1
Backup Driver Wiring
Please choose the appropriate dimming according to your needs. You can also choose not to use this function.
NOTE: The product can’t be connected to a dimming device when it is equipped with Motion Sensor.
2. Flexible cord for connection
WARNING
• To reduce the risk of personal injury or property damage
from re, electric shock, falling parts, cuts/abrasions, and
other hazards read all warnings and instructions included
with and on the xture and all xture labels.
• Commercial installation, service and maintenance of
luminaries should be performed by a qualied licensed
electrician. If you are unsure about the installation or
maintenance of the luminaries, consult a qualied licensed
electrician and check your local electrical code.
• Turn off electrical power at fuse or circuit breaker before wiring xture to the power supply.
• Turn off the power when you perform any maintenance.
• All connections should be capped with UL approved wire connectors.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Do not install in a hazardous atmosphere, except where the ambient temperature does not exceed the rated operating
temperature of the xture.
• Use min. 90°C supply.
• Damp location rated.
ADJUSTABLE LED HIGH BAY
Models: 65-641R1, 65-642R1, 65-643R1, 65-644R1,
65-645R1, 65-646R1, 65-647R1, 65-648R1
Satco Products, Inc.
Brentwood, NY 11717
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing xuture. Retain for future reference.
© Copyright 2022 Satco Products, Inc. 3/22 v1.2
1. Conduit connection
BACKUP WIRING DIAGRAM
Figure 1
EXTRA ACCESSORY OPTIONS & ASSEMBLY
Wire Guard
STEP 1: Snap the wire guards into the plug of the light-emitting
modules and tighten them with screws (Figure 1).
WIRING DIAGRAMS & INSTRUCTIONS
Three dimming functions are available:
1. Constant current can be achieved by 0-10VDC dimming
2. PWM signal dimming
3. Variation of resistance unit dimming
Two wiring methods:
Wiring Instruction
L : Black
N : White
:
Green/Yellow
DIM+
DIM–
NOTE: For the wire color of DIM+ and DIM–,
please check the light label.
