Developed by Needit Denmark
Designed by John Sebastian
Instructions for use
Congratulations on your new ParkOne X
www.parkonex.dk
Before installaon
Turn the parking disc around with its backside upwards. Insert one or more ngernails
into the slot at the top of the round compartment lid and pull it o.
A: Acvate the baery
Remove the plasc strip carefully and press the baery back into place if it comes
loose. If the baery falls out, insert it again with the + upwards (same side as the one
wrien in the baery compartment). If the baery is placed correctly, the ”hours”
ashes on the display. (It may take some me for the number on the display to ash).
B: Set the digital clock
(The clock in adjusts to both summer and winter me automacally, but the ParkOne X
funcon may be deacvated manually if necessary, see C:)
1. When is ashing, press buon ❷ repeatedly unl the hour is adjusted ”hours”
correctly.
2. Press buon ❶ once and ”minutes” ashes on the display. Adjust the minutes
with buon ❷.
3. Set year, month, and date as above (in that order).
4. When you have adjusted the above informaon, no numbers in the display should
ash.
Note, however, that the two dots (:) between the me ash connuously. If one of the
numbers is ashing, press buon ❶ repeatedly unl none of the numbers are ashing.
If you nd that you have adjusted ParkOne X incorrectly, you can always start over by
pressing and holding buon ❶ unl the ”hours” digit ashes.
We recommend that you check the clock sengs regularly, especially when switching
between summer and winter me.
C: Acvang/deacvang daylight saving me
The digital clock is by default set to switch between summer and winter me.
However, if you are in a country where there is no switching, you may disable the
feature by following the steps below:
1. Acvate the preference mode by pressing both buon ❶ and ❷ unl ”hours”
and ”minutes” ”oN:Su” show .
2. Slowly release buon ❶.
3. Press and hold buon ❷ unl the display shows ”oF:Su”.
4. The display automacally returns to operang mode.
Your ParkOne X is now ready for installaon on the inside of your car’s windscreen.
Installaon of ParkOne X
Find the best place on the inside of the lower right corner of the windscreen (legal
requirement) where all four adhesive pads touch the glass. Make sure you have access
to all the buons on the back of the clock and that the baery compartment is
accessible.
1. Clean the inside of the window where the parking disc is to be installed with a
damp cloth. Wipe the window with a dry cloth or paper towel, and use the
included cleaning cloth to clean the area thoroughly. (Only the included wipe may
be used - no other cleaning agents).
2. Make sure the window is at least +15°C, as the adhesive pads do not work
pro perly at lower temperatures. If necessary, warm up the window with the car’s
blower motor or with a hair dryer (if you’re careful).
When the baery is replaced, the clock automacally resets. You may always adjust all
me sengs as previously described. Be aware that the LCD display in your ParkOne X
will turn o shortly aer the baery is removed, so you should avoid leaving the car while
there’s no baery in the clock.
Replacing the baery
1. Buy a new buon cell baery: no. CR 2477 - 3 Volt.
2. Pull o the round compartment lid on the backside.
3. Remove the baery.
4. Insert new baery.
5. Put the compartment lid back on.
REMEMBER TO SET THE CLOCK AGAIN.
Service and warranty
On www.needit.dk, you can nd answers to many quesons about your new
ParkOne X. If you have any quesons, please email us at kundeservice@needit.dk.
Needit Denmark ApS oers 2 years of warranty in accordance with the Danish Purchase
Act. In the event of any defects or deciencies during the warranty period, ParkOne X
may be returned to the retailer. Here, it will be repaired or replaced with a new one. In
case of a complaint, please bring a copy of your receipt as proof of warranty.
Approvals and cercates
ParkOne X is approved by the Danish Civil Aviaon and Railway Authority with
reference to Statutory Order No. 327 of 29/07/2022 on parking discs and bears the
Agency’s approval number FS52 on the front.
Maintenance
Do not expose ParkOne X to extreme temperatures (below -20°C or above +75°C), as
this may damage the electronics and/or aect response me.
If is exposed to strong moisture or water, it must be wiped immediately ParkOne X
with a clean cloth. Use only a cloth to clean the disc. Do not use cleaning agents.
CE labelling
With the CE marking, NeedIt Denmark ApS declares that our product meets the gene-
ral safety requirements of any relevant CE marking direcves and regulaons. With the
CE marking, the manufacturer guarantees that the product has been manufactured
in accordance with the European Union requirements for safety, health, and environ-
ment. Needit Denmark ApS hereby declares that this parking disc is in compliance
with (CE) EN 61000-6-3 (Electromagnec Compability – Part 6-3: Generic Standards
– Emission standard for residenal, commercial and light-industrial environments)
and (CE) EN 61000-6-1 (Electromagnec Compability – Part 6-1: Generic Standards –
Immunity for residenal, commercial and light-industrial environments).
WEEE
Electrical and electronic equipment (EEE) and materials may be hazardous and harmful
to human health and the environment and must be disposed of properly. ParkOne X
must not be disposed of with normal household waste but must be collected separately.
The baery may be returned to the baery retailers, and the ParkOne X itself may be
returned to the local recycling centre or to the parking disc retailer.
Specicaons and rights
Size in cm: 10 x 10 x 1.6
Baery specicaons: Buon cell baery: no. CR 2477 - 3 Volt
Baery life: Up to 5 years
Clock accuracy (avg.): ± 2 min./2 years
Response me - parking mode: Approx. 20 sec.
Response me - non-parking mode: Approx. 20 sec.
ParkOne X is patent pending.
All rights to the product ParkOne X belong to:
Needit ApS • Hammerholmen 18 • 2650 Hvidovre
Telephone +45 70 221 535 • kundeservice@needit.dk
www.parkonex.dk
The contents of this user manual are subject to change without noce.
Important
It is the driver’s responsibility to ensure that the clock is adjusted correctly. Parking
ckets are not refunded by Needit Denmark ApS, nor are they responsible or liable for
any installaon errors.
3. Remove the protecve lm from the four adhesive pads and press the parking
disc rmly against the window for about 30 seconds. Avoid pressing in the middle
of the backside. Aer this, you must check whether all four adhesive pads are
scking properly to the window from the outside of the car.
4. You have now installed your ParkOne X and are ready to drive.
Note:
ParkOne X must not be le unaached in the car but must be xed to the window to
work properly.
How ParkOne X works
When you park your car, automacally sets the clock forward to the next ParkOne X
quarter aer the arrival me (e.g., if you arrive at 10:07, will set the clock ParkOne X
forward to 10:15).
Manual seng
Your can also be set manually as required by law. Statutory Order no. 327 ParkOne X
of 9/04/2003 (§3 paragraph 3): ”If a period without a me limit occurs during the
parking of a vehicle, the pointer shall be set, latest at the end of the me period,
at the me from which a me limit applies again.” If you need to set your ParkOne X
manually, simply press buon ❷ and the clock will count up in 15-minute increments.
Press, hold and release the buon when the desired me is displayed. Note that this
funcon is only available when ParkOne X is in parking mode.
Baery
When the baery is low, the speaker ❸ is acvated and the alarm sounds (5 x beep
tone repeated 3 mes) to indicate that the baery needs to be replaced within a
week. The alarm sounds when the parking mode is acvated and exited.
❸
❶
❷❷
PARKONE X