OSD Audio NERO MAX8 Manual

OSD Audio Modtager NERO MAX8

Læs gratis den danske manual til OSD Audio NERO MAX8 (11 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 36 personer og har en gennemsnitlig bedømmelse på 3.6 stjerner ud af 18.5 anmeldelser. Har du et spørgsmål om OSD Audio NERO MAX8, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/11

NERO

MULTIROOM PRE-AMP & AMPLIFIERS

MAX/CONTROL

MAX 12 - Six Source Six Zone Multi-Room Amp

MAX 8 - Six Source Four Zone Multi-Room Amp

CONTROL 12 Six Source Six Zone Multi-Room Pre-Amp

All with iOS / Android App Control and Integrated App

Control with Optional Keypad Control

OWNER’S

MANUAL

MAX8

POWER

ZONE ZONE ZONE ZONE ZONE ZONE 1 2 3 4 5 6

NERO CONTROL12

M U LT I - Z O N E

C O N T R O L L E R

NERO MAX-CNTRL man.indd 1 11/14/22 11:37 AM

IMPORTANT SAFETY PRECAUTIONS

This manual contains important instructions for the safe operation of the unit. Read and follow the safety

instructions and all other instructions. Keep the manual for future reference. Make sure that it is available to

all those using the device. If you sell the unit, please make sure that the buyer also receives this manual.

• Use only an approved power cable and plug or distribution board to connect your amplier to a power outlet. Do not

use an extension cable.

• Never touch the mains plug if your hands are wet.

• Do not attempt to open the equipment. Refer servicing and repair to qualied service personnel. Touching live

components inside the case can result in a fatal electrical shock!

• Read the Owner’s Manual and Safety Precautions before operating the equipment.

• Keep this Manual in a safe place so that you can refer to it later.

• Please heed all warnings on the equipment itself and in the Owner’s Manual.

• Please follow the instructions contained in your Owner’s manual and never use this equipment for any purpose

other than is explained in this Owner’s Manual.

• Only connect this equipment to a power source of the type described in the Owner’s Manual and specied for this

equipment.

• Make sure that there is adequate ventilation around the equipment to allow proper cooling. Keep the equipment

away from direct sunlight. Avoid installing the unit close to sources of heat or in spaces such as bookshelves or

cupboards where heat radiation may be obstructed. Avoid excessive temperatures in the room, as these could

ultimately damage sensitive components and reduce the service life of your player.

• Never use the unit in damp rooms, at temperatures of below 15°C, or in the open air. When bringing your amplier

in from the cold, allow it time to achieve room temperature before plugging it in.

• Always switch the unit off before removing or inserting interconnects. Doing this with the amplier switched on can

damage not only the amplier itself but also equipment connected to it.

• If you ever spill water or any other liquid onto the equipment: Do not touch the case! Remove the plug from the wall

outlet and contact your dealer or our service department.

• Never remove the earth connection from the plug. It is there to ensure your safety.

• Arrange the power cable so that no one can accidentally stand on it. Avoid locating it under objects that might put

pressure on the cable. Pay particular attention to areas where the cable exits from plugs, AC outlets and from the

unit itself.

• Never operate the unit without being present. Disconnect the plug from the wall outlet and remove all aerial

connections (including cable aerials) when: you clean the unit, you do not expect to use the unit for long periods of

time, during an electrical storm.

• If you have an external antenna or cable antenna connected to your hi- system, we recommend that you use a

signal isolating lter to avoid interference or damage during thunderstorms.

• Problems: If you lose the sound while the amplier is operating, or if you notice smoke or burning, switch the unit

off immediately and contact your dealer or our service department.

• Only replace defective fuses after you have traced and removed the cause of the fault and then only with a fuse of

the same rating. Remove the mains plug before changing fuses. Use an insulated screwdriver to remove and replace

the fuse.

NERO MAX-CNTRL man.indd 2-3

Produkt Specifikationer

Mærke:	OSD Audio
Kategori:	Modtager
Model:	NERO MAX8

Har du brug for hjælp?

Hvis du har brug for hjælp til OSD Audio NERO MAX8 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Modtager OSD Audio Manualer

OSD Audio XMP500DSP Manual

29 August 2025

OSD Audio Black SAM500 Manual

22 Juli 2025

OSD Audio Nero HTD6150 Manual

20 Juli 2025

OSD Audio SMP200 Manual

20 Juli 2025

OSD Audio Nero HTX6150 Manual

17 Juli 2025

OSD Audio PAX-50 Manual

19 Juni 2025

OSD Audio Nero HTX-8150 Manual

21 Februar 2025

OSD Audio Nero HTX8150 Manual

14 Januar 2025

OSD Audio Nero HTX4150 Manual

14 Januar 2025

OSD Audio NERO MAX8 Manual

1 Januar 2025

Modtager Manualer

Nyeste Modtager Manualer

Hegel H190v Manual

18 September 2025

Kemo M237 Manual

18 September 2025

Ashly nX1504 Manual

18 September 2025

Ashly FX-500.4 Manual

17 September 2025

AudioControl Architect Model P800 Manual

17 September 2025

Atlona AT-HDR-CAT-2 Manual

17 September 2025

FSR DV-HDA4K-14AUD Manual

17 September 2025

Topping DX5 II Manual

16 September 2025

InLine 99204I Manual

16 September 2025

Cambridge MXW70 Manual

16 September 2025