and ”minutes” show ”oN:Su”. Slowly release buon ❶. Press and hold
buon ❷ unl the display shows ”oF:Su”. The display automacally returns
to operang mode. Your PARK LITE Solar is now ready for installaon on the
inside of your car’s windscreen. Remember that it is only permied to have
one parking disc in the car, and it is always the driver’s responsibility that
the parking disc is set correctly.
INSTALLATION OF PARK LITE SOLAR
1. Find the best place on the inside of the windscreen’s lower right
corner (legal requirement), where the two adhesive pads touch the
glass. Make sure you have access to all the buons on the back of the
clock and that the baery compartment is accessible.
2. Clean the inside of the window where the parking disc is to be ”installed”,
and use the included wet wipe to clean the area thoroughly.
MANUAL SET TING
If you need to set your PARK LITE Solar manually, simply press buon
❷ and the clock will count up in 15-minute increments. Press, hold,
and release the buon when the desired me is displayed. Note that
this funcon is only available when PARK LITE Solar is in parking mode.
BATTERY AND SOLAR CELL
PARK LITE Solar has integrated solar cells. In daylight, PARK LITE Solar
uses integrated solar cells, and in the dark, it uses the backup baery.
When the baery is low, the speaker is acvated and the alarm sounds
(5 x beep tone repeated 3 mes) to indicate that the baery needs to
be replaced within a week. The alarm sounds when the parking mode
is acvated and exited.
3. Make sure the window is at least +15°C, as the adhesive pads do not
work properly at lower temperatures. If necessary, warm up the
window with the car’s blower motor or with a hair dryer (if you’re
careful).
4. Remove the protecve lm from the four adhesive pads and press the
parking disc rmly against the window for about 30 seconds.
You have now installed your PARK LITE Solar and are ready to drive.
Note: PARK LITE Solar must not be le unaached in the car. It must be
xed to the window to work properly.
REMEMBER TO SET THE CLOCK AGAIN
When the baery is replaced, the clock automacally resets.
You can always adjust all me sengs as previously described.
Please note that the LCD display of your PARK LITE Solar device will turn
o shortly aer you remove the baery, so avoid parking your car in
places that require a parking disc if there is no baery in your device.
REPLACING THE BATTERY
1. Buy a new buon cell baery: no. CR 2477 - 3 Volt
2. Carefully remove the baery compartment completely.
3. Remove the old baery.
4. Insert the new baery.
5. Carefully insert the baery compartment again.
SERVICE AND WARRANTY
On our website www.needit.dk you can nd answers to many quesons
about your new PARK LITE Solar. If you have any quesons, please send
them to kundeservice@needit.dk. Needit Denmark ApS oers 2 years of
warranty in accordance with the Danish Sale of Goods Act. In the event
of any defects or deciencies during the warranty period,
PARK LITE Solar may be returned to the retailer. Here, it will be repaired
or replaced with a new one. In case of a complaint, please bring a copy
of your receipt as proof of warranty.
Do not aempt to disassemble the PARK LITE Solar as this will damage
the electronics and void the warranty.
MAINTENANCE
Do not expose PARK LITE Solar to extreme temperatures (below -20
°C or above +75 °C), as this may damage the electronics and/or aect
the response me. If PARK LITE Solar is exposed to severe moisture or
water, it must be wiped immediately with a clean cloth. Only use a cloth
to clean the disc. Do not use cleaning agents.
APPROVALS AND CERTIFICATES
PARK LITE Solar is approved by the Danish Civil Aviaon and
Railway Authority with reference to Legislave Decree No. 327, 2003 of
29/07/2022 on parking discs and bears the Authority’s approval number
FS53 on the front.
CE MARKING
With the CE marking, Needit Denmark ApS declares that our product
meets the general safety requirements of any relevant CE marking
direcves and regulaons. With the CE marking, the manufacturer
guarantees that the product has been manufactured in accordance with
the European Union’s requirements for safety, health, and environment.
Needit Denmark ApS hereby declares that this parking disc is in compli-
ance with (CE) EN 61000-6-3 (Electromagnec Compability – Part 6-3:
Generic Standards – Emission standard for residenal, commercial and
light-industrial environments) and (CE) EN 61000-6-1 (Electromagnec
Compability – Part 6-1: Generic Standards – Immunity for residenal,
commercial and light-industrial environments).
