Panduit DCT Manual


Læs gratis den danske manual til Panduit DCT (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 7 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 4 anmeldelser. Har du et spørgsmål om Panduit DCT, eller vil du spørge andre brugere om produktet?

Side 1/1
For Cutting Panduct
Plastic Wiring Duct
or Cover
and Heat Shrink Tubing
Page: 1 of 1
DCT
WARNING:
SAFETY GLASSES MUST BE
WORN AT ALL TIMES WHEN
USE CARE WHEN HANDLING TOOL;
BLADE IS SHARP!
CAUTION:
This precision tool has been engineered and designed for use with Panduct Plastic Wiring
Duct or Cover, and Heat Shrink Tubing. It is not intended for use on any other products or
materials.
OPERATION
1. Determine (mark) the cut location as required.
2. Release the handle latch at the end of the handles. The handle spring allows the handles to be
normally open.
3. Position the cutting blade at the marked location and squeeze the handles together until the material is cut
through, and the blade bottoms out in the blade insert. If the cut is not long enough, also cut from the
opposite side, across from the first cut.
4. Latch the tool handles in the locked position when the tool is not being used and during transport.
REPLACEMENT PARTS
DCT-BLD Blade Replacement Kit (includes replacement blade and insert)
DCT-RI Replacement Insert (includes insert only)
Blade Replacement: Unhook spring from hook on blade. Using a wide blade standard screwdriver and 10mm
hex wrench, remove nut and screw. Slide blade upward, out of tool, and replace with new
blade. Fasten using existing screw and nut. Remember to hook spring onto hook on
blade.
Insert Replacement: Carefully pry out existing insert. Apply a small amount of Loctite Black Max (or
equivalent) to bottom of replacement insert. Place insert into lower jaw of tool
with the slotted side up.
DUCT CUTTING TOOL
OPERATING INSTRUCTIONS
Technical Support :
1-800-777-3300
Email:
techsupport@panduit.com
PA22193A01
REV.: 07 6-2018
www.panduit.com
© Panduit Corp. 2018
DCT
CUTTING TOOL


Produkt Specifikationer

Mærke: Panduit
Kategori: Ikke kategoriseret
Model: DCT
Produktfarve: Grøn
Produkttype: Rørsaks
Certificering: RoHS
Materiale, kniv: Rustfrit stål

Har du brug for hjælp?

Hvis du har brug for hjælp til Panduit DCT stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Panduit Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer