Noise Engineering Cursus Iteritas Percido Manual

Noise Engineering Ikke kategoriseret Cursus Iteritas Percido

Læs gratis den danske manual til Noise Engineering Cursus Iteritas Percido (5 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 7 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 4 anmeldelser. Har du et spørgsmål om Noise Engineering Cursus Iteritas Percido, eller vil du spørge andre brugere om produktet?

Side 1/5
Overview
Cursus Iteritas Percido is the second module in the Percido line of powerful synth voices. Similar
to its predecessor, the Loquelic Iteritas Percido, CIP takes the sounds of the original Cursus
Iteritas and adds the musical envelope from LIP with attenuverter-controlled routing to each knob.
With the addition of the performance-oriented Master Blaster and CV outputs, CIP is a
powerhouse of incredibly versatile synthesis.
1
Noise Engineering
Cursus Iteritas Percido
One Knob to Rule Them All
Type
Synth voice
Size
24HP Eurorack
Depth
1 Inch
Power
2x8 Eurorack
+12 mA
105/60 mA
-12 mA
60 mA
+5 mA
0/75
Etymology
Iteritas -- from Latin itero 'repeat' with suffix -tas 'state of being'.
Percido -- from Latin 'Danger'
“Dangerous Repetitiousness Series”
Cursus-- from latin Cursus 'series’
“Repetitiousness”
All CV inputs respond to 0-5v, except pitch, which responds to 0-8v. The Env and MB Out are 0-
5v. Sync responds to a rising edge around 2v, and Trig responds to a rising edge around 3v.
Input & output voltages
2
Interface
Mode: Sets the behavior of the envelope.
Algo: Selects which orthogonal function set is used to produce the wavetable.
ŸDaub: Daubechies – uses wavelets
ŸFree: Free-running mode is the original Cursus Iteritas. The oscillator will continue to run. A
trigger in will still reset the envelope on the trigger rising edge, but will not affect the volume.
Pitch: Sets the pitch. Turn to adjust fine tuning, press and turn to adjust coarse tuning. Encoder
sums with the pitch CV input.
Ÿ Trig: In Trigger mode, CIP expects a trigger input to start the envelope. CIP triggers on the
rising edge and expects a voltage of about 3v.
ŸFour: Fourier – uses sine waves
ŸWalsh: uses the Walsh Transforms
Hit: Momentary button to manually trigger CIP. When depressed, CIP behaves like it received a
rising edge on a trigger.
Time: Controls the length of the envelope.
ŸLoop: In loop mode, the envelope will continually regenerate. A trigger in will hard reset it on
the rising edge; without a trigger in, it will regenerate based on the parameters set on CIP.
AT/DC: Controls the attack and decay of the envelope. All the way CCW, the envelope is all
decay; all the way CW, attack dominates. Turning the knob transitions between these two
extremes gradually.
Shape: controls the shape of the curve: CCW gives an exponential curve, while CW gives a
logarithmic curve. In the center, the shape is linear.


Produkt Specifikationer

Mærke: Noise Engineering
Kategori: Ikke kategoriseret
Model: Cursus Iteritas Percido

Har du brug for hjælp?

Hvis du har brug for hjælp til Noise Engineering Cursus Iteritas Percido stil et spørgsmål nedenfor, og andre brugere vil svare dig