OSD Audio XMP100 Manual

OSD Audio Modtager XMP100

Læs gratis den danske manual til OSD Audio XMP100 (4 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 25 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 13 anmeldelser. Har du et spørgsmål om OSD Audio XMP100, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

OWNER’S MANUAL

XMP100

OsdAudio ®

775 Columbia St.,

Brea. CA92821

www.osdaudio.com XMP100 Owner’s Manual 51115

Congratulations on your purchase of the OsdAudio XMP100. ®

Please take a few moments to read this entire manual, and be sure to

retain this document for future reference. Please read and observe all

safety instructions detailed on page 2.

NOTE: If any part of this product is damaged or missing, please call your

dea diler or OsdAudio ® rectly at 888 779 4968.

Please read your ranty and retain your receipt and nal cartonwar origi

for possible future use.

For more information about OsdAudio ® electronics, speakers and

accessories please visit www.osdaudio.com

XMP100

Digital Stereo Power Amplifier

FEATURES:

• MAIN / INTERRUPT priority input switching

• Class D Amplification (89% Efficient)

• MAIN auxiliary output

• Speaker A/B switching

• Front panel Balance and Volume controls

• Signal sensing “Power On” and Trigger mode

SPECIFICATIONS

Stereo (8 ohm): 50W per nel, <1% THD+Nchan

Stereo (4 ohm): 75W per nel, <1% THD+Nchan

Bridged Mono (8 ohm): 160W, 1kHz, <1% THD+N

Frequency Response: 10Hz ~ 30kHz, -2dB/ +1dB

Signal to Noise Ratio: 100dB below 50W output into 8 ohms

w/20kHz Lowpass filter

Channel Separation: 65dB @ 1kHz, referred to 50W output

into 8 ohms

Input Sensitivity: 700mV input for rated 50W output

into 8 ohms

AC Power Consumption: 200W maximum

Net Weight: 4.7lbs / 2.2kgs

Gross Weight: 6.8lbs / 3kgs

2.15”

(55mm)

16.9” (430mm)

7.65”

(194mm)

• Rear mounted treble and bass controls

Bass/Treble Control: +/- 12dB @ 100Hz and 10kHz

DI GI TAL P OW ER

A M P L I F I E R

XMP100

D I GI TA L P O W E R

A M I E RP L I F

XMP100

OWNER’S MANUAL

APPLICA TIONS

STEREO SETUP

In this ration, the conﬁgu mode switch is set to “Stereo”. nnect the ne oCo li ut jacks

from a stereo pre-ampliﬁer or source to the MAIN input jacks of your XMP100.

Next c ne yo r speakers to the t als marked “Speaker A” observinon ct uermin g

prop pola paner ri Sele the “A” speakers sin the front ty. ct u g el zone selection

b ttons. nect a second (opt l) ir of speakers to the te als marked uCon iona pa rmin

“S aker B” f yo are c ectin 4 s akers to the M they m st be pe . I uonn gpe X P 010 u

8 ohm speakers only. Press A and B together to use both zones.

SETUP FOR MU L TIPLE SOURCE

In the m lt le s rce set p, a dist b ted io system is co ected to the uip ou u ri u aud nn

as a local zone li er via the MAIN p ts. lly the dist bamp ﬁin uNorma ri uted

aud audio system will be the io so rce for the . The disturib ted u audio is

then passed on to be sed by dit al zones or s b zones in the dist b ted uad ion uri u

system via the MAIN outputs.

Note: Main Out only duplicates what source is connected to the Main Input, ideal

for adding additional Amplifier or connect to Power Subwoofer.

