Mosconi Gladen Pro 4/10 Manual

Mosconi Modtager Gladen Pro 4/10

Læs gratis den danske manual til Mosconi Gladen Pro 4/10 (1 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 8 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 4.5 anmeldelser. Har du et spørgsmål om Mosconi Gladen Pro 4/10, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

PRO 4|10

4-channel AB class amplifier [ Rev. 3.0 – 2017/09 ]

------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

CEA-2006-A SPECIFICATIONS

POWER RATING: 120 Watt per channel @ 4 Ohm < 1% THD+N

SN RATIO: >74 dBA / >95 dBA (DDSP) [reference: 1 Watt into 4 Ohm]

MOS SPECIFICATIONS (Tcase = 25 °C / 4 Ohm stereo / 0.2V input level @ 14.4 Volt if not otherwise specified)

TARGET POWERs: 120 Watt per channel @ 4 Ohm Typical application:

160 Watt per channel @ 2 Ohm 106x2 + 386x1 (CH1/2 @ 4 Ohm/ST + CH3/4 @ 4 Ohm/BTL)

320 Watt BTL mode @ 4 Ohm

EFFECTIVE POWERs: 121 Watt (92 Watt @12V6) x 4 52.7 A (η = xx.x %) @ 4 Ohm / ST mode / 1% THD / 1KHz

167 Watt (127 Watt @12V6) x 4 88.0 A (η = xx.x %) @ 2 Ohm / ST mode / 1% THD / 1KHz

334 Watt (254 Watt @12V6) x 2 88.0 A (η = xx.x %) @ 4 Ohm / BTL mode / 1% THD / 1KHz

THD @ 4 Ohm / ST mode:< 0.035 % (1KHz)

THD @ 2 Ohm / ST mode:< 0.04 % (1KHz)

DIM @ 4 Ohm / ST mode:< ---- % (Power rating ref)

DIM @ 2 Ohm / ST mode: < ---- % (Power rating ref)

DC-DC converter typology / Conversion frequency: Unregulated Push-Pull / 50 KHz (± 6 %)

Supply voltage range operation: 10 V ÷ 16 V 11 V ÷ 14.4 V (Absolute maximum) / (Recommended)

Power-on/Power-off Voltage Threshold: 9 V / 7.5 V

Mute delay time: 4 secs.

Secondary voltages (VDD / DRIVE / SERV): ±38.2 V / ±12.5 V / ±13.3 V

Max output offset voltage (each channel): ±15 mV

Standby current: < 1 mA (typical)

Quiescent consumption @ 12V6 / 14V4: 0.52 A / 0.59 A (no idle current regutation)

Idle current regulation (no signal): 0.15 A (each channel)

Quiescent consumption @ 14V4: 0.89 A (with idle current setted)

Thermal protection consumption: 140 mA

Ground decoupling: (RCA Input) / 47R 1 KOhm (battery vs secondary) / (body vs battery)68 Ohm

Bandwidth (-3dB ÷ 1 Watt): < 5 Hz ÷ 135 KHz

Input sensitivity (Power rating ref): 0.35 V ÷ 12 V (5.3 V in DDSP mode)

Input impedance @ 1 KHz (STEREO input): 15 KOhm / 47 Ohm (LL) (HL)

S/N ratio (with AP filter) – Power rating ref: (filter: 10 Hz - 500 KHz )/ (filter: 10 Hz - 22 KHz “A” weighted) 81 dB 94 dB

S/N ratio DDSP (with AP filter) – Power rating ref: (filter: 10 Hz - 500 KHz )/ 89 dB 116 dB (filter: 10 Hz - 22 KHz “A” weighted)

Eq. Input noise (with AP filter): (filter: 10 Hz - 500 KHz )/ (filter: 10 Hz - 22 KHz “A” weighted)31.9 uV 6.44 uV

Channel separation@ 100Hz / 1KHz / 10KHz – 10 Watt ref: 58 dB / 56 dB / 45 dB

Xover functions (selectable filters): CH1/2= HP: 43 ÷ 500Hz(x1) or 430 ÷ 5000Hz(x10) [12 dB/oct – Q: 0.7]

CH3/4= HP: 50 ÷ 200Hz & LP:(430 ÷ 5000Hz) [12 dB/oct – Q: 0.7]

Special features: DDSP - Direct DSP (bypass all the preamplifier circuitry but the differential input interface)

HL/LL - High Level / Low Level selectable input

Controlled via uC – Internally controlled via Atmel Processor

Thermal cutoff Threshold: 95 °C (±5°C)

ProSPEED® Fan Controller Threshold: 50°C (±5°C)

Damping factor @ 100 Hz - 10 Watt ref: 453 / 396 219 / 374 [CH1/2] - [CH3/4]

Damping factor @ 1 KHz - 10 Watt ref: 455 / 398 220 / 399 [CH1/2] - [CH3/4]

Damping factor @ 10 KHz - 10 Watt ref: 199 / 245 94 / 246 [CH1/2] - [CH3/4]

Output impedance @ 1 KHz - 10 Watt ref: 8.8 mOhm / 10.1 mOhm 18.2 mOhm / 10.0 mOhm [CH1/2] - [CH1/2]

Load drive limitations (*): 2 Ohm / 4 Ohm (Stereo / Bridged)

Suggested fuse: 80 A (Internal)

Size (mm): 235 / 205 / 55

Weight (Kg): 2,4

(*) VERY IMPORTANT NOTE - READ CAREFULLY

4 Ohm ST 8 Ohm BTL or – CONTINUOUS SINEWAVE SIGNAL – pure resistive load or speaker load

2 Ohm ST 4 Ohm BTL or – – pure resistive load or speaker loadMUSICAL SIGNAL

Produkt Specifikationer

Mærke:	Mosconi
Kategori:	Modtager
Model:	Gladen Pro 4/10

Har du brug for hjælp?

Hvis du har brug for hjælp til Mosconi Gladen Pro 4/10 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Modtager Mosconi Manualer

Mosconi Pico 8|10 DSP Manual

23 Februar 2025

Mosconi Gladen Pico 1 Manual

6 September 2024

Mosconi Gladen Pico 4 Manual

5 September 2024

Mosconi Gladen Pro 5/30 Manual

5 September 2024

Mosconi Gladen One 80.4 Manual

5 September 2024

Mosconi Gladen One 70.6 Manual

5 September 2024

Mosconi Gladen One 130.2 Manual

5 September 2024

Mosconi Gladen Pro 4/10 Manual

5 September 2024

Mosconi Gladen One 130.4 DSP Manual

5 September 2024

Mosconi Gladen One 130.4 Manual

5 September 2024

Modtager Manualer

Nyeste Modtager Manualer

Atoll AV500 Manual

6 December 2025

Atoll AV100 Manual

5 December 2025

Atoll AM300 Evolution Manual

5 December 2025

AVM Evolution AS 3.3 Manual

5 December 2025

AIYIMA A08 Pro Manual

5 December 2025

MKC MK3506D+ Manual

4 December 2025

AIYIMA T5 Manual

3 December 2025

PRV Audio MDX1800.1 Manual

3 December 2025

Topping MX5 Manual

30 November 2025

Topping Mini 300 Manual

29 November 2025