3 1987 Voltage fluctuations

EN55020 1994 Immunity

FCC notice

NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the

following measures:

— Reorient or relocate the receiving antenna.

— Increase the separation between the equipment and receiver.

— Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

— Consult the dealer or an experienced radio/TV technician for help.

Produkt Specifikationer

Mærke:	Linn
Kategori:	Skrige
Model:	Kivor k

Har du brug for hjælp?

Hvis du har brug for hjælp til Linn Kivor k stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Skrige Linn Manualer

Linn Kivor Oktal Manual

30 August 2024

Linn Kivor Index Manual

30 August 2024

Linn Direktor Manual

30 August 2024

Linn Kivor Tunebox Manual

30 August 2024

Linn Kivor k Manual

26 August 2024

Skrige Manualer

Nyeste Skrige Manualer

FERM FRJ-2000 Manual

14 Oktober 2024

Hamron 601-029 Manual

28 August 2024

Hamron 601-052 Manual

28 August 2024

22 August 2024

22 August 2024

21 August 2024

21 August 2024

21 August 2024

Ultimate Speed IAN 275331 Manual

9 August 2024

Car Xtras SH-RW-2 Manual

6 August 2024