The io o tp t of a local so rce, s ch as an M 3 layer, CD, television, aud u u u u P P

comp ter, etc., is cuonnected to the XM via the INTERRU TIN G pP 010 P in uts, and

whenever the local so rce is acutive i s al ll take rity over the ts ign wi prio

dist b ted a dio al ent at MAIN pri u u sign pres in ut . However, the distributed io saud ignal

will still be sent at the MAIN p t. In this mst ce the io o tp t of the pre in u circu an aud u u

local source will be rd via the M . Once the local s rce is t ed hea X P 010 ou urn

off or m ted, the Mu X P 010 ll awi utomatically switch back to the distributed dio au

system as an audio s rce, ass n the local s rce ns active. T re ou umi g ou remai in he

is a ay of p to 6 seconds del u when switching from INTERRUPTING input back

(From Pre-amp or Receiver Line Out)

(From Pre-amp Line Out)

(From Local Source Line Out) (Out to Additional Zones)

Limited Warranty

OsdAudio ® warrants its ampliﬁer p r oducts against defects in materials

and workmanship for a limited period of time. For a period of two years f r om

date of original pu r chase, we will r epair or r eplace the p r oduct, at our option,

without cha r ge for parts and labo r . Customer must pay all parts and labor

cha r ges after the limited warranty period expi r es. The limited warranty period

for factory r efurbished p r oducts expi r es after ninety (90) days f r om date of

original pu r chase.

This limited warranty applies only to pu r chases f r om authorized OsdAudio ®

elect r onics r etailers. This limited warranty is extended only to the original

pu r chaser and is valid only to consumers in the United States.

Consumers a r e r equi r ed to p r ovide a copy of the original sales invoice f r om

an authorized OsdAudio ® dealer when making a claim against this limited

warrant y . This limited warranty only covers failu r es due to defects in materials

or workmanship that occur during normal use. It does not cover failu r es

r esulting f r om accident, misuse, abuse, neglect, mishandling, misapplication,

alteration, faulty installation, modiﬁcation, service by anyone other than

AudioSou r ce®, or damage that is attributable to Acts of God. It does not

cover costs of transportation to OsdAudio ® or damage in transit. The

customer should r etu r n his defective p r oduct, f r eight p r epaid and insu r ed, to

OsdAudio ® only after r eceiving a Retu r n Authorization.

This warranty will become void if the serial number identiﬁcation has been

wholly or partially r emoved, alte r ed or erased. Repair or r eplacement under

the terms of this warranty does not extend the terms of this warrant y . Should

a p r oduct p r ove to be defective in workmanship or material, the consumer ’ s

sole r emedies will be r epair or r eplacement as p r ovided under the terms

of this warrant y . Under no ci r cumstances shall OsdAudio ® be liable for

loss or damage, di r ect, consequential or incidental, arising out of the use of

or inability to use the p r oduct. The r e a r e no exp r ess warranties other than

described above.

to MAIN inputs.

775 Columbia St.,Brea. CA92821

MX P 010

Produkt Specifikationer

Mærke:	OSD Audio
Kategori:	Modtager
Model:	XMP100

Har du brug for hjælp?

Hvis du har brug for hjælp til OSD Audio XMP100 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Modtager OSD Audio Manualer

OSD Audio Black SAM500 Manual

22 Juli 2025

OSD Audio Nero HTD6150 Manual

20 Juli 2025

OSD Audio SMP200 Manual

20 Juli 2025

OSD Audio Nero HTX6150 Manual

17 Juli 2025

OSD Audio PAX-50 Manual

19 Juni 2025

OSD Audio Nero HTX-8150 Manual

21 Februar 2025

OSD Audio Nero HTX8150 Manual

14 Januar 2025

OSD Audio Nero HTX4150 Manual

14 Januar 2025

OSD Audio NERO MAX8 Manual

1 Januar 2025

OSD Audio HTD4150 Manual

27 December 2024

Modtager Manualer

Nyeste Modtager Manualer

Albrecht HAE75 Manual

1 August 2025

CYP AU-A220 Manual

30 Juli 2025

Sirus I-Amp 8.150T Manual

30 Juli 2025

AER Colourizer 2 Manual

30 Juli 2025

Sirus I-Amp 1.300T Manual

30 Juli 2025

PAC AP4-FD32 Manual

30 Juli 2025

CYP PUV-1540S-RX Manual

30 Juli 2025

ART USB Dual Pre Manual

29 Juli 2025

SSL Pure Drive Quad Manual

29 Juli 2025

SSL Pure Drive Octo Manual

29 Juli 2025