LtAP mini kit-series
LtAP mini LTE series user manual for models:
LtAP mini LTE kit (RB912R-2nD-LTm&R11e-LTE)
LtAP mini LTE kit-US (RB912R-2nD-LTm&R11e-LTE-US)
LtAP mini 4G kit (RB912R-2nD-LTm&R11e-4G)
The LtAP mini LTE kit is a wireless access point with two SIM card slots. The LtAP mini LTE, 4G kit comes with a factory-installed card.
Safety Warnings
Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be familiar with standard practices for preventing
accidents.
Ultimate disposal of this product should be handled according to all national laws and regulations.
All installation methods for mounting an access point on any wall surface is subject to the acceptance of local jurisdiction.
The Installation of the equipment must comply with local and national electrical codes.
This product is intended to be mounted outdoors on a pole but can also be installed indoors. Please read the mounting instructions carefully before
beginning installation. Failure to use the correct hardware and configuration or to follow the correct procedures could result in a hazardous situation for
people and damage to the system.
Use only the power supply and accessories approved by the manufacturer, and which can be found in the original packaging of this product.
Read the installation instructions before connecting the system to the power source.
We cannot guarantee that no accidents or damage will occur due to the improper use of the device. Please use this product with care and operate at your
own risk!
In the case of device failure, please disconnect it from power. The fastest way to do so is by unplugging the power plug from the power outlet.
It is the customer's responsibility to follow local country regulations, including operation within legal frequency channels, output power, cabling
requirements, and Dynamic Frequency Selection (DFS) requirements. All Mikrotik radio devices must be professionally installed.
The equipment is not tested for Outdoor use by UL.
Exposure to Radio Frequency Radiation:This MikroTik equipment complies with the FCC, IC, and European Union radiation exposure limits set forth for an
uncontrolled environment.This MikroTik device should be installed and operated no closer than 20 centimeters from your body, occupational user, or the
general public.
Connecting
Connect your Internet cable to the Ethernet port (this is optional if using LTE as the primary connection);
Install your modem using miniPCIe slot (optional);
Insert the SIM card into the SIM slot;
Connect the GPS antenna (see " ",optional);GPS usage
Choose your powering solution (see " ");Powering
Navigate to the network connections section on your computer and locate the wireless network named " ". Proceed to connect to it;
MikroTik-....
Configuration should be made via a wireless network using a web browser or mobile application. Alternatively, you can use the WinBox
configuration tool ;https://mt.lv/winbox
Open the in your web browser;http://192.168.88.1
User name: , and there is no password
admin
(or, for some models, check user and wireless passwords on the sticker);
Click the "Check for updates" button and update RouterOS to the latest version.The device requires an active internet connection;
For a manual update of the device, visit the products page at to find your product. The required packages are https://mikrotik.com/products
accessible under the "Support&Downloads" menu;
Upload downloaded packages to the menu and reboot the device;"
WinBox Files"
By upgrading your RouterOS software to the latest version, you can ensure optimal performance, stability, and security updates;
In the " menu set up the following: Choose your country, to apply country regulation settings;
QuickSet"
Set up your wireless network password in the left field;
Set up your router password in the bottom field.