WEEE
Electrical and electronic equipment (EEE) and materials may be hazardous
and harmful to human health and the environment and must be disposed
of properly. PARK LITE Solar must not be disposed of as normal house-
hold waste and must instead be disposed of separately. The baery may
be returned to the baery retailers, and the PARK LITE Solar itself may be
returned to the local recycling staon or to the parking disc retailer.
SPECIFICATIONS AND RIGHTS
Size in cm: 10.4 x 5.5 x 2.0
Baery specicaons: Buon cell baery no. CR 2477 - 3 Volt
Baery life: Approx. 5 years
Clock accuracy (avg.): ± 2 min./2 years
Response me, parking mode: Approx. 20 sec.
Response me, non-parking mode: Approx. 20 sec.
PARK LITE Solar is patent pending.
All rights to the product PARK LITE Solar belong to:
Needit ApS • Hammerholmen 18 • 2650 Hvidovre
Telefon: +45 70 221 535 • E-post: kundeservice@needit.dk
Neside: www.needit.dk
The contents of this user manual are subject to change without noce.
IMPORTANT. It is the driver’s responsibility to ensure that the clock is
adjusted correctly. Parking ckets are not refunded by Needit Denmark
ApS, nor are we responsible or liable for any installaon errors.
Congratulaons on your new PARK LITE Solar with an integrated speaker.
With PARK LITE Solar in the car, you don’t have to remember seng the
parking disc and hence avoid hey parking nes.
The electronics in PARK LITE Solar register the car’s movements and
automacally set the parking disk at the correct parking me and only
end the parking mode when the car starts moving again.
Before using PARK LITE Solar, we recommend that you read the enre
manual thoroughly. To ensure correct installaon of PARK LITE Solar,
the instrucons below should be followed:
2
3
Button ❶
Button ❷
Battery
English User Guide
PARK LITE SOLAR
Developed by Needit Denmark
Designed by John Sebastian
BEFORE INSTALLATION
A: Acvate the baery
Remove the plasc strip carefully and press the baery back into place if
it comes loose. If the baery falls out, insert it again with the + upwards
(same side as the one wrien in the baery compartment). If the baery is
placed correctly, the ”hours” ash on the display (it may take some me for
the display to ash).
B: Set the digital clock
1. (The clock in PARK LITE Solar automacally adjusts to both summer and
winter me, but the funcon may be deacvated manually if necessary,
see secon )C
2. Acvate seng mode by pressing and holding buon ❶ unl “hours”
start ashing. When ”mer” is ashing, press buon ❷ repeatedly unl
the mer is adjusted correctly.
When you have adjusted the above informaon, no numbers in the dis-
play should ash. Note, however, that the two dots (:) between the hours
and minutes ash connuously. If one of the numbers is ashing, press
buon ❶ repeatedly unl none of the numbers are ashing. If you nd
that you have adjusted PARK LITE Solar incorrectly, you can always start
over by pressing and holding buon ❶ unl the ”hours” digit ashes.
We recommend that you check the clock sengs regularly, especially
when switching between summer and winter me.
C: Acvaon/deacvaon of summer me/winter me
The digital clock is by default set to switch automacally between summer
and winter me. However, if you are in a country where there are no shiing
seasons, you may disable the feature by following the steps below:
Acvate the seng mode by pressing both buon ❶ and ❷ unl ”hours”
4
5
6
10 13
11 14
12 15
8
7
9
3. Press buon ❶ once, aer which the ”minutes” will ash on the display.
Adjust the minutes with buon ❷.
4. Set the year, month, and date as above (in that order).
Choose how the parking start me should be handled:
2:PE The parking me is set to the nearest half hour. If you park at 13:07,
the display will show 13:30. This is a requirement, e.g., in Finland, Sweden,
Germany, and Switzerland. The parking me is set to the exact hour 0:PE
and minute. If you park at 13:07, the display will show 13:07. This is a
requirement, e.g., in Estonia and Norway. The parking me is set to the 1:PE
nearest quarter hour. If you park at 13:07, the display will show 13:15. This
is a requirement, e.g., in Denmark and Austria.
5. When all sengs are implemented, only (:) will ash.
